Friedland D417E - Evo 50m Manual de Usario

Friedland Timbre de la puerta D417E - Evo 50m

Lee a continuación 📖 el manual en español para Friedland D417E - Evo 50m (1 páginas) en la categoría Timbre de la puerta. Esta guía fue útil para 12 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/1

D417E

Fig 6

1. Open the bell push

To open the front cover carefully

insert a flat bladed screw driver, into

the slot and twist gently (A). When

refitting the front cover to ensure

the weather proofing is maintained,

always mount the bell push in the

upright position and replace the

cover securely. Fig 1

2. To fit or replace the battery

Open the front cover and insert

the CR 2032 Lithium coin cell

battery into the base as shown

in Fig 2. Any debris created

during installation must be

removed from the base before

fitting battery, to ensure good contact.

3. Mount the bell push

Ensure the wall surface is clean

and dry. Mount using either the

double sided sticky pad on a

smooth surface, or the screws

and wall plugs provided, See Fig 3.

Do not mount the push on or near

(< 30cm) large metal objects, as it

will block signals from the push.

4. Test the bell push

When the bell push button is pressed,

the confidence light (B) in Fig 4, will

illuminate to reassure the caller that

the bell push is working.

The light will flash 5 times when

the battery needs replacing.

5. Use of the door chime

Plug the chime into any

220-240V BS 1363 socket,

installed in a clean dry

environment, situated

within transmission

range of the bell push,

as shown in Fig 5.

6. Automatic Programming of bell pushes

The first time a chime unit is powered up, the sounds available

are demonstrated. Press the door push until the chime

responds with a tune. You can leave this tune or change it to a

desired tune by using button A (see fig 6) (see Sound Selection).

To programme a second push, press the push button until the

chime sounds, then use button B to change the tune if

required. Programming is now completed.

If more than 5 minutes has elapsed, you will have to reset the

chime programing by pressing and holding buttons A and B

until the chime sounds, this takes approximately 5 seconds.

The chime can then be programmed to 1 or 2 door pushes.

All EVO and Décor Chimes and Bell Pushes use a self learning

feature to ensure no interaction from other neighbouring

systems.

7. Sound Selection

A = Main push sound selection

B = Second push sound selection

Chime tune options are as follows:

1. Tone Bar 2 Note (Default Tune for 1st Push)

2. Bass clarinet (Default Tune for 2nd Push)

Fig 1

Fig 2

Fig 4

Fig 5

Fig 3

Evo 50m* Wirefree

Plug-In Chime Kit

Declaration

Novar ED&S hereby declares that this

wirefree chime kit is in compliance with

the essential requirements and other

relevant provisions of the Radio and

Telecommunications Terminal Equipment

(R & TTE) directive, 1999/5/EC

Pack contents:

50m Plug-In Chime 230v

Bell push & CR2032 Lithium coin cell battery

Adhesive pad, 2 x screws (ø3x20mm) 2 x wall plugs (ø5x25mm)

for mounting the bell push

You will require:

A small crosshead and flathead screwdriver, a ø5 masonry drill

The stated transmission range of this product is measured in

open field conditions. Walls ceilings, and metal structures will

reduce the maximum range.

Friedland guarantees this product for 3 years from date of purchase.

Proof of purchase is required, this does not affect your statutory rights.

If you require further information about our products, call the Friedland

helpline on 01268 563066.

Friedland a Novar business, Novar ED&S, The Arnold Centre,

Paycocke Road, Basildon, Essex, SS14 3EA, England

www.friedland.co.uk

Trouble Shooting

Chime not Sounding

Chime may be positioned out of range of the bell push

Move your chime closer to the bell push

A metallic object may be blocking the signal from bell push

position



Experiment with the location of the chime to see if you can

move it in a more suitable place

The battery in the bell push may need replacing

Press the bell push. If the confidence light (B) flashes 5 times

after being pushed, replace the battery.

Note: In cold conditions, poor location or environment,

operating at maximum range it is advisable to replace the

battery more frequently before the indicator light flashes

(i.e every 12 - 18 months) to maintain optimum performance

Your bell push and chime haven't been programmed

Reset the automatic programming of your chime and bell push

Instructions

– Please retain these instructions for future reference

Especificaciones del producto

Marca:	Friedland
Categoría:	Timbre de la puerta
Modelo:	D417E - Evo 50m
Color del producto:	Zwart, zilver
Certificación:	IEC 60803, IEC 60352-2
Cantidad por paquete:	1 stuk(s)
Impedancia:	75 Ohm
Productos compatibles:	Tesca France Bengal
Tensión de funcionamiento:	50 V
Temperatura de funcionamiento (TT):	-30 - 85 °C
Conexión 1:	BNC
Conexión 1 tipo:	Mannelijk
Tipo-de-conección:	BNC
Resistencia de aislamiento:	5000 MΩ
Poder-de-retención:	30 N