Broan Elite EI59 Manual de Usario

Broan campana extractora Elite EI59

Lee a continuación 📖 el manual en español para Broan Elite EI59 (32 páginas) en la categoría campana extractora. Esta guía fue útil para 8 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/32

MODEL EI5936SS

Page 1

Chimney Island

Range Hood

READ AND SAVE THESE INSTRUCTIONS

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY

TO PERSON(S) OBSERVE THE FOLLOWING:

1. Use this unit only in the manner intended by the manufacturer. If

you have questions, contact the manufacturer at the address or

telephone the number listed in warranty.

2. servicing Before or cleaning unit, switch power off at service panel

and lock service disconnecting means to prevent power from being

switch on accidentally. When the service disconnecting means

cannot be a locked, securely fasten prominent warning device,

such a as tag, to the service panel.

3. Installation work and electrical be wiring must done by qualified

personnel in accordance codes standards, applicable with all and

including construction fire-rated codes and standards.

4. is combustion Sufficient air needed for proper and exhausting

of gases through the flue (chimney) burning of fuel equipment to

prevent back drafting. Follow the heating equipment manufacturer’s

guideline published and safety standards such as those by the

National Protection Association American Fire (NFPA), and the

Society Refrigeration for Heating, and Air Conditioning Engineers

(ASHRAE), and the local code authorities.

5. This product may have sharp edges. Be careful to avoid cuts and

abrasions during installation and cleaning.

6. When cutting or drilling into wall or ceiling, do not damage electrical

wiring and other hidden utilities.

7. Ducted fans must always be vented to the outdoors.

8. only Use metal ductwork.

9. Do not use this unit with any other solid-state speed control device.

10. This unit be must grounded.

TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

a) Never leave surface units unattended at high settings. Boilovers

cause smoking and greasy spillovers oils that may ignite. Heat

slowly low on or medium settings.

b) Always turn hood ON when cooking at high heat or when flambéing

food Peppercorn (i.e. Crêpes Suzette, Cherries Jubilee, Beef

Flambé).

c) Clean ventilating frequently. fans be Grease should not allowed to

accumulate on fan or filters.

d) Use proper pan size. Always use cookware appropriate for the size

of surface the element.

TO REDUCE THE RISK OF INJURY TO PERSON(S) IN THE EVENT

OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING*:

1. SMOTHER a FLAMES with close-fitting lid, cookie sheet, or metal

tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS.

IF DO THE FLAMES NOT GO OUT IMMEDIATELY, EVACUATE

AND CALL THE FIRE DEPARTMENT.

1. For indoor use only.

2. For general ventilating use only. Do not use to exhaust hazardous

or explosive materials and vapors.

3. To avoid motor bearing damage and noisy and/or unbalanced

impeller, keep drywall spray, construction dust, etc. off power unit.

4. Your hood motor has a thermal overload which will automatically

shut off the motor if it becomes overheated. The motor will restart

when it will cool down. If the motor continues to shut off and

restart, the hood serviced. have

5. The bottom of the hood MUST BE LESS than 24” NOT and

recommended at maximum of 36” a above cooktop best for

capture of cooking impurities.

6. Two installers are recommended because of the size of this

hood.

7. To reduce risk of fire and to properly exhaust air, be sure duct to

air outside. Do not exhaust air into spaces within walls or ceilings

or into attics, crawl spaces, or garages.

8. Be careful when installing the decorative flue and hood, they may

have sharp edges.

9. This hood is not intended to a be used as shelf.

10. Please read specification label on product further information for

and requirements.

Installer: Leave this manual

with the homeowner.

Homeowner: Operation and Maintenance

instructions on pages 8 & 9.

WARNING

CAUTION

FOR DOMESTIC COOKING ONLY

WARNING

2. NEVER PICK A – be UP FLAMING PAN You may burned.

3. DO NOT USE WATER, including wet dishcloths or towels – a violent

steam explosion will result.

4. Use extinguisher an ONLY if:

A. You a extinguisher, know you have Class ABC and you

know how operate to it.

B. The is small fire and contained in the it area where started.

C. The department is fire being called.

D. You can fight the fire with your back to an exit.

* Based on published “Kitchen Fire Safety Tips” by NFPA

MODEL EI5936SS

Page 2

FRONT

HOOD

CENTERLINE

HOOD

CENTERLINE

5”

2”

3½”

HOUSE WIRING

IN THIS AREA

FRONT

HOOD

CENTERLINE

HOOD

CENTERLINE

DUCT

CENTERLINE

OFFSET 1” TO

REAR OF HOOD

8” MINIMUM

8½”

ON CENTER

INSTALL THE DUCTWORK

(Ducted Hoods Only)

1. Decide where the ductwork will run between the hood and

the outside.

