GE GP94ENSRSA Manual de Usario

GE Calderas y calderas GP94ENSRSA

Lee a continuación 📖 el manual en español para GE GP94ENSRSA (24 páginas) en la categoría Calderas y calderas. Esta guía fue útil para 10 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/24
1
49-50230-1 03-08 JR
Installation Outdoor Tankless Water Heater
Instructions Models GN75ENSRSA, GN94ENSRSA, GP94ENSRSA
Questions? Call 888-HOTWTER (888.468.9837) or Visit our website at ge.com
BEFORE BEGINNING INSTALLATION
Read these instructions completely and carefully.
IMPORTANT Save these instructions
for local inspector’s use.
IMPORTANT Observe all governing
codes and ordinances.
Be sure to leave theseNote to Installer
instructions with the Consumer.
Keep these instructionsNote to Consumer –
for future reference.
Proper installation is the responsibility of the
installer.
Product failure due to improper installation
is not covered under the Warranty.
Recognize this symbol as an indication of
Important Safety Information!
WARNING: Read entire manual. Failure to follow all guides and rules could cause personal
injury or property damage.
Check with your state and/or local public works department for plumbing codes. You must follow their
guides as you install the Water Heater.
NOTE: Failure to comply with these installation instructions will void the product warranty, and the
installer will be responsible for any service, repair or damages caused thereby.
SAFETY PRECAUTIONS
WARNING: If the information in these
instructions is not followed exactly, a fire or explosion
may result, causing property damage, personal injury
or death.
FOR YOUR SAFETY!
Do not store or use gasoline or other
flammable vapors or liquids or other
combustible materials in the vicinity of this or
any other appliance. To do so may result in an
explosion or fire.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch;
do not use any phone in your building.
Immediately call your gas supplier from a
neighbors phone. Follow the gas suppliers
instructions.
If you cannot reach your gas supplier,
call the fire department.
Do not return to your home until authorized
by the gas supplier or fire department.
Improper installation, adjustment, alteration,
service or maintenance can cause property
damage, personal injury or death. Refer to
this manual. Installation and service must
be performed by a qualified installer, service
agency or the gas supplier.
Service information and wiring diagram are
located behind front panel.
Service must be performed by a qualified
service agency.
This appliance must be properly grounded and
installed as described in these instructions
.
FOR OUTDOOR APPLICATIONS ONLY
Installation Instructions
2
SAFETY PRECAUTIONS (cont.)
WARNING: Gasoline, as well
as other flammable materials and liquids
(adhesives, solvents, paint thinners, etc.) and
the vapors they produce, are extremely
dangerous. DO NOT handle, use or store gasoline
or other flammable or combustible materials
anywhere near or in the vicinity of a water
heater or any other appliance. Be sure to read
and follow the labels on the water heater, as well
as the warnings printed in this manual. Failure
to do so can result in property damage, bodily
injury or death.
WARNING: Do not use substitute
materials. Use only parts certified with the
appliance.
This appliance must be installed, inspected and
leak tested by a state- and city-qualified licensed
contractor. It is the responsibility of the person
having the water heater installed to ensure the
installing contractor has proper licenses and
permits for installing water heaters in your
location. GE highly recommends that installers
attend a product knowledge class to ensure
customer satisfaction and warranty coverage.
Failure to comply with state and local codes
pertaining to water heater installations may
void the warranty.
This appliance is not to be installed indoors.
The installation must conform with local codes or,
in the absence of local codes, with the National
Fuel Gas Code, ANSI Z223.1/NFPA 54, or the
Natural Gas and Propane Installation Code,
CSA B149.1.
The appliance and its appliance main gas valve
must be disconnected from the gas supply piping
system during any pressure testing of that
system at test pressures in excess of 1/2 psi
(3.5 kPa) (13.84 in W.C.).
SAFETY PRECAUTIONS (cont.)
The appliance must be isolated from the gas
supply piping system by closing its individual
manual shut-off valve during any pressure
testing of the gas supply piping system at test
pressures equal to or less than 1/2 psi (3.5 kPa)
(13.84 in W.C.).
The appliance should be located in an area
where water leakage of the unit or connections
will not result in damage to the area adjacent
to the appliance or lower floors of the structure.
When such locations cannot be avoided,
it is recommended that a suitable drain pan,
adequately drained, be installed under the
appliance. The pan must not restrict combustion
airflow.
The flow of combustion and ventilation air shall
not be obstructed.
This appliance is not suitable for use in an
application such as a pool or spa heater that
uses chemically treated water. (This appliance is
suitable for filling large or whirlpool bath tubs
with potable water.)
If a water heater is installed in a closed-water
supply system, such as one having a backflow
preventer in the cold water supply line, means
shall be provided to control thermal expansion.
Contact the water supplier or local plumbing
inspector on how to control this situation.
Should overheating occur or the gas supply fail
to shut off, turn off the manual gas control valve
to the appliance.
Keep the air intake location free of chemicals,
such as chlorine or bleach, that produce fumes.
These fumes can damage components and
reduce the life of your appliance.
CAUTION: DO NOT operate the water
heater if any part of the appliance has been under
water.
CAUTION: BURN HAZARD. Hot exhaust
and vent may cause serious burns. Keep back from
water heater unit. Keep small children and animals
away from unit.
CAUTION: Hot Water outlet pipes leaving
unit can be hot to touch. Insulation must be used
for hot water pipes below 36 due to burn risk to
children.
WARNING: This unit is not intended
or qualified for use in manufactured homes, mobile
homes or recreational vehicles.
DANGER
Read and follow water heater warnings and
instructions. If owner’s manual is missing, contact
the retailer or manufacturer.
3
Installation Instructions
TOOLS YOU WILL NEED
Pipe Wrenches (2) Gloves
Adjustable Pliers Safety Glasses
Screwdrivers (2)
Wire Cutters
MATERIALS YOU WILL NEED TO SUPPLY
Soap Solution 3/4 Pipe Fittings
Pipe Compound Required:
5/8 ID PVC Flexible – Unions
Tubing – Ball Valves
2 Conductor 22 AWG – Drain Valves
Wire for Remote – Pressure Relief Valve
Control
Single Gang Electrical Box
Wire Nuts
Outdoor Rated Switch and Enclosure
Concrete Wall Anchors (Optional)
Your installation components may vary.
PARTS PROVIDED
Locate the parts packed with the Water Heater.
Gas Valve
3/4 FNPT Ball Valve
4 #10 x 114
Wood Screws
OTHER TOOLS THAT MIGHT BE REQUIRED
Hammer Drill with Concrete Bits
• Saw
Threading Machine with Heads and Oiler
Core Drill with Diamond Head
Torch Set
Copper Tubing Cutter
Steel Pipe Cutter
OTHER MATERIALS THAT MIGHT BE NEEDED
Heat Tape
Pipe Insulation
Electrical Wire and Conduit per Local Code
Air Inlet Screen
Optional Pipe Cover AGTPCM
Optional Additional Remote Controller AGTRC1
Remote
Control

Especificaciones del producto

Marca: GE
Categoría: Calderas y calderas
Modelo: GP94ENSRSA

¿Necesitas ayuda?

Si necesitas ayuda con GE GP94ENSRSA haz una pregunta a continuación y otros usuarios te responderán




Calderas y calderas GE Manuales

Calderas y calderas Manuales

Últimos Calderas y calderas Manuales