Elkay LK2500CR Manual de Usario

Elkay Grúa LK2500CR

Lee a continuación 📖 el manual en español para Elkay LK2500CR (5 páginas) en la categoría Grúa. Esta guía fue útil para 11 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/5
WrenchGroove joint pliers Screwdriver Sealant Tape Plumber's Putty
(2) 1/2 Supply Linesin
SAVE FOR CONSUMER
Single Handle Kitchen Faucet
Model # LK2500
INSTALLATION / OWNER'S MANUAL
OPTIONAL 2.2GPM FLOW
REGULATOR
You choose the ow rate!
This faucet ships with an
eco-friendly 1.5GPM ow regulator
installed.
If you desire higher ow rate, a
2.2GPMow regulator has also
been included in the box.
Switching the ow regulator is
simple! See the "Flow Regulator
Replacement" section for details.
Important!
Insert faucet body through the hole in escutcheon.
From underneath sink, hand tighten mounting nuts (1).
Install plastic washer (2) and metal washer (3) onto the
threaded mounting shank. Thread nut (4) onto mounting
shank. Do not overtighten.
Insert faucet body through the hole in sink.
Install plastic washer (1) and metal washer (2) onto the
threaded mounting shank. Thread nut (3) onto mounting
shank. Do not overtighten.
Before installation, screw bolts to the large escutcheon.
Insert escutcheon assembly through the gasket and the
holes of the sink.
Shut off water supplies.
Before installation, remove quick connect assembly (1)
from the free end of hose.
If installing the faucet with the escutcheon, begin with step
2A. If installing the faucet with flange, begin with step 3.
STEPS:
WARNING: Please carefully read and properly follow the instructions for installation found in this manual.
1
3-Ø 1 3/8" (Ø35mm)
2
3
4
1
2
3
1
Ø 1 3/8" (Ø35mm)
STEPS:
Screw quick connect assembly to the free end of hose.
Align male tting (1) and tabs (2) on quick connector.
Push quick connector housing firmly upward and snap
onto receiving male tting. Pull down moderately to
ensure connection has been made.
Important: after installation is completed, turn on hot
and cold water supplies. Check for leaks. Remove
the spray head by unscrewing it from the hose
counterclockwise. Turn the faucet on to the warm
position where it mixes hot and cold water. Flush
water lines for one minute. Check for leaks.
Re-tighten any connections if necessary, but do not
overtighten. Reinstall spray head by hand tightening
it back onto the hose.
WARNING: Please carefully read and properly follow the instructions for installation found in this manual.
Make connections to water lines.
Use 1/2" I.P.S. faucet connections (1) or use coupling
nuts (3) with 3/8" O.D.ball-nose riser (2). Use
wrenches to tighten connections. Do not overtighten.
1
2
3
12

Especificaciones del producto

Marca: Elkay
Categoría: Grúa
Modelo: LK2500CR

¿Necesitas ayuda?

Si necesitas ayuda con Elkay LK2500CR haz una pregunta a continuación y otros usuarios te responderán




Grúa Elkay Manuales

Grúa Manuales

Últimos Grúa Manuales