AXESS AXDI-CL2 Manual de Usario

Lee a continuación 📖 el manual en español para AXESS AXDI-CL2 (4 páginas) en la categoría No categorizado. Esta guía fue útil para 5 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/4
AXDI-CL2
I N S T A L L A T I O N I N S T R U C T I O N S
AxxessInterfaces.com © COPYRIGHT 2020 METRA ELECTRONICS CORPORATION REV. 1/21/20 INSTAXDI-CL2
Product Info
INTERFACE FEATURES
INTERFACE COMPONENTS
TOOLS & INSTALLATION ACCESSORIES REQUIRED
• Crimping tool and connectors, or solder gun,
solder, and heat shrink • Tape • Wire cutter
• Zip ties
TABLE OF CONTENTS
Connections .........................................................2-3
Installation .............................................................3
Programming .........................................................3
GM Data Interface 2000-2013
APPLICATIONS
See inside front cover
Provides accessory power (12-volt 10-amp)
Retains R.A.P. (retained accessory power)
Provides illumination, parking brake, reverse, and speed sense outputs
Retains chimes through an onboard speaker
Pre-wired AXSWC harness (AXSWC sold separately)
Designed for non-amplified models, analog amplified models,
or when bypassing a factory amplifier
Retains balance and fade
Micro-B USB updatable
• AXDI-CL2 interface
• AXDI-CL2 harness
2
APPLICATIONS CONNECTIONS
From the AXDI-CL2 harness to the aftermarket radio, connect the:
wire to the ground wire.Black
Yellow wire to the battery wire.
wire to the accessory wire.Red
Blue/White wire to the amp turn-on wire.
Orange wire to the illumination wire (if applicable).
There are (2) illumination wires. If the wire on the 24-pin harness is populated Note: Orange
on the factory side, use that wire instead.
Tape off and disregard the Orange/White wire, it will not be used in this application.
wire to the front right positive speaker output.Gray
Gray/Black wire to the front right negative speaker output.
White wire to the front left positive speaker output.
White/Black wire to the front left negative speaker output.
Green wire to the rear left positive speaker output.
Green/Black wire to the rear left negative speaker output.
wire to the rear right positive speaker output.Purple
wire to the rear right negative speaker output.Purple/Black
The following (3) wires are only for multimedia/navigation radios that require these wires.
wire to the VSS/speed sense wire.Blue/Pink
Green/Purple wire to the reverse wire.
Light Green wire to the parking brake wire.
BUICK
Century 2004-2005
LaCrosse 2005-2009
Rainier * 2004-2007
Regal 2004
Rendezvous 2002-2007
Terraza 2005-2007
CADILLAC
Escalade, Escalade ESV & EXT †
2003-2006
CHEVROLET
Avalanche ** 2003-2006
Cavalier 2000-2005
Colorado 2004-2012
Corvette 2005-2013
Express 2003-2007
Impala 2000-2005
Kodiak C4500-C8500 2003-2009
Malibu 2001-2003
Malibu Classic 2004-2005
Monte Carlo 2000-2005
CHEVROLET (CONT)
Silverado ** 2003-2006
Silverado Classic ** 2007
SSR * 2003-2006
Suburban ** 2003-2006
Tahoe ** 2003-2006
Trailblazer * 2002-2006
Trailblazer 2007-2009
Uplander 2005-2008
GMC
Canyon 2004-2012
Envoy * 2002-2006
Envoy 2007-2009
Savana 2003-2007
Sierra ** 2003-2006
Sierra Classic ** 2007
TopKick C4500-C8500 2005-2009
Yukon / Yukon XL ** 2003-2006
HUMMER
H2 † 2003-2007
H3/H3t 2006-2010
ISUZU
Ascender 2003-2008
H-Series 2003-2008
I-Series 2006-2008
OLDSMOBILE
Alero 2001-2004
Bravada 2002-2004
Intrigue 2002
PONTIAC
Aztec 2001-2005
Grand Am 2001-2005
Grand Prix 2004-2008
Montana SV6 2005-2006
Sunfire 2000-2005
