BeSafe iZi Modular i-Size Manual de Usario

BeSafe asiento de coche iZi Modular i-Size

Lee a continuación 📖 el manual en español para BeSafe iZi Modular i-Size (90 páginas) en la categoría asiento de coche. Esta guía fue útil para 7 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/90

> 25 cm

click!

102

108

113

118

123

128

134

140

145

150

156

161

171

177

183

USER MANUAL

Rearfacing 61-105 cm

Forward facing 88-105 cm

Max. weight: 18 kg

Age approx. 6m - 4 yrs

UN regulation no. R129 i-Size

Rear & Forward facing

8 9

! Vital information

• The child seat MUST NOT be installed in a front passenger

seat WITH AN ACTIVATED AIRBAG.

• iZi Modular can only be installed on the iZi Modular

i-Size base.

• iZi Modular is approved rearfacing for children with a stature

height from 61 to 105 cm, with a maximum weight up to 18 kg and

forward facing for children with a stature height from 88 to 105 cm

with a maximum weight up to 18 kg.

• iZi Modular RF is approved rearfacing for children with a stature

height from 61 to 105 cm, with a max. weight up to 18 kg.

• Important: Do not use forward facing before the child is over

15 months.

• BeSafe recommends to use the seat for as long as possible in the

rearfacing position.

• The harness straps must always be locked when the child is in

the seat.

• The harness straps must be tightened without slack and

not twisted.

• The shoulder pads contain magnets. Magnets can inﬂuence

electronic equipment such as pacemakers.

• Protect any part of the child’s body which is exposed to the sun.

• Always dress your child in a thin layer of clothes to avoid direct

contact between harness belts and skin. Avoid puy clothes since

this prevents being able to tighten the belts fully.

• We recommend that this seat is used only for children who can sit

upright, usually not younger than 6 months.

• Remove the extra seat cushion when the child is over 2 years.

• Remove the extra side supports when the child is over 2 years

or earlier when the child does not ﬁt between these side

supports anymore.

• When the child weighs over 18 kg or the shoulder height exceeds

above the highest position of the shoulder straps, the child must

change to a seat suitable for children with a weight above 18 kg.

• Replace the seat if it has been in a collision where the speed was

8 9

15 16

17 18

321

<2 yrs >2 yrs

SIP+

2 3

click!

Thank you for choosing BeSafe iZi Modular (RF)

! It is important that you read this user manual BEFORE

installing your seat. Incorrect installation could endanger

your child.

10 11

• Adjustable head rest

• Shoulder pads (2x)

• Side support

• Shoulder straps (2x)

• Harness buckle

• Seat cushion

• Central adjuster

• Reclining handle

• Release handle head rest

• Front brace

Preparing to install

Installation of the seat on the i-Size base

1. Check if the ISOﬁx and ﬂoor support indicators on the base are

green. (2)

2. Make sure that the front brace is installed on the base. The

operation of the front brace is described in the user manual for the

base. (2)

3. Make sure that the seat is always in the release position when you

want to install the seat on the base or take the seat o the base. The

two yellow arrows on the seat and the base must be aligned. (3) Use

the reclining handle to adjust the recline position, see step 6.

4. Position the seat in the correct position on the base untill it clicks

with the base and the indicator at the front shows green. (3)

5. When the seat is positioned rearfacing on the back seat of the

vehicle, you should, if possible, push the front seat of the vehicle

backwards, so that it is in contact with the child seat (4). If it is not

possible to obtain contact with the child seat, push the back rest of

the front seat of the vehicle forward as far as possible.

6. The seat can be taken o and turned around by pulling the seat

release handle at the front of the base (5,6). Make sure that the

two yellow arrows on seat and seatbase are aligned; this is the only

position where you can take o the seat.

7. The seat should only be turned around to forward facing when the

child is minimum 88 cm and 15 months. BeSafe recommends to use

the seat rearfacing for as long as possible.

