Hoover HL C8DF-80 Manual de Usario

Hoover secadora HL C8DF-80

Lee a continuación 📖 el manual en español para Hoover HL C8DF-80 (10 páginas) en la categoría secadora. Esta guía fue útil para 10 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/10
2.
DRAIN HOSE : FITTING INSTRUCTIONS
FOR TANK IN DOOR DRAWER
To avoid emptying the water container after
each drying cycle, the water can be discharged
directly to a waste water drain pipe (the same
drainage system as household sinks). Water
Bye-Laws prohibit connection to a surface
water drain. The waste water drain pipe should
be located adjacent to the tumble dryer.
The kit consists of:1 hose and 1 tap.
WARNING! Switch off and remove the
tumble dryer plug from the electricity supply
before carrying out any work.
Fit he s Follows:t Hose a
1.Tilt the machine
backwards.
2. The waste water
pipe is situated at the
right-hand side of the
machine (see the
picture). A grey hose
connects to the bridge
at the left hand side of
the machine. Using
pliers, remove the
pipe retaining clip
from the bridge.
3. Pull the hose off the
bridge connection.
4. Attach the black
hose from the kit,
( using the connector
a n d p i p e c l i p s
supplied , to the hose )
removed from the
bridge connection.
5 . P l a c e t h e t a p
supplied by the kit to
close the remaing
hose.
Connect the new drain
hose to the waste
black w ater pipe .
6. Once the machine is
in place, check the
bottom to ensure that
the new hose does not
kink when pushing the
tum bl e d ry er into
position.
Connect to the mains
electricity supply.
8
1
2
3
4
5
6
water kit is suitable only on models with the
water tank on the door.
NOTE:
The direct drain condensed
5.
WATER CONTAINER
The water removed from the laundry during the drying cycle is collected in a container inside the
door of the dryer. When the container is full the indicator on the control panel will light, and
the container MUST be emptied. However, we recommend that the container is emptied after each
drying cycle.
NOTE: Very little water will collect during the first few cycles of a new machine as an internal
reservoir is filled first.
To remove the container
tank in door drawer
To remove the container
bottom water drawer
1. Gently pull out the
water container holding
the handle. (A)
When it is full the
water container will
weigh about 6 kg.
2. T i l t t h e w a t e r
container to empty the
water out through the
spout. (B)
When empty, replace
the water container
back as shown; f(C) irst
insert the base of the
container into position
as shown then (1)
gentle push the top into
position (2).
3. Press to Button
restart the cycle.
NOTE: If you have the
option of drainage near
to the dryer you can use
the discharge kit to
provide a permanent
drainage for the water
c o l l e c t e d i n t h e
container of the dryer.
This means that you
don't have to empty the
water container.
A
B
1C
10
1.Gently pull the bottom
of the kickplate so that it
unclips from the dryer.
The top section can
t hen b e u nh i ng e d
allowing the kickplate to
b e c o m p l e t e l y
removed. (A)
2.Pull firmly on the
handgrip and slide the
water container out of
the dryer. ( )B
Support the container
w i t h b ot h h a n d s .
(C)When full, the water
container will weigh
about 4kg.
3. Open the lid located
on the top of the
container and empty
the water.(D)
4. Refit the lid and slide
the water container
back into position. (D)
PUSH FIRMLY INTO
PLACE.
5. Refit the kickplate by
engaging the hinges at
the top and 'snapping'
the lower clips into
place.
A
B
C
D

Especificaciones del producto

Marca: Hoover
Categoría: secadora
Modelo: HL C8DF-80

¿Necesitas ayuda?

Si necesitas ayuda con Hoover HL C8DF-80 haz una pregunta a continuación y otros usuarios te responderán




secadora Hoover Manuales

secadora Manuales

Últimos secadora Manuales