Glem Gas M965GI Manual de Usario

Glem Gas horno M965GI

Lee a continuación 📖 el manual en español para Glem Gas M965GI (33 páginas) en la categoría horno. Esta guía fue útil para 5 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/33

INSTRUCTIONS BOOKLET

NOTICE D’UTILISATION

p.2

p.22

p.43

Cookers

| 5

YOUR PRODUCT

Given the wide range of products available on the market, this booklet contains information about several models,

and it is therefore possible that not all of the information contained here in refers to your appliance or its accessories.

We are nevertheless at your disposition for any clarication you may require.

Your cooker consists of the following main parts:

• hob: at top part where the pan supports (supports for the pots), the gas burners, electric plates or the glass-

ceramic areas, depending on the size and the model of your cooker are located.

• : control panel cooker control devices zone (i.e. knobs and switches).

• oven door

SYMBOL MEANING

Burner / front left area

Burner / rear left area

Central burner

Burner / front right area

Burner / rear right area

Burner / left area

Oven temperature control (°C)

Timer / minute minder

SYMBOL MEANING

Multi-function electric oven features

Oven thermostat

Gas oven burner

Grill burner

Light button

Ignition button (spark)

Ventilated gas button (Multichef)

These two pilot lights indicate that the

electric oven is on and/or that the oven is

heating up.

HOW TO IDENTIFY THE SYMBOLS ON THE CONTROL PANEL

USE

HOB

USING THE HOB

If your cooker has a glass lid, make sure it is lifted open before turning on the burners, during use and the

subsequent cooling phase. Failure to do so may cause the breakage of the glass.

TURNING ON THE GAS BURNER

Place a lit match near the burner (or a spark or a ame generator), press and turn the corresponding knob counter-clockwise

to the MAX position. The hob can be equipped with electrical ignition activated through a separate button or by pressing

the knob. When it is lit, hold the knob down for approximately 10 seconds, then release it and adjust ame intensity, being

careful to position the knob in the area between maximum and minimum (included) and never between maximum and zero

to prevent turning it off unexpectedly. The burner may go out when you release the knob: this means that the thermocouple

is not hot enough. If it does not ignite within 15 seconds, wait 1 minute before trying again. If your model does not have a gas

safety valve (copper-coloured thermocouple near the burner), please check that, at regular intervals, the ame does not go out

due to possible liquid overowing from the pots during cooking.

USE OF ELECTRIC PLATES

The electrical plates are switched on by turning the knob clockwise, at a value between 0 and 4.

The higher the number, the greater the applied electrical power. By turning a plate on for the rst time or after a long period

of inactrivity, it is advisable to make it run idle without cooking on it, on the “minimum heating” position (position 1) for at least

15 minutes, so as to eliminate any humidity that the insulation may have absorbed. To optimize the use of electric plates, use

at-bottomed pots and avoid using pots with diameters smaller than the plates.

USING GLASS-CERAMIC HOBS (HIGHLIGHT)

Please refer to the booklet supplied with the appliance.

PREVENTING HOME ACCIDENTS

Do not leave the appliance unattended when cooking with fats or oil: it may cause a re.

Do not leave objects near the cooking surfaces.

If glass ceramic hobs crack, turn the appliance off to prevent possible electric shock.

8 | EN

PROGRAMMERS AND MINUTE MINDERS

MINUTE MINDER

The minute minder is switched on by turning the knob clockwise to the end of its run, in order to load the mechanism, then

counter-clockwise to set the required time. The time is expressed in minutes, a bell will let you know when the previously-set

minutes are up.

COOKING-END MECHANICAL TIMER (only in models with an electric oven)

This mechanical timer, in addition to sounding the bell, also acts as a switch, by switching off the power. It is different from the

minute minder because the ring nut around the knob (washer), in addition to indicating the minutes, also has the symbol of

a hand. To set it, turn the knob to the end of its run, in order to load the mechanism, then turn it in the opposite direction to

set the required time. If you wish to turn the oven on without setting any time, position the knob on the ‘hand’ symbol in the

manual position.

3 KEYS OF THE DIGITAL TIMER (g. 3 - page 8)

• Set the time: press the timer on/off button (bell) immediately followed by the + or – key to adjust the time. Once it has been

set, the time will automatically be set after 10 sec.

• Use the timer: to set the cooking time, press the + or – key until you reach the required amount of time (between 1 and 99

minutes). When the timer is on, it will appear on the screen. When the time is up, the timer will start ringing. To turn it off,

press the timer on/off key (bell).

• set the timer at 1 minute and when you hear the bell, press the - key to change the volume.

ELECTRONIC TIMER (g. 4 - page 8)

• Set the clock: when the oven is first connected, or after a power failure, ‘0.00’ will flash on the display. To set the clock, push

the middle set button and the (+) or (-) buttons immediately to the disered time. The time of day will be saved after 10

seconds.

• Use the timer: It can be set for a maximum period of 99 minutes and minimum of 10 seconds. To set the timer just push the

(+) or (-) button until you have set the required in minutes and seconds.

• When the timer is operating the timer on indicator will be lit. Once the pre-set time has elapsed, the timer will beep Push the

SET button switch Off. The (-) button can also be uset to change the volume of the beep.

TOUCH PROGRAMMER (g. 5 - page 8)

The touch programmer can work in 3 modes:

- MINUTE MINDER: once the time is set the timer will start counting down until it is up, and a bell will ring.

