Doepfer A-143-3 Manual de Usario

Lee a continuación 📖 el manual en español para Doepfer A-143-3 (4 páginas) en la categoría No categorizado. Esta guía fue útil para 3 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/4
DOEPFERDOEPFERDOEPFERDOEPFER System A-100 Quad LFO A-143-3
1
Fig. 1: A-143-3 Controls and Outputs
1. Introduction
Module A-143-3 Quad LFO is a low-cost four-fold
modulation oscillator and includes four independent low
frequency oscillators (LFO's), which produce cyclical
control voltages in a wide frequency range.
Three waveforms are available for each LFO: triangle,
square and sawtooth. The frequency of the sawtooth
output is twice the frequency of the other outputs.
The LFO's can be used as modulation sources for any
control voltage input of other modules - for instance
modulating the pulse width or frequency of a VCO,
modulating the cut-off frequency of a VCF or the phase-shift
of a VCP, amplitude modulation with a VCA, delay time of a
BBD module, parameters of a voltage controlled wave
shaper/multiplier, or any other control voltage input.
A three-way switch let’s you select three frequency ranges,
spanning from about two cycles per minute at the lowest, to
moderate audio frequency at the highest.
The module includes four identical units.
Quad LFO A-143-3 System A-100 DOEPFERDOEPFERDOEPFERDOEPFER
2
2. Overview
Fig. 2: A-143-3 front panel
Controls:
1Frequ. : frequency control
2Range: frequency range switch
3: LED control
Outputs:
!: triangle output
": rectangle output
§: sawtooth output
The controls and outputs are the same for all four sub-units.
Module width: 14 HP / 70.8 mm
Module current: 70 mA
2
1
§
"
!
3
DOEPFERDOEPFERDOEPFERDOEPFER System A-100 Quad LFO A-143-3
3
3. Controls and Outputs
1 Frequency
This control adjusts the frequency of the LFO within the
frequency range set by the range switch 2.
2 Range
Use switch 2 to select a suitable frequency range:
L (low): minimum about 2 cycles per minute
M (medium): normal LFO range
H (high): moderate audio range
Pay attention that the high range is in the middle position
due to technical reasons.
3 LED
LED 3 displays the triangle signal that appears at socket !.
If the LFO frequency goes above about 25 Hz, our
persistence of vision means that the LEDs look permanently
on.
!
This is the output for the triangle wave, whose frequency is
displayed by LED 3. The output is symmetrical around 0V,
the level is about ± 7 V.
"
This is the output for the square wave. The output is
symmetrical around 0V, the level is about ± 6 V.
§
This is the output for the sawtooth wave. The output is
symmetrical around 0V, the level is about ± 7 V. To obtain
an inverted sawtooth the voltage inverter module A-175 may
be used.
Fig. 3: A-143-3 waveforms and levels

Especificaciones del producto

Marca: Doepfer
Categoría: No categorizado
Modelo: A-143-3

¿Necesitas ayuda?

Si necesitas ayuda con Doepfer A-143-3 haz una pregunta a continuación y otros usuarios te responderán




No categorizado Doepfer Manuales

No categorizado Manuales

Últimos No categorizado Manuales