2. A straight, short duct run will allow the hood perform most to

efficiently.

3. Long duct runs, elbows and transitions will reduce the

performance of the hood. Use as of them as possible. few

Larger ducting be required best performance with may for

longer duct runs.

4. Install wall cap or roof cap. Connect round metal ductwork to

cap and back the hood location. Use duct tape work towards

to seal the joints between ductwork sections.

PLAN THE INSTALLATION

The minimum hood distance above cooktop MUST BE NOT

LESS than 24”.

A maximum of 36” above cooktop is recommended best for

capture of cooking impurities.

Distances 36” at the installer and users discretion; over are

providing that the ceiling height permits.

INSTALL THE CEILING SUPPORT

1. Construct wood framing that is flush with interior surface of

the ceiling joists.

NOTE

Hood distance above cooktop is: Minimum 24”, Maximum

36”. 9-10 ft. ceilings require Flue Extension Model may

FXNE59SS, depending on installation height (purchase

separately). Discard the upper and lower flues, mounting

frame, and trim strips supplied with your hood and replace

them with Flue Extension Model FXNE59SS.

2. Finish opening to match surrounding ceiling carefully marking

framing location.

INSTALL THE WIRING

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event of an electrical

short circuit, grounding reduces the risk of electric shock by

providing an escape wire the electric current.for

Position the electrical (house wiring) within the space covered by

the decorative flue and where it will not interfere with the round

duct. Make sure the length of the house wiring is a minimum of 5

feet. It be shortened after hood is installed at correct height may

and electrical connection is made.

ROOF P CA

DECORATIVE

FLUES EAVE

VENT

6” ROUND

ELBOWS

6” ROUND

DUCT

HOOD

24” TO 36” ABOVE

COOKING SUFACE

HOOD

CENTER

LINE

DUCT CENTER LINE

(1” rear of hood centerline)to

MODEL EI5936SS

Page 3

PREPARE THE HOOD

Unpack hood and check contents. You should receive:

1 - Hood Assembly

1 - Glass Canopy

1 - Decorative Flue Assembly

(consisting of 2-upper and 2-lower flue sections)

1 - Hood Frame Assembly

(consisting of upper and lower sections)

2 - Upper Flue Trim Strips

2 - Lower Flue Trim Strips

1 - Aluminum Grease Filter (installed on hood)

4 - 35W MR16 GU10 Halogen Lamps (included on hood)

1 - Parts Bag containing:

6 - Mounting Screws (4mm x 38mm Cross Recessed Head) Pan

3 - Mounting Screws (4mm x 12mm Cross Recessed Pan Head)

12 - Mounting Screws (3mm x 5mm Cross Recessed Head) Pan

4 - Mounting Screws (.188” x .250” Cross Recessed Flat Head)

1 - Suction Cup Tool

3 - Wire Nuts

1 - Installation Manual

6 MOUNTING

SCREWS

(4mm x 50mm

Cross Recessed

Pan Head)

3 MOUNTING

SCREWS

(4mm x 12mm

C dross Recesse

Pan Head)

DECORATIVE

FLUE

ASSEMBLY

4 MOUNTING

SCREWS

(.188” x .250”

Cross Recessed

Flat H )ead

BULB SUCTION

CUP TOOL

HOOD

ASSEMBLY

GLASS

CANOPY

HOOD

FRAME ASSEMBLY

FLUE

TRIM

STRIPS

DECORATIVE

FLUE

ASSEMBLY

12 MOUNTING SCREWS

(3mm x 5mm Cross

Recessed Pan Head)

3 WIRE NUTS

Especificaciones del producto

Marca:	Broan
Categoría:	campana extractora
Modelo:	Elite EI59
Color del producto:	Zwart
Pantalla incorporada:	Nee
Ancho:	43.3 mm
Profundidad:	17 mm
Altura:	115.9 mm
Amable:	Basistoegangscontrolelezer
Código de seguridad internacional (IP):	IP65
Indicadores LED:	Status
Lector de huellas dactilares:	Nee
Señal de advertencia:	Ja
Impermeable:	Ja
Tipo de procesador:	Ja
Frecuencia:	13.56 MHz
Alimentación a través de Ethernet (PoE):	Nee
Protocolos soportados:	Wiegand(w26, w34)\nMIFARE
PC conectada:	Nee
Temperatura de funcionamiento (TT):	-20 - 65 °C
Humedad relativa de funcionamiento (VV):	10 - 90 procent
Teclado integrado:	Nee
Tipo de autenticación:	toegangschip/kaart
Lector de código de acceso:	Nee
Acceso al lector de tarjetas/chip:	Ja
frecuencia RFID:	13.56 MHz
Soporte RFID:	50 mm