- AUTOMATIC END-COOKING: when the time is up, the oven will switch off and a bell will ring (only in models with electric ovens).

- DELAYED START: by setting the cooking time and the switch off time, the oven will start and stop automatically.

• Keyboard freeze: the programmer is equipped with automatic keyboard freeze after 7 seconds of inactivity. To unfreeze it,

press any key for 2 seconds.

• Set the programmer time: hold the + and - keys down at the same time until the central cursor between the hour and minutes

starts flashing. Then press + or - to set the time. Once you have reached the time you need to set, do not press any other key,

and after a few seconds a beep will confirm the set time.

• Setting the count down (minute minder feature): the minute minder operates separately from the oven, and can be used for

all cooking features. Hold the “Menu” key down until the screen changes. Release the key and adjust the time (minutes) by

using the + and - keys. Once you reach the required time, release the key and wait for the confirmation beep. A bell icon will

appear on the screen. At the end of the minutes, the bell will ring. Press any key to turn it off. To remove the bell icon from

the screen, press the “Menu” key. To check the remaining amount of time (before it expires), hold the “Menu” key down. To

delete the set amount of time, press the “Menu” key until the screen changes, and then press the + and - keys at the same

time. The set amount of times will thus be deleted.

• Setting Auto Power Off (only for electric ovens): turn the oven on by adjusting features and temperatures. Hold the “Menu”

key down until the screen changes, then press it again. The letters “DUR” (for ‘duration’) will appear on the screen. Press the

+ and - keys to adjust the cooking time. Wait for the confirmation beep without touching any keys. When the set amount of

time is over, the oven will switch off and the beeping sound will be set off. Press any key to turn it off. To remove the bell icon

from the screen, press the “Menu” key. To check the remaining amount of time (before it is over) hold the “Menu” key down.

To delete the set amount of time, press the “Menu” key until the screen changes, and then press the + and - keys at the same

time. Accordingly, the set amount of times will be deleted. At the end of cooking, remember to place the knob back to the

“0” position.

• Setting delayed start (only for electric ovens): hold the “Menu” key down until the screen changes, then press it again. The

letters ‘’DUR’’ (for ‘duration’) will appear on the screen. Press the + and - keys to adjust the cooking time. Then press the

“Menu” key once and the letters END will appear on the screen, indicating the menu to set the switch-off time. Press the +

and - keys to adjust the switch-off time. Then select the cooking feature and required temperature. Obviously the oven will

not start up immediately. Once the set amount of time has passed, the oven will switch off and the beep sound will start. Press

any key to turn it off. To remove the bell icon from the screen, press the “Menu” key.

• Setting the volume: press + and - at the same time, followed by “Menu”, to enter the tone setting mode and press the – key

repeatedly to change the tone of the alarm. Once you have selected the tone, the timer will memorize your selection until

you wish to change it again. Practical tips when using the programmer: please consider the amount of time for heating the

oven when the cooking time is being set. Please switch the oven off at the end of the cooking cycles.

ANALOGUE CLOCK with hands (g. 6)

• Setting the time: pull the rod (F) and turn clockwise until you have set the current time. When it is set, put the rod back in its

initial position.

• Setting the cooking time: turn the rod (without pulling it) (F) clockwise and set the required minutes on the clock disk set at

“9” (E). The maximum amount of time is 3 hours. When the time is over, a bell will ring. It will turn off automatically after three

minutes. If you wish to turn it off manually, turn the rod clockwise until you see E, 0 or a crossed-out bell on the disk and in

the E box.

• Setting the manual feature: Turn the rod clockwise to position I or to exclude the minute minder.

Especificaciones del producto

Marca:	Glem Gas
Categoría:	horno
Modelo:	M965GI

¿Necesitas ayuda?

Si necesitas ayuda con Glem Gas M965GI haz una pregunta a continuación y otros usuarios te responderán

Tu nombre*

Tu correo electrónico*

Escribe tu pregunta aquí

horno Glem Gas Manuales

Glem Gas UN8612EI Manual de Usario

26 Octubre 2024

Glem Gas UN6611RI Manual de Usario

26 Octubre 2024

Glem Gas UN664EI Manual de Usario

21 Octubre 2024

Glem Gas MQB612VI Manual de Usario

5 Octubre 2024

Glem Gas GS965GG Manual de Usario

28 Septiembre 2024

Glem Gas UN765GGEI Manual de Usario

27 Septiembre 2024

Glem Gas GV75TXBK Manual de Usario

16 Septiembre 2024

Glem Gas GA965GEXMB Manual de Usario

13 Septiembre 2024

Glem Gas GV64TXBK Manual de Usario

12 Septiembre 2024

Glem Gas GFXV21BK-S2 Manual de Usario

10 Septiembre 2024

horno Manuales

Últimos horno Manuales

Continental Edison CECM6065W Manual de Usario

27 Octubre 2024

Taurus HM778WHD Manual de Usario

27 Octubre 2024

Lacanche CITEAUX Manual de Usario

27 Octubre 2024

JennAir JDS1450FS Manual de Usario

27 Octubre 2024

Orima ORP-76-IN Manual de Usario

27 Octubre 2024

Breville the Handy Hot Plate BHP150 Manual de Usario

27 Octubre 2024

JennAir JGRP436HL Manual de Usario

27 Octubre 2024

Neff C17MS22G1 Manual de Usario

27 Octubre 2024

Pit Boss BK24 Manual de Usario

27 Octubre 2024

Guzzanti GZ-8206 Manual de Usario

27 Octubre 2024