Frigidaire MWBOK15TB Manual de Usario

Frigidaire No categorizado MWBOK15TB

Lee a continuación 📖 el manual en español para Frigidaire MWBOK15TB (15 páginas) en la categoría No categorizado. Esta guía fue útil para 7 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/15

Installation Bump-Out Kit

Instructions For 15” Deep Cabinets

BEFORE YOU BEGIN

Read these instructions completely and carefully.

IMPORTANT:

•

•Save these instructions for local inspector’s use.

•Observe all governing codes and ordinances.

•Note to Customer- Keep these instructions for future reference.

•Skill level- Installation of this appliance requires basic mechanical

and electrical skills.

•Proper installation is the responsibility of the installer.

•Product failure due to improper installation is not covered under

the Warranty.

Note to Installer –Be sure to leave these

instructions with the consumer.

TOOLS YOU WILL NEED

# 1 P hillips screwdriver Penci l

Ruler or t ape measure and

straight edge Carpenter square

(optional)

Ti n snips (for cutti ng

damper, i f required)

Electric drill with 3⁄16

“,1⁄2“and5⁄8“

drill bits

Hammer (opti onal)Stud finder or

Fi ll er blocks or scrap

wood pieces, i f ded nee

for top cabinet spacing

(used on recessed bott om

cabinet i nstallations only)

Gloves

Saw (saber, hole or keyhole)

Level Duct and masking t ape

Scissors

(to cut template, if necessary)

Safety goggles

MOUNTING SPACE NOTES:

•The bet ween the cabinet s must be

30“(76.2 cm) wi de and free of obstr uctions.

•If you are going to vent your microwave oven

to t he outside, see H ood Exhaust Section for

exhaust du ct p repar ati on .

•When installing the microwave oven beneath

smooth, f lat cabinets, be caref ul to f ollow the

instr uctions on the top cabinet template f or

power cord clearance.

Bottom Edge of

Cabinet Needs to

be 30 (76.2 cm)

or More from the

Cooki ng Surface

Backsplash

66 (167.6 cm)

or more from

the oor to the

30 (76.2 cm)

(5.1 cm)

(76.2 cm)

min.

161⁄2(41.9 cm)

Cabi netCabinet

NOTE: Maximum cabinet depth is 15

top of the

microwave

acesp

A06823408

NOTE: For BOK installation use hardware from over the range microwave unit which has 2 –

toogle bolts and 2 wood screws for mounting BOK. In addition, there are 2 toggle bolts in the

BOK to complete proper installation.

Bump out kit installs with Over the Range models

in which the serial number of the unit begins with

To verify proper unit, check the rating

label located on the inside of the doo r.

See below example:

KGXXXXXXX.

KGXXXXXXXX

XXXXXXXXXX XXXXXX

Bump-Out Kit

Bracket

IMPORTANT:



   

   

  

   

     

   

 

  

  

     

 



 

 

     

 

 





 













  



     

 

  

  

Rear wall template

Installation Instructions

DAMAGE SHIPMENT/INSTALLATION–

•If the unit is damaged in shipment, return the unit to the store in which it was bought for

repair or replacement

•If the unit is damaged by the customer, repair or replacement is the responsibility of the

customer

•If the unit is damaged by the installer (if other than the customer), repair or replacement

must be made by arrangement between customer and installer

•Move the top cabinet template that comes with your OTR microwave

2. ” forward when installing from bac wall.

•Use the rear wall template that comes with your OTR microwave to

identify mounting location for the bump out kit.

Move top cabinet template forward 2.2 ”

Mark lowest edge of bracket

Place the Bump Out Kit Bracket in place of rear wall template location making sure that the bottom edge lines up.

Installation Instructions

Find the studs, using one of the following methods:

A. Stud finder – a magnetic device which locates nails.

B. Use a hammer to tap lightly across the mounting

surface to find a solid sound. This will indicate a stud

location.

After locating the stud(s), find the center by probing

the wall with a small nail to find the edges of the stud.

Then place a mark halfway between the edges. The

center of any adjacent studs should be 16" or 24" from

this mark.

Draw a line down the center of the studs.

THE BUMP-OUT BRACKET MUST BE ED

AT LEAST ONE

WALL STUD.

FINDING THE WALL STUDS

PLACEMENT OF THE BUMP-OUT BRACKET

Wall Studs

Level line for front overhang

Center 3

Centerline

notches Draw a Vertical Line

on Wall from Center

of Top Cabinet

Draw a horizontal line on wall at the

bottom of “Rear Wall Template”.

Horizontal Line

3/8" T O ED GE

%#76+10Ä+(':*#756#&#2614+5 215+6+10'& 1765+&'

4'%1//'0&'&&+/'05+ 10)4'#5'Ä.#&'0#+49+..

