GE Café CP9530SJSS Manual de Usario

GE horno Café CP9530SJSS

Lee a continuación 📖 el manual en español para GE Café CP9530SJSS (16 páginas) en la categoría horno. Esta guía fue útil para 7 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/16

Installation

Instructions

BEFORE YOU BEGIN

Read these instructions carefully and completely.

• IMPORTANT — Save these instructions

for local inspector’s use.

• IMPORTANT — Observe all governing

codes and ordinances.

• Note to Installer – Be sure to leave these

instructions with the consumer.

• Note to Consumer – Keep these instructions for

future reference.

• Product failure due to improper installation is not

covered under the Warranty.

• WARNING This appliance must be properly

grounded.

• ATTENTION INSTALLER

ALL COOKTOPS MUST BE HARD WIRED

(DIRECT WIRED) INTO AN APPROVED

JUNCTION BOX. A “PLUG AND RECEPTACLE”

IS NOT PERMITTED ON THESE PRODUCTS.

• Proper installation is the responsibility of the

installer and product failure due to improper

installation is NOT covered under warranty.

30 and 36”

Electric Cooktop - Radiant

Excludes Down-Draft Models

MATERIALS YOU WILL NEED

TOOLS NEEDED

CUTTING THE COUNTERTOP

If you are installing the cooktop in a solid surface

material such as granite, quartz or any other natural

or synthetic solid surface, we recommend that the

cutout be prepared by a professional cabinet or

countertop installer.

Cooktop cutouts in wood or wood-laminate

countertops may be able to be prepared using a

saber saw and electric drill.

PARTS INCLUDED

31-11072-3 11-18 GEA

Wire NutsJunction Box

Saber Saw

Pencil

Safety Glasses

1/8” Drill Bit & Electric or

Hand Drill

Ruler or Straightedge

Phillips Head

Screwdriver

2 Hold Down

Brackets

4 Screws

(WB01X1137)

Foam Tape

WB06K5042

90º or Straight

Squeeze Connector

for 1” Conduit

Questions? Call us at 1.800.432.2737 or visit GEAppliances.com.

In Canada, call 1.800.561.3344 or visit GEAppliances.ca.

231-11072-3

Installation Instructions

IMPORTANT SAFETY INSTRUCTIONS

FOR YOUR SAFETY

• For Personal Safety, remove house fuse or open

circuit breaker before beginning installation. Failure

to do so could result in serious injury or death.

• Be sure your cooktop is installed properly by a

qualified installer or service technician.

• To eliminate the risk of burns or fire due to reaching

over heated surface elements, cabinet storage

located above the surface units should be avoided.

If cabinet storage space is to be provided, the risk

can be reduced by installing a range hood that

projects horizontally a minimum of 5" beyond the

bottom of the cabinets. Cabinet installation above

the cooktop may be no deeper than 13".

• Make sure the cabinets and wall coverings around

the cooktop can withstand the temperatures (up to

200°F) generated by the cooktop.

• The cooktop should be easy to reach and lighted

with natural light during the day.

• Always disconnect the electrical service to the

cooktop before repairing or servicing the cooktop.

This can be done by disconnecting the fuse or

circuit breaker. Failure to do this could result in a

dangerous or fatal shock. Know where your main

disconnect switch is located. If you do not know,

have your electrician show you.

ELECTRICAL REQUIREMENTS

This appliance must be supplied with the proper

voltage and frequency, and connected to an individual,

properly grounded branch circuit, protected by a circuit

breaker or a time delay fuse as noted on name plate

and the chart below.

We recommend you have the electrical wiring and

hookup of your cooktop connected by a qualified

electrician. After installation, have the electrician show

you where your main cooktop disconnect is located.

Wiring must conform to National Electrical Code. You

can get a copy of the National Electrical Code, ANSI/

NFPA No. 70-Latest Edition, by writing to:

National Fire Protection Association

Batterymarch Park

Quincy, MA 02269

The cooktop conduit wiring is approved for copper

wire connection only, and if you have aluminum house

wiring, you must use special UL approved connectors

for joining copper to aluminum.

You must use a two-wire, three conductor 208/240

VAC, 60 Hertz electrical system. A white (neutral)

wire is not needed for this unit. The cooktop must be

installed in a circuit that does not exceed 125 VAC

nominal to ground.

