Hooker 5820-75411-84 Manual de Usario

Hooker Silla 5820-75411-84

Lee a continuación 📖 el manual en español para Hooker 5820-75411-84 (2 páginas) en la categoría Silla. Esta guía fue útil para 4 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/2
1/2
ASSEMBLY INSTRUCTION
Item#: 5820- 11-84 754 Upholstered Back Arm Chair
** Please make sure you have all parts indicated below prior to assembly.
Assembly Steps:
There are two K/D chairs in one box. Please follow numbers on one chair and letters on the other chair
during assembly.
1. Place chair back on a clean surface.
2. Attach seat frame (L) chair back (J) by using bolt (E), lock washer (B) , flat washer (C) at the to
center location T , tighten seat frame (L) to chair back (J) and tighten by Allen Wrench(D). hen by
using bolts (A lock washers flat washers (C) and secured by using wrench (D) ), (B), allen at
corners (See diagram 1).
3. Attach front legs (I) seat frame ) by using bolts (A), lock washers (B) ,flat washers (C) to (L and
tighten by wrench (D) at corners (See diagram 1). allen
4. After all bolts are attach upright. ed and hand tightened, turn the chair
5. Make sure the chair is level and then tighten all bolts completely using wrench (D). by allen
Diagram 1
2/2
PLEASE READ THESE INSTRUCTIONS PRIOR TO ASSEMBLING THE
CHAIRS
CHAIR LEVELING INSTRUCTION SUPPLEMENT
Chair leveling procedures:
To make the assembly process easy and efficient, please read the entire instruction sheet prior to
assemb of the chair. Make sure all hardware listed is included. To properly assemble the chair, none of ling
the bolts should be fully tightened until all components are attached to the chair. This will allow an
opportunity to level the chair and prevent any unnecessary “rocking”.
1. Place the loosely assembled chair on a hard flat surface.
2. Apply gentle downward pressure on the seat. This step eliminates rocking and ensures the chair to
be level.
3. Once the chair is level, tighten all bolts and nuts.
Note:
Most floors have slight irregularities that can affect chair leveling. If your chair is uneven when placed
in its desired location, perform the following steps:
1. Loosen front legs to finger tight.
2. Extend both front legs ward to their fullest length. up
3. Gently push downward on the front edge of the seat until all four legs rest on the floor.
4. -tighten all bolts and nuts. Re
Cleaning Instruction: Clean finished parts with a damp cloth using a mild dishwashing liquid and water solution.
Polish the finish with soft cloth and an industry recognized furniture polish.

Especificaciones del producto

Marca: Hooker
Categoría: Silla
Modelo: 5820-75411-84

¿Necesitas ayuda?

Si necesitas ayuda con Hooker 5820-75411-84 haz una pregunta a continuación y otros usuarios te responderán




Silla Hooker Manuales

Silla Manuales

Últimos Silla Manuales