Celestron EdgeHD 14 Manual de Usario

Celestron No categorizado EdgeHD 14

Lee a continuación 📖 el manual en español para Celestron EdgeHD 14 (21 páginas) en la categoría No categorizado. Esta guía fue útil para 13 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/21

INSTRUCTION MANUAL

8●

●E

5●

●E

1●

●E

Your telescope is designed to give you years of fun and rewarding observations. However, there are a few things to consider before using

your telescope that will ensure your safety and protect your equipment.

Warning

Never look directly at the sun with the naked eye or with a telescope (unless you have the proper solar

filter). Permanent and irreversible eye damage may result.

Never use your telescope to project an image of the sun onto any surface. Internal heat build-up can damage the telescope and any

accessories attached to it.

Never use an eyepiece solar ﬁlter or a Herschel wedge. Internal heat build-up inside the telescope can cause these devices to crack or

break, allowing unﬁltered sunlight to pass through to the eye.

Never leave the telescope unsupervised, either when children are present or adults who may not be familiar with the correct operating

procedures of your telescope.

Technical Specs

Highest Useful Magnification 480x 555x 660x 840x

Lowest Useful Magnification 29x 34x 40x 51x

Limiting Stellar Magnitude 14 14.4 14.7 15.3

Resolution: Rayleigh .68 arc seconds .59 arc seconds .50 arc seconds .39 arc seconds

Dawes Limit .57 arc seconds .49 arc seconds .42 arc seconds .33 arc seconds

Light Gathering Power 843x unaided eye 1127x unaided eye 1593x unaided eye 2579x unaided eye

Field of View: standard eyepiece .85º .8º .67º .48º

Linear FOV (@1000 yds) 44 ft. 42 ft. 35 ft. 25 ft.

Optical Coatings - Standard Starbright XLT Coating Starbright XLT Coating Starbright XLT Coating Starbright XLT Coating

Secondary Mirror Obstruction 2.7" 3.35" 3.75" 4.5"

by Area 11% 13% 12% 10%

by Diameter 34% 36% 34% 32%

Optical tube length 17 inches 22 inches 24 inches 31 inches

#91030

XLT

#91040

XLT

#91050

XLT

#91060

XLT

EdgeHD 800 EdgeHD 925 EdgeHD 1100 EdgeHD 1400

Diameter

203mm (8") EdgeHD

Optics 235mm (9.25") EdgeHD

Optics 280mm (11") EdgeHD

Optics 356mm (14") EdgeHD

Optics

Focal Length 2032mm F/10 2350mm F/10 2800mm F/10 3910mm F/10

Eyepiece 40mm - 1.25" (51x) 23mm - 2" (102x) 23mm - 2" (122x) 23mm - 2" (170x)

Finderscope 9x50 9x50 9x50 9x50

Diagonal 90° - 1.25" 90° - 2" with 1.25"

adapter 90° - 2" with 1.25"

adapter

The visual back is the accessory that allows you to attach all visual accessories to the 8" telescope. The 8" telescope optical

tubes come with the visual back installed. If it is not already on the tube it can be attached as follows:

1. Remove the rubber cover on the rear cell.

2. Place the knurled slip ring on the visual back over the threads on the rear cell (Fig 1-1).

3. Hold the visual back with the set screw in a convenient position and rotate the knurled slip ring clockwise until tight.

Once this is done, you are ready to attach other accessories, such as eyepieces, diagonal prisms, etc.

If you want to remove the visual back, rotate the slip ring counterclockwise until it is free of the rear cell.

The star diagonal is a prism or mirror that diverts the light at a right angle to the light path of the telescope. This allows you

to observe in positions that are physically more comfortable than if you looked straight through.

To attach the 1.25" star diagonal onto the 8" optical tube:

1. Turn the set screw on the visual back until its tip no

longer extends into (i.e., obstructs) the inner diameter of

the visual back.

2. Slide the chrome portion of the star diagonal into the

visual back.

3. Tighten the set screw on the visual back to hold the star

diagonal in place.

If you wish to change the orientation of the star diagonal, loosen

the set screw on the visual back until the star diagonal rotates

freely. Rotate the diagonal to the desired position and tighten the

set screw.

To attach the 2" star diagonal onto the 9.25/11/14" optical tubes:

1. Remove the visual back from the rear of the tube.

2. Attach the threaded ring of the 2" diagonal to the rear cell of

the telescope.

3. Loosen the thumb screws on the side of the diagonal and

remove the 1.25" adapter from the barrel of the diagonal.

If you wish to change the orientation of the 2" star diagonal, loosen the

retaining ring that attaches the diagonal to the rear cell. Rotate the

diagonal to the desired position and tighten the retaining ring.

1.25" Star

Diagonal

Visual Back

1.25"

Eyepiece

Figure 1-1 – Visual accessories for the 8"

2" Mirror

Diagonal

2 inch

Eyepiece

Figure 1-2 – Visual accessories for the 9.25/11/14"

Especificaciones del producto

Marca:	Celestron
Categoría:	No categorizado
Modelo:	EdgeHD 14
Color del producto:	Zwart
Peso.:	864.4 g
Ancho:	410 mm
Profundidad:	100 mm
Altura:	23 mm
Peso del embalaje:	1089 g
Ancho del embalaje:	142 mm
Empaquetadura en profundidad:	448 mm
Altura del embalaje:	48 mm
Fuente-de-alimentación:	Batterijen
Instrucciones:	Ja
Cables suministrados:	USB
Destinado a:	Kantoor
Conecta y reproduce:	Ja
Soporta Windows:	Ja
Diseño ergonomico:	Ja
Número:	1
Uso recomendado:	PC
Número de botones:	7
Soporta el sistema operativo Mac:	Ja
Tipo de desplazamiento:	bal
Resolución de movimiento:	2800 DPI
Receptor suministrado:	Ja
Número de botones programables:	6
tipo de botones:	Drukknoppen
Tecnología de detección de movimiento:	Rollerbar
Número de ruedas de desplazamiento:	1
Direcciones de desplazamiento:	Verticaal/Horizontaal
Interfaz de receptor inalámbrico:	USB Type-A
Altura del paquete principal (exterior):	255 mm
Ancho del embalaje principal (exterior):	300 mm
Peso bruto del embalaje principal (exterior):	12000 g
Longitud del paquete principal (exterior):	470 mm
Cantidad por caja principal (exterior):	10 stuk(s)
Código del Sistema Armonizado (SA):	84716070
Contenido del embalaje principal (exterior):	0.036 cm³
Botones programables del ratón:	Ja
Resolución de movimiento ajustable:	Ja
Número de modos de resolución de movimiento:	10
Ancho de la varilla del rodillo:	30 cm
Número de contrahuellas:	4