Extron MDA 5A RCA Manual de Usario

Extron receptor MDA 5A RCA

Lee a continuación 📖 el manual en español para Extron MDA 5A RCA (2 páginas) en la categoría receptor. Esta guía fue útil para 5 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/2
Setup Guide — MDA 5V, 5SV, 5A RCA
The Extron® MDA 5 series of mini distribution amplifiers distribute buffered
composite video (MDA 5V), buffered S-video (MDA 5SV), and amplified stereo audio
(MDA 5A RCA). Unless otherwise stated, these instructions apply to all three of the
amplifiers.
W These instructions provide a quick setup guide for experienced installers.
Installation and service must be performed by authorized personnel only.
MDA 5V
POWER
12V
.5A MAX
4
3
5
INPUT
IN HIGH Z
75 Ohm
LOOP 2
1
OUTPUTS
3
7
2 4 6
Rear Panel MDA 5V
DISTRIBUTION AMPLIFIER
Front Panel All Models
1
MDA 5SV
POWER
12V
.5A MAX
4
3
5
INPUT
IN HIGH Z
75 Ohm
LOOP 2
1
OUTPUTS
47
6
2
Rear Panel MDA 5SV
MDA 5A RCA
POWER
12V
.34A MAX
INPUT OUTPUTS
1 2 3 4 5
L
R
582
Rear Panel MDA 5A RCA
3
Step 1
Turn all the equipment off and disconnect all cables.
Step 2
Mount the unit in a convenient location, in a rack, under a desk, or on a projector mounting system. Follow the
instructions included with the appropriate mounting kit.
Step 3
Connect the external 12 VDC power supply (provided) to the 2-pole, captive screw power
connector (b). When power is applied to the unit, the front panel LED (
a) lights green.
C Voltage polarity is important. Identify the negative lead by the ridges on the side (see figure
at right).
C Always use a power supply specified by Extron for this unit. Use of an unauthorized power
supply voids all regulatory compliance certification and may cause damage to the supply
and the distribution amplifier.
Step 4
For the MDA 5V:
Connect a video source to the video input (c), using composite video (BNC) connectors.
For the MDA 5SV:
Connect a video source to the video input (c), using S-video (4-pin mini DIN) connectors.
For the MDA 5A RCA:
Connect an audio source to the audio inputs (c), using unbalanced stereo to RCA connectors. Left channel input goes to
the upper input; right channel input goes to the lower input.
Indicators and
Connectors
a
Power LED
b
Power supply input
c
Video input
d
Video loop to local
monitor
e
Audio input (left channel
top; right channel
bottom)
f
High Z/75 Ohm switch
g
video outputs
h
audio outputs (left
channel top; right
channel bottom)
POWER
12V
.5A MAX
SECTION A–A
RidgesSmooth
Power Supply
Output Cord
A A
© 2010 Extron Electronics. All rights reserved.
Extron USA - West
Headquarters
+800.633.9876
Inside USA / Canada Only
+1.714.491.1500
+1.714.491.1517 FAX
Extron USA - East
+800.633.9876
Inside USA / Canada Only
+1.919.863.1794
+1.919.863.1797 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+400.883.1568
Inside China Only
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.2991800
+971.4.2991880 FAX
Setup Guide — MDA 5V, 5SV, 5A RCA, cont’d
575 Ohm
HIGH Z
LOO P
IN
2 4
1 3
12V
POW ER
.1A MAX
MDA 5S V
INP UT OU T PU T S
Local Monitor
Flat Panel
Display
Flat Panel
Display
VCR
Ext ron
MDA 5SV
Distribution
Amplier
Step 5 (optional)
For the MDA 5V:
Connect the video loop feed (d) to a local monitor, using composite video connectors.
For the MDA 5SV:
Connect a video loop feed (d) to a local monitor, using S-video connectors.
Step 6
For the MDA 5V and MDA 5SV models:
If a terminated device was connected to the loop feed in , set the High Z/75 Ohm switch (step 5 f) to High Z (up
position, as shown in the figure at right). If no device or an unterminated device was connected to the loop feed
in , set the switch to 75 Ohm (down position).step 5
Step 7
For the MDA 5V:
Connect up to five display composite video devices to the outputs (g), using composite video connectors.
For the MDA 5SV:
Connect up to five display S-video devices to the outputs (g), using S-video connectors.
For the MDA 5A RCA:
Connect up to five stereo audio devices to the audio outputs (h), using the RCA connectors (left channel top; right channel
bottom).
Troubleshooting
If you have problems, please consult the full manual, which is available on-line at www.extron.com.
If the problems persist, contact the Extron service department.
MDA 5A RCA
P O WER
12V
.3A MAX
INPUT OUT PUT S
R
L
321 4 5
CD Player
Tape Recorder
Ext ron
MDA 5A RCA
Distribution
Amplier
Ext ron
XPA 1002
Power
Amplier
Ext ron
XPA 1002
Power
Amplier
Ext ron
SI 28
Surface-mount
Speakers
Ext ron
SI 28
Surface-mount
Speakers
XPA 1002
1 2LIMITER/PROTECT
SIGNAL
OVER
TEMP
XPA 1002
12
LIMITER/PROTECT
SIGNAL
OVER
TEMP
HIGH Z
75 Ohm
68-614-50
Rev. A
01 10

Especificaciones del producto

Marca: Extron
Categoría: receptor
Modelo: MDA 5A RCA

¿Necesitas ayuda?

Si necesitas ayuda con Extron MDA 5A RCA haz una pregunta a continuación y otros usuarios te responderán




receptor Extron Manuales

receptor Manuales

Últimos receptor Manuales