GE TPK6 Manual de Usario

GE Refrigerador TPK6

Lee a continuación 📖 el manual en español para GE TPK6 (3 páginas) en la categoría Refrigerador. Esta guía fue útil para 10 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/3

TOOLS YOU WILL NEED

Installation Custom Panel Trim Kit

Instructions TPK6 (Use with GE Model

GMR06AAPBB, Black Model only)

Nutdriver Phillips head screwdriver

FOR YOUR SAFETY:

WARNING –Unplug the refrigerator

before installing the trim kit.

PARTS INCLUDED

Plastic frame Plastic wood panel retainers

(weight limitation for custom panels:

5 lbs. max.)

Installation Instructions

Self-threading screws (4)

MATERIALS YOU WILL NEED

A consumer-supplied laminated plastic or

wood panel must be used with this kit.

Thin Panel (recommended):

Use a commonly available, heat and scratch

resistant laminated plastic panel cut to the

following dimensions:

•Thickness – 3/32″or less

•Width – 223⁄4″

•Length – 291⁄2″

Weight limitation for custom panels is

5 lbs. max.

1/4″Wood Panel (not recommended):

Use of a 1/4″wood panel is not recommended,

because wood’s tendency to warp may cause

the trim kit to come off from the door. A thin

plastic panel is recommended whenever

possible.

See 1/4″Wood Panel Installation for instructions

on installing a wood panel.

197D4679P002

49-60287

06-03 JR

Printed in China

INSTALL THE TRIM KIT

Loosely reinstall the handle using the five

screws previously removed.

Lay the consumer-supplied panel on top

of the door and slide the panel up under

the handle, making sure it is centered

from side to side.

Peel off the paper strip from the top

section of the plastic frame, exposing

the adhesive tape.

Position the top of the frame over the top

of the door. Check to make sure the top of

the frame is positioned so that it slightly

overlaps the handle. Press down firmly.

PREPARE REFRIGERATOR FOR

TRIM KIT

Carefully lay the refrigerator on its back as

shown. Make sure the refrigerator door is

clean and dry to ensure proper adhesion

of the tape on the trim kit frame.

Remove the screws and leveling leg

attaching the bottom hinge to the

refrigerator.

Open the door and pull the door away

from the top hinge.

Lay the door on a flat surface facing up.

Remove the handle by removing the five

screws.

Panel centered

on door side to

side as shown

Screws

INSTALL THE TRIM KIT (CONT.)

Starting at the bottom of one side of the

frame, peel off the paper strip from the

adhesive tape as shown.

Then starting at the top of the side of the

frame, press the frame onto the side of the

door, letting the top flange of the trim rest

on the front of the door as a guide.

If the frame attaches to the door and is not

installed correctly, you can pull it loose and

try again. The adhesive does not set to its

complete holding strength right away.

Repeat on opposite side.

Take the remaining frame section and

attach it to the bottom of the door. Using

the 4 self-threading screws supplied in the

kit, secure the bottom frame to the door.

With the refrigerator still on its back, lay

the door on top of the refrigerator and

slide the door up so that the hinge pin

goes into the top hinge hole on the door.

Make sure the door is lined up with the

side of the cabinet, then reattach the

bottom hinge. Stand the refrigerator

upright and make sure the door opens

and closes correctly.

1/4″WOOD PANEL INSTALLATION

Cut 1/4″wood panel to size as shown.

Panel should be stained, finished and dry.

Lay it face down on a flat surface.

Frame the wood panel with the plastic

retainer pieces as shown. Fit the corners

and apply masking tape to secure the

wood panel and retainer strips together

as one piece.

Remove the door (see Prepare Refrigerator

for Trim Kit steps 1, 2 and 3).

Insert the wood panel into the door frame

(see Prepare Refrigerator for Trim Kit steps 4

and 5 and Install the Trim Kit).

283/4″

221/4″

Wide side

of flange

to outside

of frame

Tape

Flat surface

Wide

flange

Narrow

flange

Finished side

of panel

1/4″ Wood panel

Especificaciones del producto

Marca:	GE
Categoría:	Refrigerador
Modelo:	TPK6
Color del producto:	Meerkleurig
Peso del embalaje:	214 g
Ancho del embalaje:	191 mm
Empaquetadura en profundidad:	262 mm
Altura del embalaje:	46 mm
Edad recomendada (máx.):	99 jaar
Edad recomendada (mín.):	6 jaar
Tipo de embalaje:	Doos
País de origen:	China
Material:	Kunststof
Género propuesto:	Jongen/meisje
Se requieren baterías:	Nee
Numero de piezas:	179 stuk(s)
Efectos de sonido compatibles:	Nee
se requiere ensamblaje:	Ja
Baterias-incluidas:	Nee
Tipo-producto:	Bouwpakket
Advertencia de TSD de la UE:	No warning applicable, Not for children under 36 months
SAL:	B09BNXLZMY