Refer to the name plate on your cooktop for the KW

rating for your cooktop.

Use the chart below to determine the minimum

recommended dedicated circuit protection:

Name plate location

KW Rating 240v KW Rating 208V

Recommended

Circuit Size

(Dedicated)

.: .: 20 Amp

4.9 KW - 7.2 KW 4.2 KW - 6.2 KW 30 Amp

7.3 KW - 9.6 KW 6.3 KW - 8.3 KW 40 Amp

9.7 KW - 12.0 KW 8.4 KW - 10.4 KW 50 Amp

31-11072-3 3

Installation Instructions

PRE-INSTALLATION CHECKLIST

WARNING The electrical power to the

cooktop supply line must be shut off while

connections are being made. Failure to do so

could result in serious injury or death.

A When preparing cooktop opening, make sure

the inside of the cabinet and the cooktop do

not interfere with each other. (See section on

preparing the opening.)

B Remove packaging materials and literature

package from the cooktop before beginning

installation.

C Be sure to place all literature, Owner’s Manual,

Installations, etc. in a safe place for future

reference.

D Make sure you have all the tools and materials

you need before starting the installation of the

cooktop.

E Your home must provide the adequate electrical

service needed to safely and properly use

your cooktop. (Refer to section on electrical

requirements.)

F When installing your cooktop in your home, make

sure all local codes and ordinances are followed

exactly as stated.

G Make sure the wall coverings, countertop and

cabinets around the cooktop can withstand heat

(up to 200°F) generated by the cooktop.

H Installing cooktop in combination

with other products.

Both products must be installed according to

their specific product installation instructions.

Consideration must be given the separate

electrical requirements and locations:

Over one or two wall ovens:

• Only certain models may be installed over wall

ovens. The wall oven and cooktop will both

have a label stating which models are approved

in combination.

Over a Microwave:

• See microwave installation instructions for how

to install a microwave under a cooktop. For

vertical dimension of cooktop, see Approximate

Cooktop Dimensions section.

In combination with telescopic downdraft vent:

• See telescopic downdraft vent instructions for

how to install a vent behind a cooktop.

• The countertop must have a deep flat surface

to accommodate the combined installation of

the cooktop and vent.

Over a warming drawer:

• See warming drawer instructions for how to

install a warming drawer under a cooktop. For

vertical dimension of cooktop, see Approximate

Cooktop Dimensions section.

HOT

Cooktop

Foam

Packaging

Literature Package

(Located under unit)

Especificaciones del producto

Marca:	GE
Categoría:	horno
Modelo:	Café CP9530SJSS
Color del producto:	Metallic, White
Peso.:	10500 g
Ancho:	358 mm
Profundidad:	221 mm
Altura:	353 mm
Tipo de enchufe:	Type C
Longitud del cable:	1.15 m
Peso del embalaje:	11500 g
Ancho del embalaje:	406 mm
Empaquetadura en profundidad:	273 mm
Altura del embalaje:	413 mm
Amable:	Staande mixer
Material de la carcasa:	Zink
Fácil de limpiar:	Ja
Número de velocidades:	10
Bandeja extraíble:	Ja
Activos:	275 W
Contenido contenedor/lata:	4.3 l
Velocidad variable:	Ja
Interruptor encendido / apagado:	Ja
Piezas aptas para lavavajillas:	Ja
Panel de control de colores:	Wit
Pies antideslizantes:	Ja
Material:	Metaal
Material del cuenco:	Roestvrijstaal
Cantidad por paquete:	1 stuk(s)
botón turbo:	Nee
jardín:	Ja
tipo de dispositivo:	Mixer
Accesorios aptos para lavavajillas:	Ja
Contenido:	4.28 l
Velocidad de rotación:	220 RPM
Planeetomwenteling:	Ja
batidores:	Ja
Funciones del mezclador:	Beat, Knead, Mixing, Stirring
Cuenco suministrado:	Ja
ganchos para masa:	Ja
voltaje-de-entrada-de-CA:	220 - 240 V
Frecuencia-de-entrada-de-CA:	50/60 Hz
Tipo de motor:	AC