Chief PAC117 Manual de Usario
Chief
soporte de panel plano
PAC117
Lee a continuación 📖 el manual en español para Chief PAC117 (4 páginas) en la categoría soporte de panel plano. Esta guía fue útil para 3 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios
Página 1/4
I N S T A L L A T I O N I N S T R U C T I O N S
Steel Stud / Dry Wall Anchor Kits
PAC115-116-117
PAC115-116-117 Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT WARNINGS AND
CAUTIONS!
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component. The wall to which the mount is being attached
may have a maximum drywall thickness of 5/8" (1.6cm).
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components does not exceed 175 lbs (79.38 kg) or the
maximum weight capacity of the mount to which this
accessory is being installed. This product is NOT designed
for use with articulating wall mounts.
TOOLS/PARTS FOR INSTALLATION
(A)
[1/4-20 toggler anchor]
(B)
1/4-20 x 1-3/4"
(C)
1/4"
A B C
MODEL (qty) (qty) (qty)
PAC115 4 4 4
PAC116 8 8 8
PAC117 28 28 28
Installation Instructions PAC115-116-117
3
Assembly and Installation
1. Drill a 1/2" hole at the desired location, making sure wall is
at least 1/2" thick. If the wall is made with metal studs, it is
recommended to install the anchor through the drywall and
the metal stud.
2. Hold metal channel on anchor (A) flat alongside plastic
straps and slide channel through hole. (See Figure 1)
Figure 1
3. Holding plastic straps on anchor (A), pull anchor away from
wall until channel rests flush behind wall making sure anchor
channel is positioned vertically on stud. (See Figure 2)
4. Slide plastic cap on anchor (A) towards wall until flange of
cap is flush with wall. (See Figure 2)
Figure 2
5. Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 3)
6. Repeat steps 1 through 5 for each mounting hole.
Figure 3
7. Place mount over anchors and align mounting holes in
display mount with holes in anchors. (See Figure 4)
8. Insert 1/4-20 x 1-3/4" Phillips pan head screws (B) through
1/4" washer (C), corresponding mounting hole on mount
and into anchor (A) and tighten until flush against mount.
DO NOT overtighten! (See Figure 4)
9. Repeat steps 7 and 8 for remaining mounting holes.
WARNING: IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Overtightening of
mounting hardware can damage the steel studs. DO NOT
overtighten mounting hardware!
Figure 4
(A)
Drywall
Plastic Straps
2
(A)
Plastic Cap
Drywall
Anchor Metal Channel
SIDE VIEW
3
Steel Stud
4
Plastic Straps
Drywall
Anchor Metal Channel
Plastic Cap
SIDE VIEW
5
Steel Stud
Drywall
Anchor Metal Channel
Mount
SIDE VIEW
(B)
8
Steel Stud
(C)
Especificaciones del producto
| Marca: | Chief |
| Categoría: | soporte de panel plano |
| Modelo: | PAC117 |
¿Necesitas ayuda?
Si necesitas ayuda con Chief PAC117 haz una pregunta a continuación y otros usuarios te responderán
soporte de panel plano Chief Manuales
17 Septiembre 2024
16 Septiembre 2024
15 Septiembre 2024
15 Septiembre 2024
14 Septiembre 2024
3 Septiembre 2024
3 Septiembre 2024
3 Septiembre 2024
3 Septiembre 2024
3 Septiembre 2024
soporte de panel plano Manuales
- soporte de panel plano Samsung
- soporte de panel plano HP
- soporte de panel plano Abus
- soporte de panel plano Acco
- soporte de panel plano Icy Box
- soporte de panel plano Hitachi
- soporte de panel plano SilverStone
- soporte de panel plano 3M
- soporte de panel plano GPX
- soporte de panel plano Manhattan
- soporte de panel plano Vision
- soporte de panel plano Kensington
- soporte de panel plano Nec
- soporte de panel plano Techly
- soporte de panel plano BlueBuilt
- soporte de panel plano Da-Lite
- soporte de panel plano Luxor
- soporte de panel plano Steren
- soporte de panel plano Iiyama
- soporte de panel plano Barkan
- soporte de panel plano Digitus
- soporte de panel plano Insignia
- soporte de panel plano Sanus
- soporte de panel plano Peerless-AV
- soporte de panel plano Vogels
- soporte de panel plano Fellowes
- soporte de panel plano Planar
- soporte de panel plano Sven
- soporte de panel plano Konig
- soporte de panel plano Valueline
- soporte de panel plano One For All
- soporte de panel plano Ematic
- soporte de panel plano Newstar
- soporte de panel plano Ewent
- soporte de panel plano BakkerElkhuizen
- soporte de panel plano Ultimate
- soporte de panel plano Wentronic
- soporte de panel plano Peerless
- soporte de panel plano Proaim
- soporte de panel plano Monoprice
- soporte de panel plano Ergotron
- soporte de panel plano Gabor
- soporte de panel plano Konig & Meyer
- soporte de panel plano Premier
- soporte de panel plano Atdec
- soporte de panel plano StarTech.com
- soporte de panel plano SIIG
- soporte de panel plano Bell'O
- soporte de panel plano B-tech
- soporte de panel plano Speaka
- soporte de panel plano Crimson
- soporte de panel plano Kogan
- soporte de panel plano Panduit
- soporte de panel plano Schwaiger
- soporte de panel plano Premier Mounts
- soporte de panel plano Cabstone
- soporte de panel plano Elite Screens
- soporte de panel plano V7
- soporte de panel plano Kondator
- soporte de panel plano Bretford
- soporte de panel plano SmartMetals
- soporte de panel plano Unicol
- soporte de panel plano Equip
- soporte de panel plano Zaor
- soporte de panel plano Dataflex
- soporte de panel plano Multibrackets
- soporte de panel plano Anthro
- soporte de panel plano AMX
- soporte de panel plano Rocstor
- soporte de panel plano CTA Digital
- soporte de panel plano Amer
- soporte de panel plano Avteq
- soporte de panel plano Walker Edison
- soporte de panel plano My Wall
- soporte de panel plano Mount-It!
- soporte de panel plano LTN Technologies
- soporte de panel plano Heckler
- soporte de panel plano Helder
Últimos soporte de panel plano Manuales
27 Octubre 2024
15 Octubre 2024
15 Octubre 2024
4 Octubre 2024
2 Octubre 2024
1 Octubre 2024
1 Octubre 2024
1 Octubre 2024
1 Octubre 2024
1 Octubre 2024