Extech IR200 Manual de Usario
Extech
multimetro
IR200
Lee a continuación 📖 el manual en español para Extech IR200 (7 páginas) en la categoría multimetro. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios
Página 1/7
User Manual
InfraRed Thermometer
with Laser Pointer
MODEL IR400
Additional User Manual translations available at www.extech.com
IR400 en 2.0- - vUS_ 7/22
2
Introduction
Congratulations on your purchase of the Model IR400 IR Thermometer. The IR400 is capable of
non-contact (infrared) temperature measurements at the touch of a button. The built-in laser pointer
increases target accuracy while the backlit LCD and handy pushbuttons combine for convenient,
ergonomic operation. This meter is shipped fully tested and calibrated and, with proper use, will
provide years of reliable service.
Safety
• Use extreme caution when the laser beam is onpointer
• Do not point the beam toward anyone's eye or allow the beam
to strike the eye from a reflective surface
• Do not use the laser near explosive gases or in other
potentially explosive areas
Meter Description
Meter Description
1. Laser pointer beam
2. IR Sensor
3. Measurement Trigger
4. Battery Compartment
5. LCD Display
6. Pushbuttons
7. Handle Grip
Display Description
1. Temperature scan in progress (trigger held)
2. Last reading held (trigger released)
3. Laser pointer ON
4. Emissivity (0.95 fixed)
5. Max or MIN value displayed
6. Temperature display
7. Low battery icon (replace battery)
8. Temperature units
IR400 en 2.0- - vUS_ 7/22
3
Operating Instructions
Basic IR Measurements
1. Hold the meter by its handle and point it toward the surface to be measured.
2. Pull and hold the trigger to turn the meter on and begin testing. The temperature reading, the
flashi and ng ‘SCAN’ icon the unit of measure, , € = 0.95 will appear.
3. seconds Release the Trigger and the reading will hold for approximately 10 (HOLD will appear
on the LCD) after which the meter will automatically shut off.
Laser Pointer
1. When the trigger is pressed, the laser pointer will turn on and identify the spot being measured.
The icon on the display indicates that the pointer is on.
2. To turn the laser pointer off, press the button while scanning. Press the button again to
turn the pointer back on.
MAX - MIN
The Max / Min feature provides a means to display the highest (MAX) or lowest (MIN) temperature
measured during a scan.
1. While the trigger is pressed, press the MAX/MIN button will appear. The “MAX” icon and the
maximum measured temperature will appear in the display. The displayed temperature will not
change until a higher temperature is measured.
2. Press the MAX/MIN button again and the “ ” icon will appear. MIN The minimum temperature
only be displayewill d
3. Press the MAX/MIN button again to return to a real time display.
Temperature Units C/F
To change the temperature units, press and release the trigger. Momentarily press the C/F button
and the temperature unit will change.
Backlight
When the meter is on, press the backlight button to turn the backlight on. Press the button again
to turn the backlight off.
Note: Constant use of the backlight feature will reduce battery life.
Over-Range Indication
If the temperature measurement exceeds the specified temperature range, the thermometer will
display “HI” or “LO” in place of a temperature reading.
Especificaciones del producto
| Marca: | Extech |
| Categoría: | multimetro |
| Modelo: | IR200 |
¿Necesitas ayuda?
Si necesitas ayuda con Extech IR200 haz una pregunta a continuación y otros usuarios te responderán
multimetro Extech Manuales
19 Septiembre 2024
9 Septiembre 2024
9 Septiembre 2024
9 Septiembre 2024
9 Septiembre 2024
4 Septiembre 2024
30 Agosto 2024
30 Agosto 2024
30 Agosto 2024
26 Agosto 2024
multimetro Manuales
- multimetro Alecto
- multimetro Appa
- multimetro Amprobe
- multimetro Silverline
- multimetro Ferm
- multimetro Workzone
- multimetro Stanley
- multimetro Yato
- multimetro Parkside
- multimetro Milwaukee
- multimetro EMOS
- multimetro Tacklife
- multimetro Schneider
- multimetro Metrix
- multimetro Benning
- multimetro Voltcraft
- multimetro Somogyi
- multimetro Velleman
- multimetro Steren
- multimetro Kyoritsu
- multimetro Ideal
- multimetro Flir
- multimetro Maxwell
- multimetro Digitus
- multimetro Testboy
- multimetro Hager
- multimetro Topcraft
- multimetro TFA
- multimetro Clas Ohlson
- multimetro Powerfix
- multimetro Owon
- multimetro Fluke
- multimetro Jung
- multimetro Etekcity
- multimetro Greenlee
- multimetro Högert
- multimetro Laserliner
- multimetro REV
- multimetro Testo
- multimetro Bruder Mannesmann
- multimetro Keithley
- multimetro Monacor
- multimetro Metrel
- multimetro Multimetrix
- multimetro Digi-tool
- multimetro Brandson
- multimetro GW Instek
- multimetro Skandia
- multimetro Elma
- multimetro Beha-Amprobe
- multimetro Vimar
- multimetro Uni-T
- multimetro Kewtech
- multimetro Strex
- multimetro Mastech
- multimetro PeakTech
- multimetro Sonel
- multimetro MBS
- multimetro MGL Avionics
- multimetro Chauvin Arnoux
- multimetro Megger
- multimetro Gossen Metrawatt
- multimetro Rigol
- multimetro PCE Instruments
- multimetro Micronta
- multimetro CEM
- multimetro Horex
- multimetro Cosinus
- multimetro Joy-it
- multimetro Klein Tools
- multimetro Aim TTi
- multimetro Kurth Electronic
- multimetro Wiha
- multimetro Weltron
- multimetro Sanwa
- multimetro Rohde & Schwarz
- multimetro EEVBlog
- multimetro Kingcraft
- multimetro Weidmüller
- multimetro HT Instruments
- multimetro Caltek
- multimetro Elworks
- multimetro Qian
- multimetro Bearware
- multimetro Noyafa
Últimos multimetro Manuales
22 Octubre 2024
21 Octubre 2024
18 Octubre 2024
18 Octubre 2024
17 Octubre 2024
16 Octubre 2024
16 Octubre 2024
16 Octubre 2024
16 Octubre 2024
16 Octubre 2024