Belling Baby 321R Manual de Usario

Belling horno Baby 321R

Lee a continuación 📖 el manual en español para Belling Baby 321R (8 páginas) en la categoría horno. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF
Página 1/8
Baby Belling
321R
Installation and User Instructions
2
Installing Your Cooker
Your Belling Cooker Even if you have used an electric cooker before, it is important that you read
these instructions thoroughly before starting to cook, paying particular attention
to the installation and safety instructions.
Getting help If you have any problems with installing, operating, or cooking with your Belling
Cooker, please check through these instructions thoroughly to make sure that
you have not missed anything. If you still need help, then please contact:
Belling Customer Care Centre
Stoney Lane
Prescot
Merseyside
L35 2XW
Tel 0844 815 3746
If your query relates to cooking then please write to the Senior Home
Economist at the same address.
Details of how to contact a Belling Approved Service Agent, should your cooker
ever require maintenance, can be found in the ‘Care of your cooker’ section of
this book. Please quote the cooker model and serial number with all enquiries,
this can be found on the voltage label which is located on the outer back panel.
WARNING! For your own safety, make sure that these instructions on
installation, use and maintenance are followed.
We advise you to keep these instructions in a safe place for future reference. if
you sell or transfer ownership of this product, please pass on these instructions
to the new owner.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Unpacking After unpacking your cooker, make sure that you remove all the packing from the
oven and grill compartment, and the packing from under the hob on radiant ring
models, and any stickers from the oven door and the hob. Examine your cooker
for any damage. If there is any damage to your cooker or anything is missing,
please contact your supplier for advice.
Locating the cooker Your cooker must stand on a flat surface, or be fitted to the special Belling stand,
so that when it is in position the hob is level. Make sure that the cooker is stable
and cannot be rocked. If it is used between units, allow 10mm (3/8”) clearance
on each side. It must not be situated with either side closer than 150mm (6”) to a
wall or cupboard that is higher than the hob. Do not remove the cooker feet.
Any overhanging surface or cooker hood should be at least 450mm (18”) above
the cooker hob. We do not recommend positioning the cooker below wall
cupboards, as the heat and steam from the cooker may cause damage to the
cupboards and its contents. Make sure that the walls near the cooker are
resistant to heat, steam, and condensation.
3
Installing Your Cooker
Connecting the cooker For your own safety, we recommend that your cooker is installed by
competent electrician. The installation must comply with current I.E.E. Wiring
regulations
Warning: This appliance must be earthed
The cooker must be connected to the correct electrical supply as stated on
the voltage label, through a suitable cooker control unit incorporating a double
pole switch having a contact separation of a least 3mm in all poles. It must not
be connected to a 13amp plug.
We recommend you use 2.5mm² twin and earth cable to connect the cooker
to the mains supply
The cable should be connected to the mains terminal block as follows;
Connect the Green & yellow lead to the terminal marked
Connect the Brown lead to the terminal marked “ ” L
Connect the Blue wire to the terminal marked “ ” N
Ensure that the cable is clamped using the clamp provided.
Allow sufficient cable length for the cooker to be pulled out for cleaning, but
do not let it hang closer than 50mm (2”) to the floor.The cable can be looped
if necessary, but make sure that it is not kinked or trapped when the cooker
is in position.

Especificaciones del producto

Marca: Belling
Categoría: horno
Modelo: Baby 321R

¿Necesitas ayuda?

Si necesitas ayuda con Belling Baby 321R haz una pregunta a continuación y otros usuarios te responderán


horno Belling Manuales

Belling

Belling Farmhouse 90 DFT Manual de Usario

5 Octubre 2024
Belling

Belling Classic 900 DFT Manual de Usario

5 Octubre 2024
Belling

Belling Sandringham 100DFT Manual de Usario

2 Octubre 2024
Belling

Belling GHU75GC Manual de Usario

27 Septiembre 2024
Belling

Belling Kensington 110Ei Manual de Usario

24 Septiembre 2024
Belling

Belling BI602G Manual de Usario

22 Septiembre 2024
Belling

Belling FSEC50DO Manual de Usario

18 Septiembre 2024
Belling

Belling DB4 110E Manual de Usario

17 Septiembre 2024
Belling

Belling BEL BI703MFC Manual de Usario

16 Septiembre 2024
Belling

Belling GHU70GE Manual de Usario

15 Septiembre 2024

horno Manuales

Últimos horno Manuales

Continental Edison

Continental Edison CECM6065W Manual de Usario

27 Octubre 2024
Taurus

Taurus HM778WHD Manual de Usario

27 Octubre 2024
Lacanche

Lacanche CITEAUX Manual de Usario

27 Octubre 2024
JennAir

JennAir JDS1450FS Manual de Usario

27 Octubre 2024
Orima

Orima ORP-76-IN Manual de Usario

27 Octubre 2024
Breville

Breville the Handy Hot Plate BHP150 Manual de Usario

27 Octubre 2024
JennAir

JennAir JGRP436HL Manual de Usario

27 Octubre 2024
Neff

Neff C17MS22G1 Manual de Usario

27 Octubre 2024
Pit Boss

Pit Boss BK24 Manual de Usario

27 Octubre 2024
Guzzanti

Guzzanti GZ-8206 Manual de Usario

27 Octubre 2024