Honeywell CT3300 Manual de Usario

Lee a continuación 📖 el manual en español para Honeywell CT3300 (24 páginas) en la categoría Termostato. Esta guía fue útil para 9 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/24
MagicStat® CT3300 Programmable Thermostat
Installation and Programming Instructions
Welcome to the world of comfort and energy savings
with your new Honeywell MagicStat® Programmable
Thermostat. Your new thermostat will automatically
control the temperature in your home, keeping you
comfortable while saving energy.
If you have any questions about using this thermostat,
visit our home expert Web site at
www.honeywell.com/yourhome or call Honeywell
Customer Relations at 1-800-468-1502.
®U.S. Registered Trademark
Copyright © 2001 Honeywell • All Rights Reserved
Weekday/Weekend (5-day/2-day)
Programmable Heat and/or Cool
Low Voltage (20 to 30 Vac)
Thermostat and Mounting Plate
Model CT3300
Table of Contents
Installation 2
Programming 11
Operation 17
Change the clock for Daylight/
Standard Time
17
Set the Fan and System switches 17
Replace the batteries 18
Override the program settings 19
Frequently asked questions 22
Limited 1-Year Warranty 24
69- 0654- 5
2INSTALLATION 69-0654-5
Installation
Verify that you have the right thermostat
Make sure that the CT3300 is the right thermostat for your heating/cooling system. Read the compatibility chart below to
determine which system you have. If your system is not compatible with the CT3300, the table recommends an alternate
Honeywell model. If you are unsure what type of thermostat is right for your system, visit us on the Web at
www.honeywell.com/yourhome or call Honeywell Customer Relations at 1-800-468-1502.
Heating/cooling system
Compatible
with CT3300?
Alternate
model
Conventional
Single stage systems that include warm air furnaces and hot water.
Yes
Electric Baseboard
Electric powered heating strips located just above the floor, usually 120 to 240 volts.
No CT1950 for
240 volts
Steam
A steam boiler with radiator heat.
No CT3600
Heat Pump
Heating and cooling are produced from the same outdoor unit (compressor) with no
auxiliary or backup heat.
No CT3600
Multistage Heat Pump
Heating and cooling are produced from the same outdoor unit (compressor) with
auxiliary or backup heat.
No CT3611
Multistage Conventional
A heating or cooling system with more than one stage.
No See your
contractor
Recycling thermostat
If you are removing an old thermostat that contains mercury in a
sealed tube (Fig. 1), do not place the old thermostat in the trash.
Contact your local waste management authority for instructions
regarding recycling and the proper disposal of the old thermostat.
Fig. 1
M3701
MERCURY
SWITCH
69-0654-5 INSTALLATION 3
Step 1. Prepare for installation
a. Carefully unpack your new thermostat. Save your receipt and make sure you have the following parts:
b. Gather the needed tools and supplies listed below.
c. Make sure that your heating and cooling systems are working properly. If there is a problem with either system, call a
heating/air conditioning contractor—the problem may persist after you install the new thermostat.
Required tools and supplies Optional tools
Two AA alkaline batteries. Honeywell recommends
Energizer® batteries.
• Screwdriver
Hand or power drill with 3/16-inch or 7/32-inch drill bit
• Pencil
Wire cutter/stripper or sharp knife
• Level
Electrical tape
IMPORTANT: To avoid damaging the compressor in the air conditioner, do not operate the cooling system when the
temperature outdoors is below 50°F (10°C).
Thermostat and mounting plate
• Labels
Screws and anchors
Installation and Programming Instructions

Especificaciones del producto

Marca: Honeywell
Categoría: Termostato
Modelo: CT3300

¿Necesitas ayuda?

Si necesitas ayuda con Honeywell CT3300 haz una pregunta a continuación y otros usuarios te responderán




Termostato Honeywell Manuales

Termostato Manuales

Últimos Termostato Manuales