Elkay LKLFAV1031NK Manual de Usario

Elkay No categorizado LKLFAV1031NK

Lee a continuación 📖 el manual en español para Elkay LKLFAV1031NK (7 páginas) en la categoría No categorizado. Esta guía fue útil para 7 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/7
SAVE FOR CONSUMER
INSTALLATION / OWNER’S MANUAL
Avado - Pull-Down Kitchen Faucet
LKAV1031CR
LKAV1031NK
LKLFAV1031CR
LKLFAV1031NK
Includes:
Tools:
A
B
D
D1
D1
D2
B1
B2
B3
C1
C2
E
1/2”
[13 mm]
13/16”
[20 mm]
5/8”
[16 mm]
13/16”
[21 mm]
C
NOTE: only 1 D1 washer is
used with this faucet model
NOTE: these washers are not
used on this faucet model
WARNING: please carefully read and properly follow the instructions for installation found in this manual.
STEPS:
5
Connect the exible hoses to the supply connections
with rubber gaskets.
Secure with wrench.
Turn on the water and check for leaks.
321
Before dissassembling the faucet be sure that the water supply is turned off.
Remove the nish cap (A), paying attention not to damage it. Remove the setscrew (B) with a 1/8” [2,5mm] hex wrench. Remove the handle (C). Lift the nishing ring nut (D)
using the reference notch. Unscrew the cartridge nut (E) then pull out the cartridge (F). Put the new car tridge into the body of the faucet, checking that the two centering pins
enter into the respective seats (X) and that the gaskets on the cartridge are well positioned.
Reassmble the handle following the instructions in reverse order.
5/8”
[16 mm]
Hot
Cold
Red
Blue
CARTRIDGE REPLACEMENT
B
A
C
X
1/8”
[2,5 mm]
FE
1-1/8”
[28 mm]
D
321
Before inserting the single lever group in the hole of
the sink, make sure that the base gasket is properly
positioned in its seat and that the exible hoses are
well tightened to the body of the tap.
Place the single lever group in the hole of the sink,
orienting the spout toward the sink tank.
For countertop thicknesses less than 1/16” thick
use the ange (B1), for all other installations use
the metal washer (B2).
Secure mounting hardware in place by tighte ning
mounting nut (B3).
Install the check valve (C1) to the outlet hose with a
rubber washer (C2).
Secure with wrench.
Attach the pull-down hose to th e bottom of the
check valve with a rubber washer (D1).
Secure with wrench.
13/16”
[20 mm]
1/2”
[13 mm]
4
Attach the counterweight (D2) to the exible ho se
approximately 15-3/4 [400mm] from the connection
to the outlet pipe.
B3
B
2
B1
A
C2
D1
C1
13/16”
[21 mm]
D2
1
321
Before operating, ensure the water supply is turned
off.
Unscrew the fastening pin of the hand shower (A)
and remove it from its connection (B).
Disassemble the hose-carrier connection from the
hand shower connection (C).
Unscrew the connection (C) from the hose (D).
54
Remove the connection of the hand shower from the
hose (E).
Remove the hand shower, completely disconnected,
to carry out the replacement (F).
Finally reassemble the whole with the opposite pro-
cedure.
REPLACEMENT OF THE HAND SHOWER
2
Before removing the aerator make sure that the faucet is turned off.
Unscrew the aerator using the aerator installtion key (E) included with the faucet.
If the aerator is clogged just rinse it with running water. Do not use detergents.
Reassemble the aerator by following the instructions in reverse order.
AERATOR CLEANING / REPLACING
E
C
E
A
1/16”
[2 mm] B
11/16”
[18 mm]
3/4”
[19 mm]
C
11/16”
[18 mm]
D
11/16”
[18 mm]
F

Especificaciones del producto

Marca: Elkay
Categoría: No categorizado
Modelo: LKLFAV1031NK

¿Necesitas ayuda?

Si necesitas ayuda con Elkay LKLFAV1031NK haz una pregunta a continuación y otros usuarios te responderán




No categorizado Elkay Manuales

No categorizado Manuales

Últimos No categorizado Manuales