&+5%*#4)'+061*175'5647%674'

/+0+/7 /9+&6*4'37+4'&

4'#49#..6'/2.#6'

NOTE: IT IS VERY IMP ORTANT TO

READ AND FOLLOW THE DIRECTI ONS

IN THE IN STALLATI ON IN STRUCTIONS

BEFORE PROCEEDI NG WITH THIS

REAR WALL TEMPL ATE.

This Re ar Wall Te mplate s erve s to pos ition the bottom

mounting pla te a nd to locate the horizo ntal exhaus t

outlet.

1. Use a level to check tha t the te mpla te is pos itione d

a ccura tely.

2. Loca te a nd mark at le as t one s tud on the left or

right s ide of the ce nterline.

016 '

It is important to us e a t lea s t one wood

s crew mounte d firmly in a stud to support the we ight

of the microwave. Ma rk two add itional, eve nly spa ced

locations for the supplied toggle bolts.

3. Drill ho les in the marke d locations . Where the re is

a st ud, drill a 3/16" hole for wood s crews . For holes

that do not line up with a st ud, drill 5/8" holes for

toggle bolts .

016 '

DO NOT INSTALL T HE MOUNT ING PLAT E

AT T HIS TIME.

4. Remove the template from the re ar wa ll.

5. Review the Ins ta llation Ins truction book for your

insta llation situation.

Locate and mark hole s to align with h oles in the

mounting plat e .

IM PORTANT:

LOCATE AT LEAST ONE STUD ON EITHER SIDE OF

THE CEN TERLINE.

MARK TH E LOCATION FOR 2 ADDITIONAL , E VENLY

SPACED TOGGLE BOLTS IN TH E MOUNTIN G PLATE

AREA.

Locate and mark holes to align with hol es in the

mounting plat e.

IM PORTANT:

LOCATE AT LEAST ONE STUD ON EITHE R SIDE OF

THE CEN TERLINE.

MARK TH E LOCATION FOR 2 ADDITIONAL , E VENLY

SPACED TOGGLE BOLTS IN THE M OUN TING PLATE

AREA.

T rim the rea r wall tem pla te a long the do tted lin e.

(%76176(14*14+<106#.

1765+&'':*#756

%76*1.'6*417)* 4'#4 9#.. (14':*#756#&#2614

12"

Darle vue lta a la ho ja p ara c onsult ar la

ve rs ión e n Es pa ñol.

Draw a vertical line on the wall at the center of the

30" wide space.

2Draw a horizontal line on the wall at the bottom of

“Rear Wall Template”.

MARK THE LOWEST EDGE OF BRACKET

INSTALL IN

Especificaciones del producto

Marca:	Frigidaire
Categoría:	No categorizado
Modelo:	MWBOK15TB

¿Necesitas ayuda?

Si necesitas ayuda con Frigidaire MWBOK15TB haz una pregunta a continuación y otros usuarios te responderán

Tu nombre*

Tu correo electrónico*

Escribe tu pregunta aquí

No categorizado Frigidaire Manuales

Frigidaire WOMC3TRIMWHT Manual de Usario

6 Octubre 2024

Frigidaire GMTK3068AD Manual de Usario

4 Octubre 2024

Frigidaire CFPWD15W Manual de Usario

3 Octubre 2024

Frigidaire GLGT1142FS Manual de Usario

3 Octubre 2024

Frigidaire GMTK2768AD Manual de Usario

2 Octubre 2024

Frigidaire IM115 Manual de Usario

22 Septiembre 2024

Frigidaire WOMC3TRIMBLK Manual de Usario

18 Septiembre 2024

Frigidaire GDPH4525AF Manual de Usario

17 Septiembre 2024

Frigidaire FFDI501CMS Manual de Usario

16 Septiembre 2024

Frigidaire FDSR4501AP Manual de Usario

14 Septiembre 2024

No categorizado Manuales

Últimos No categorizado Manuales

POLARIS RZR S 1000 EPS (2018) Manual de Usario

27 Octubre 2024

Workzone 20V Li-Ion Reciprocating Saw PT160501 Manual de Usario

27 Octubre 2024

Philips 43PUL7672 Manual de Usario

27 Octubre 2024

Manhattan 461504 Manual de Usario

27 Octubre 2024

Sungrow SG125HV Manual de Usario

27 Octubre 2024

Schneider CCT724319 Manual de Usario

27 Octubre 2024

Technoline WS 250 Manual de Usario

27 Octubre 2024

Livarno IAN 354423 Manual de Usario

27 Octubre 2024

Kupper 12152 Manual de Usario

27 Octubre 2024

JennAir CARBON24L Manual de Usario

27 Octubre 2024