SAAB
9-7x 2005-2009
SATURN
Relay 2005-2007
* These vehicles have a digital amplifier option. Please reference the “Service Parts Identification” sticker
located in the glove box for the RPO code UQA. If UQA is present, then the vehicle is equipped with a digital
amplifier. Either use the AXDIS-CL2 interface, or bypass the amplier.
** These vehicles have a digital amplifier option. Please reference the “Service Parts Identification” sticker
located in the glove box for the RPO code Y91. If Y91 is present, then the vehicle is equipped with a digital
amplifier. Either use the AXDIS-CL2 interface, or bypass the amplier.
These vehicles are standard for a digital amplifier. Either use the AXDIS-CL2 interface, or bypass the amp
.
3
REV. 1/21/2020 INSTAXDI-CL2
CONNECTIONS (CONT) INSTALLATION
With the key in the off position:
Connect the into the 1. AXDI-CL2 harness AXDI-CL2 interface, and then to the wiring harness in
the vehicle.
Note: If installing an AXSWC, connect it after you program and test the AXDI-CL2, with the
key in the off position.
Attention! If the interface loses power for any reason, the following steps will need to be
performed again.
Cycle the engine on.1.
If the radio doesn’t come on within 60 seconds, turn the key to the off position, Note:
disconnect the interface, check all connections, reconnect the interface, and then try again.
Cycle the ignition off, then back on.2.
Test all functions of the installation for proper installation.3.
12-pin pre-wired AXSWC harness:
This harness is to be used along with the (sold separately) to retain steering wheel AXSWC
audio controls. If the is not being used, disregard this harness. If it will be used, refer AXSWC
to the instructions for radio connections and programming. Disregard the harness AXSWC
that comes with the .AXSWC
The following wire(s) must be cut before programming the AXSWC:
* For the following vehicles cut the White/Green Green/Orange Orange/Green, , and wires.
** For the following vehicles cut the White/Green Pink Green/Orange, , and wires.
*** For the following vehicles cut the and Pink Green/Orange wires.
For the following vehicles cut the White/Green Pink and wires.
For the following vehicles cut the wire.Pink
BUICK
Century † 2004-2005
LaCrosse 2005-2009
Rainer * 2004-2007
Regal † 2004
Rendezvous2002-2007
Terraza ‡ 2005-2007
CADILLAC
Escalade, Escalade ESV &
EXT * 2003-2006
CHEVROLET
Avalanche * 2003-2006
Cavalier * 2000-2005
Colorado * 2004-2012
CHEVROLET (CONT)
Corvette *** 2007-2011
Corvette 2012-2013
Impala ** 2000-2005
Malibu 2001-2003
Malibu Classic
2004-2005
Monte Carlo ** 2000-2005
Silverado * 2003-2006
Silverado Classic * 2007
SSR * 2003-2006
Suburban * 2003-2006
Tahoe * 2003-2006
Trailblazer * 2002-2009
Uplander ** 2005-2008
GMC
Canyon * 2004-2012
Envoy * 2002-2009
Sierra * 2003-2006
Sierra Classic * 2007
Yukon * 2003-2006
Yukon XL * 2003-2006
HUMMER
H2 * 2003-2007
ISUZU
Ascender * 2003-2008
OLDSMOBILE
Alero ** 2001-2004
Bravada * 2002-2004
Intrigue ** 2002
PONTIAC
Aztec ** 2001-2005
Grand Am ** 2001-2005
Grand Prix ** 2004-2008
Montana SV6 **
2005-2006
Sunfire * 2000-2005
SAAB
9-7x * 2005-2009
SATURN
Relay ** 2005-2007
PROGRAMMING

Especificaciones del producto

Marca: AXESS
Categoría: No categorizado
Modelo: AXDI-CL2

¿Necesitas ayuda?

Si necesitas ayuda con AXESS AXDI-CL2 haz una pregunta a continuación y otros usuarios te responderán




No categorizado AXESS Manuales

No categorizado Manuales

Últimos No categorizado Manuales