8. When the seat is positioned forward facing, the front brace has to be

in position 1. (7)

9. The seat cannot be turned around in the BeSafe iZi Modular RF. This

seat is only to be used rearfacing.

Positioning of the child

Removal of the seat of the i-Size base

1. Check that the shoulder strap slots are level with your child’s

shoulders. (12)

2. While pressing the button of the central adjuster, pull the shoulder

straps away from the seat with a ﬂat hand. Make sure to pull the

straps evenly so that they stay at the same length. (13)

3. Open the harness buckle. (14)

4. The height of the shoulder straps and the head rest can be adjusted

by pulling the release handle upwards at the back of the head rest

and pulling the head rest up or down. (15)

5. Position the shoulder straps over the marking at the sides of the seat

to use the magnets to keep the harness open while you position the

child. (16)

1. The seat can be taken o by pulling the seat release handle at the

front of the base. Make sure that the two yellow arrows on seatbase

and seatbase are aligned; this is the only position where you can take

o the seat.

10. The seat can be reclined by pulling the reclining handle at the front

side of the seat. (8)

11. In a rearfacing position the seat should only be used in the 2 most

reclined positions. (9)

12. The leg room of the seat, in rearfacing position, can be made larger by

pulling the front brace box out from the base. The front brace box has

3 positions. To adjust the front brace position, the seat has to be taken

o and the base should be released from the ISOﬁx. (10)

13. The seat is delivered with removable SIP+ (side impact protection

+). This extra side impact protection should be used on the doorside

of the vehicle. To connect your SIP+ version, follow the instruction

drawings on the SIP+ included with your seat. The seat already oers

high level integrated side impact protection. This extra side impact

protection improves the protection in the side impact still further. (Not

on all models) (11)

14. Do not use the SIP+ on the seat when the space between seat and

door of the vehicle is too small, which might lead to a situation where

the seat is not positioned correctly on the vehicle seat.

Especificaciones del producto

Marca:	BeSafe
Categoría:	asiento de coche
Modelo:	iZi Modular i-Size

¿Necesitas ayuda?

Si necesitas ayuda con BeSafe iZi Modular i-Size haz una pregunta a continuación y otros usuarios te responderán

Tu nombre*

Tu correo electrónico*

Escribe tu pregunta aquí

asiento de coche BeSafe Manuales

BeSafe Go Beyond Lite Manual de Usario

13 Septiembre 2024

BeSafe Beyond Manual de Usario

13 Septiembre 2024

BeSafe Flex FIX 2 Manual de Usario

13 Septiembre 2024

BeSafe iZi Flex S fix Manual de Usario

8 Septiembre 2024

BeSafe Tablet and Seat Cover Manual de Usario

8 Septiembre 2024

BeSafe combi Manual de Usario

8 Septiembre 2024

BeSafe IZI Modular Isofix base Manual de Usario

8 Septiembre 2024

BeSafe iZi Go X1 - 2015 Manual de Usario

8 Septiembre 2024

BeSafe iZi Turn i-Size Manual de Usario

2 Septiembre 2024

BeSafe IZi Kid i-Size Manual de Usario

2 Septiembre 2024

asiento de coche Manuales

Últimos asiento de coche Manuales

Foppapedretti IS0DINAMYK Manual de Usario

27 Octubre 2024

Giordani Pegasus Plus 1/2/3 Isofix Manual de Usario

26 Octubre 2024

Caretero Securo Manual de Usario

26 Octubre 2024

Caretero Kamptos Manual de Usario

26 Octubre 2024

Caretero Rio Manual de Usario

26 Octubre 2024

Caretero Fortis Manual de Usario

26 Octubre 2024

Phil And Teds optimum Manual de Usario

25 Octubre 2024

Cosatto Zoomi 3 i-Size Manual de Usario

21 Octubre 2024

Lionelo Izzy Manual de Usario

20 Octubre 2024

Joie Every Stage FX Signature Manual de Usario

19 Octubre 2024