Electrolux EPWD157STT Manual de Usario

Lee a continuación 📖 el manual en español para Electrolux EPWD157STT (12 páginas) en la categoría No categorizado. Esta guía fue útil para 10 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/12
137360500 A (1102)
Installation Instructions
Electrolux 15” Pedestal
Instructions d’installation
Socle de 38 cm (15 po) Electrolux
Instrucciones de Instalación
Pedestal Electrolux de 15" (38,1 cm)
WARNING
Failure to disconnect from power
source before stacking could result in
personal injury or even death.
Improper installation of dryer venting
could result in personal injury or
damage to property.
To avoid back or other injury, have more
than one person move or lift the washer
or dryer.
Do not stack a dryer on top of washer
already installed on pedestal.
AVERTISSEMENT
Ne pas débrancher l’appareil de sa
source d’alimentation en électricité
avant de le superposer peut causer des
blessures, voire la mort.
Une installation inappropriée du
système de ventilation de la sécheuse
peut causer des blessures ou des
dommages matériels.
Pour éviter les blessures au dos ou
d’autres types de blessure, demandez
l’aide d’autres personnes pour déplacer
ou soulever la laveuse ou la sécheuse
.
Ne superposez pas une sécheuse sur
une laveuse déjà installée sur un socle.
ADVERTENCIA
El no desconectar el suministro
eléctrico antes de la instalación apilada
puede ocasionar lesiones personales o
incluso la muerte.
La instalación inadecuada de la
ventilación de la secadora puede
ocasionar lesiones personales o daños
a la propiedad.
Para evitar lesiones en la espalda u
otro tipo de lesiones, procure levantar
o mover la lavadora o secadora con la
ayuda de más de una persona.
No apile la secadora sobre la lavadora
si p1-ya está instalada sobre un pedestal.
Adjustable wrench
Llave ajustable
Clé à molette
Carpenter’s level
Nivel de carpintero
Niveau de charpentier
Universal wrench
supplied with washer
Llave universal propor-
cionada con la lavadora
Clé iniverselle fournie
avec la laveuse
Phillips screwdriver
Destornillador Phillips
Tournevis Phillips
OR
O
OU
OR
O
OU
AND
Y
ET
AND
Y
ET
9/16” or 14 mm box wrench
Llave de cubo de
9/16 po o 14 mm
Clé polygonale de
9/16 po ou de 14 mm
Tools needed:
Outils nécessaires:
Herramientas necesarias:
26.5”
(67 cm)
42.5”
(108 cm)
15
(38 cm)
27
(68.5 cm)
IMPORTANT
Total weight IN closed drawer or combination of IN and ON TOP
OF open drawer should not exceed 65 lb. (29.5 kg).
IMPORTANTE
El peso total DENTRO del cajón cerrado o el peso combinado de
los artículos que estén DENTRO y ENCIMA del cajón abierto no
debe exceder las 65 lb (29,5 kg)
.
IMPORTANT
Le poids total DANS un tiroir fermé ou une combinaison du poids
DANS et SUR le tiroir ouvert ne doit pas excéder 29,5 kg (65 lb).
English continued on page 2.
Pour la suite de la version française,
reportez-vous à la page 5. La versión en español continúa en la página 8.
C
SCREW KIT COMPONENTS:
14 #10 (16 x .500) screws.C
COMPOSANTS DU NÉCESSAIRE DE VIS:
14 vis n° 10 (16 x .500).C
PIEZAS DEL KIT (TORNILLOS):
14 tornillos n.º 10 (16 x .500).C
KIT COMPONENTS:
2 Front brackets.A
2 Rear brackets.B
COMPOSANTS DU NÉCESSAIRE :
2 supports avant.A
2 supports arrière.B
PIEZAS DEL KIT:
2 soportes delanteros.A
2 soportes traseros.B
A
B
CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more than one person move
or lift the appliance.
If washer or dryer is new and has not been installed yet, skip 1.
to step 4.
If dryer is already installed, disconnect dryer from electrical 2.
and gas connections and exhaust venting. On models with
Steam Option, turn off cold water supply and disconnect wa-
ter supply hose to dryer.
If washer is already installed, disconnect washer from electri-3.
cal connection. Turn off hot and cold water supply and dis-
connect hot and cold water supply hoses from water supply
outlets. Disconnect drain hose from drain pipe.
Protect fl oor and unit with cardboard or rug and carefully lay 4.
the appliance on its side and screw each leg completely into
the base.
NOTE
Allow for approximately 5 in. (12.5 cm) behind the pedestal
for clearance of back of washer or dryer to the wall. Allow an
additional 3/4 in. (2 cm) for water inlet on Steam Model Dryers
and additional space if venting dryer upward or downward.
NOTE
Due to higher center of gravity of appliance on pedestals, some
side-to-side rocking is normal during operation. Vibration can be
minimized by assuring appliance is installed properly, including being
level and solid on all four (4) legs by following these directions.
lock nut
2
Prepare appliance for mounting
Prepare pedestal before mounting
Locate pedestal 1.
to within a few
inches of its
nal location.
Level the pedestal 2.
front-to-back and
side-to-side by ad-
justing each leveling
leg. Keep leg exten-
sion to a minimum.
Rock the pedestal from corner-to-corner to check for stability. 3.
Repeat leveling and rocking until all four (4) feet are sturdy on
the fl oor and pedestal is level.
Without turning the rubber foot, lock each pedestal leg in 4.
place by tightening its lock nut tight against the pedestal
base.
DO NOT remove foam!
raise lower
adjustable
pliers
IMPORTANT
DO NOT use open dispenser drawer of washer or dispenser
cavity as hand-hold location when tipping washer on its side.
Serious damage could occur to your washer.
IMPORTANT
If feet are not completely screwed in, mounting holes in
appliance will not align to mounting holes in brackets.
3
Attach front mounting brackets
Attach rear mounting brackets
DRAWER
Attach each front bracket to outer-1.
most set of holes with 2 screws.
Determine your appliance type (washer or dryer) according to column 1.
1 in table below.
Orient rear brackets according to column 2 for your particular model.2.
Attach each bracket with 2 screws through the holes that line up on 3.
pedestal.
Front brackets
from kit.
1 - Appliance 2 - Rear bracket orientation
DRYER
Tab A into
Slot 1
Arrow pointing to back
WASHER
Tab A into
Slot 1
Arrow pointing to front
TAB A
TAB B
Each rear bracket has tabs marked “A” and “B”.
Each pedestal has slots in the rear marked “1”, “2”
and “3”.
Each rear bracket also has 2 arrows indicating
bracket direction when mounted on the pedestal.
SLOT 1
SLOT 2
SLOT 3
DIRECTION
INDICATOR
ARROWS

Especificaciones del producto

Marca: Electrolux
Categoría: No categorizado
Modelo: EPWD157STT
Color del producto: Zwart
Estuche de almacenamiento: Ja
Marcas de cámaras compatibles: Nikon
Número de guía de flash: 85 m

¿Necesitas ayuda?

Si necesitas ayuda con Electrolux EPWD157STT haz una pregunta a continuación y otros usuarios te responderán




No categorizado Electrolux Manuales

No categorizado Manuales

Últimos No categorizado Manuales