GE DNCK440EAWC Manual de Usario

GE secadora DNCK440EAWC

Lee a continuación 📖 el manual en español para GE DNCK440EAWC (3 páginas) en la categoría secadora. Esta guía fue útil para 13 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/3
GE Appliances
DNCK440EA/GA—GE Commercial Smart Card Electric Dryer
R
Listed by
Underwriters
Laboratories
Specification Revised 2/02
Dryer Dimensions (in inches)
Exhaust Options:
Electric: 4-way via rear, right, left and bottom. Maximum recommended exhaust duct length
is 45 feet of 4” rigid ducting with two 90° elbows and a 4” dampered wall cap.
Gas: When viewed from the front of the unit, exhaust 3-way via rear, left and bottom.
Maximum recommended exhaust duct length is 15 feet of 4 rigid ducting with two 90” °
elbows and a 4 dampered wall cap.
Circuit Requirements:
An individual, properly-grounded branch circuit, protected by a 30-amp circuit breaker or a
time-delay fuse, is required.
Electric Dryer Rating:
208/240V, 5600W, 24A, 60Hz
208V, 4400W, 22A, 60Hz
A special 208 volt heater, part # WE11X0101 is avaialable to reduce drying time in
208 volt installations.
Gas Circuit Requirements: An individual branch circuit fused for 15- or 20-amp is required
for each dryer.
Gas Dryer Rating: 115V; 60Hz
Gas (BTU/Hr): 22000. Factory equipped for natural gas. tested for LP gas. A conversion Kit is
required for LP gas.
Note: Dryer wall outlet must be located within 36" of service cord entry and accessible
when dryer is mounted in position.
Installation Information: For complete information, see installation instructions packed
with your dryer.
36 42
27
23-1/2
2-1/2
25-1/2*
Side View Rear View
5-1/4
25-3/4
23-1/2
11-1/2
*24-1/2" from the edge of the side panel to the front.
25-1/2" from front to edge of endcaps.
For answers to your Monogram,
® GE Profileor
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center®service, 800.626.2000.
GE Appliances
Specification Revised 2/02
DNCK440EA/GAGE Commercial Smart Card Electric Dryer
Features and Benefits
Super 7.0 Cu. Ft. Capacity
3 Dry Cycles: High Heat; Medium Heat; Low Heat
4 Heat Selections
Cool Down (with High Heat Cycle)
ESD Smart Card Reader with Alphanumeric Display and Control Card
Digital Cycle Countdown with LED Indicators
Quiet Package
Lockable Lint Filter
Reversable Door Swing
DuraDrumInterior
Model DNCK440EAWCWhite
Model DNCK440GAWCWhite
GE Appliances
Specification Revised 2/02
DNCK440EA/GAGE Commercial Smart Card Electric Dryer
Dryer Exhausting Information Use Metal Duct OnlyFor complete information, see installation instructions packed with your dryer.
Ducting Materials:
For best performance, this dryer should be vented with 4 diameter all rigid metal exhaust duct. If ” “all rigid metal
duct cannot be used, then flexible all metal“ ” venting can be used, but it will reduce the maximum recommended
duct length.
Exhaust Length Calculation:
1. Determine the number of 90°turns needed for your installation. If you exhaust to the side
or bottom of dryer, add one turn.
2. The maximum length of 4 rigid (aluminum or galvanized) duct which can be tolerated is shown
in the table. The maximum length for flexible ducts are less than for rigid duct.
A turn of 45°or less may be ignored. Two 45 elbow. A°turns within the duct length should be treated as a 90°
turn over 45 should be treated as a 90° ° elbow.
Exhausting the dryer to the outside is strongly recommended to prevent large amounts of moisture and
lint from being blown into the room. Gas dryers or any dryer located in a closet must be exhausted to the outside.
Caution: For personal safety do not terminate exhaust into a chimney, under any enclosed
house floor (crawl space), or into an attic, since the accumulated lint could create a fire hazard
or moisture could cause damage. Never terminate the exhaust into a common duct or plenum with a kitchen
exhaust, since the combination of lint and grease could create a fire hazard.
Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird nesting, etc. The wall
cap must also be located at least 12 above the ground or any other obstruction with the opening pointed Down.
Other terminations, such as louvered wall boxes, are acceptable provided they are equivalent to a 4 opening
dampered wall cap.
For more information on venting kits and accessories, please call 1-800-GE-CARES.
Special Installation Requirements
Alcove or Closet Installation:
If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.
The dryer MUST be exhausted to the outside.
Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:
0 either side
3 front and rear
• ” Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52 .
Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of open area
equally distributed. If this closet contains both a washer and a dryer, doors must contain a minimum of 120 sq. in.
of open area equally distributed.
The closet should be vented to the outdoors to prevent gas pocketing in case of a gas leak in the supply line.
No other fuel-burning appliance shall be installed in the same closet with the dryer.
Bathroom or Bedroom Installation:
The dryer MUST be exhausted to the outdoors.
The installation must conform with the local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI
Z223.
Minimum Clearances other than Alcove or Closet Installation:
Minimum clearances to combustible surfaces
0 both sides
3 rear
R
Listed by
Underwriters
Laboratories
4
B
2-1/2
A
0 90 ft. 60 ft. 55 ft. 45 ft.
1 60 ft. 45 ft. 40 ft. 30 ft.
Super & Extra-Large 2 45 ft. 35 ft. 30 ft. 20 ft.
6.0 Capacity Models 3 35 ft. 25 ft. 20 ft. 15 ft.
All Electric Dryers 4 25 ft. 15 ft. 15 ft. 10 ft.
0 45 ft. 30 ft. 30 ft. 15 ft.
Super & Extra-Large 1 35 ft. 20 ft. 20 ft. 10 ft.
6.0 Capacity Models 2 25 ft. 10 ft. 10 ft.
All Gas Dryers 3 15 ft.
0 60 ft. 48 ft. 30 ft. 18 ft.
1 52 ft. 40 ft. 22 ft. 14 ft.
Extra-Large 5.7 2 44 ft. 32 ft. 14 ft. 10 ft.
Capacity Electric 3 32 ft. 24 ft.
and Gas Dryers 4 28 ft. 16 ft.
Number
of
90°
Turns
Maximum Length of 4"
Dia. Rigid Metal Duct
Maximum Length of 4"
Dia. Flexible Metal Duct
Exhaust Hood Type Exhaust Hood Type
Domestic
Dryer Models
A
4" Opening
B
2-1/2"
Opening
A
4" Opening
B
2-1/2"
Opening
Best Performance
For answers to your Monogram,
® GE Profileor
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center®service, 800.626.2000.

Especificaciones del producto

Marca: GE
Categoría: secadora
Modelo: DNCK440EAWC

¿Necesitas ayuda?

Si necesitas ayuda con GE DNCK440EAWC haz una pregunta a continuación y otros usuarios te responderán




secadora GE Manuales

secadora Manuales

Últimos secadora Manuales