Hotpoint Aqualtis AQ8F 492 U Manual de Usario

Hotpoint Wasmachines Aqualtis AQ8F 492 U

Lee a continuación 📖 el manual en español para Hotpoint Aqualtis AQ8F 492 U (72 páginas) en la categoría Wasmachines. Esta guía fue útil para 6 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/72

English,1

Contents

Installation, 2-3

Unpacking and levelling

Connecting the electricity and water supplies

Technical data

Description of the machine, 4-5

Control panel

Running a wash cycle, 6

Wash cycles and options, 7

Table of wash cycles

Wash options

Detergents and laundry, 8

Detergent

Preparing the laundry

Washing recommendations

Load balancing system

Precautions and advice, 9

General safety

Disposal

Opening the porthole door manually

Care and maintenance, 10

Cutting off the water and electricity supplies

Cleaning the machine

Cleaning the detergent dispenser drawer

Caring for your appliance drum

Cleaning the pump

Checking the water inlet hose

Trouble shooting, 11

Assistance, 12

WASHING MACHINE

AQUALTIS

AQ8F 492 U

Instructions for

installation and use

Português,25

Español,13

Deutsch,37

Français,49

Nederlands,61

! If the appliance is levelled correctly, it will be more stable

and much less likely to cause vibrations and noise while it

is operating, particularly during the spin cycle.

! If it is placed on carpet or a rug, adjust the feet in such a

way as to allow a sufficient ventilation space underneath

the washing machine.

Connecting the electricity and water

supplies

Connecting the water inlet hose

! Before connecting the inlet hose to the water supply, run

the water until it is perfectly clear.

1. Connect the inlet hose

to the machine by screwing

it onto the cold water inlet

of the appliance, which is

situated on the top right-

hand side of the rear part of

the appliance . (see figure)

2. Connect the inlet hose

by screwing it to a cold

water tab using a 3/4 gas

threaded connection (see

figure).

3. Make sure that the hose is not folded over or bent.

! The water pressure at the tap must fall within the values

indicated in the Technical data table (see next page).

! If the inlet hose is not long enough, contact a specialised

shop or an authorised technician.

! Never use second-hand or old inlet hoses; use the

products supplied with the machine.

! This instruction manual should be kept in a safe place

for future reference. If the washing machine is sold, given

away or moved, please ensure the manual is kept with

the machine, so that the new owner may benefit from the

advice contained within it.

! Read these instructions carefully: they contain vital

information relating to the safe installation and operation of

the appliance.

! Inside the pack containing this manual, you will also find

the guarantee and all the details necessary for installation.

Unpacking and levelling

Unpacking

1. Once you have removed all the packaging from the

washing machine, make sure it has not been damaged

during transportation.

If it has been damaged, contact the retailer and do not

proceed any further with the installation process.

2. Remove the 4 protective

screws (used during

transportation) and the

corresponding spacer,

located on the rear part of

the appliance ( ). see figure

3. Close off the holes using the plastic plugs supplied in the

pack.

4. Keep all the parts in a safe place; they will be needed

again if the washing machine is moved to another location,

to prevent the inside of the appliance being damaged.

! Packaging materials should not be used as toys for

children.

Levelling

1. Place the washing machine on a flat sturdy floor, without

resting it up against walls or cabinets.

2. If the floor is uneven, the

front feet of the machine

may be adjusted until

it reaches a horizontal

position (the angle of

inclination must not exceed

2 degrees).

Installation

Technical data

Model AQ8F 492 U

Dimensions

width 59.5 cm

height 85 cm

depth 64,5 cm

Capacity from 1 to 8 kg

Electrical

connections

please refer to the technical data plate

fixed to the machine

Water connections

maximum pressure 1 MPa (10 bar)

minimum pressure 0.05 MPa (0.5 bar)

drum capacity 62 litres

Spin speed up to 1400 rotations per minute

Energy rated

programmes

according to

regulation

2010/1061

programme ; temperature 60°C and

40°C.

This appliance conforms to the following

EC Directives:

- 2004/108/EC (Electromagnetic Compa-

tibility)

- 2006/95/EC (Low Voltage)

- 2002/96/EC

65 - 100 cm

Connecting the drain hose

Connect the drain hose to

drain duct piping or a wall

drain located between 65

and 100 cm above the floor,

making sure it is not bent

at all.

Alternatively, rest the

drain hose on the side of

a washbasin or bathtub,

fastening the duct supplied

to the tap (see figure).

The free end of the hose

should not be underwater.

! We advise against the use of hose extensions; if it is

absolutely necessary, the extension must have the same

diameter as the original hose and must not exceed 150 cm

in length.

Electrical connections

Before plugging the appliance into the electricity socket,

make sure that:

• thesocketisearthedandcomplieswithallapplicable

laws;

• thesocketisabletowithstandthemaximumpowerload

of the appliance as indicated in the Technical data table

(see opposite);

• thepowersupplyvoltagefallswithinthevaluesindicated

in the Technical data table (see opposite);

• thesocketiscompatiblewiththeplugoftheappliance.

If this is not the case, have the socket or the plug

replaced.

! The appliace must only be installed indoor in a frost free

and dry room, to prevent it from electronic damage due to

frost or condensation.

! The mains socket must remain within easy reach after the

washing machine has been installed.

! Do not use extension cords or multiple sockets.

! The cable should not be bent or compressed.

! The power supply cable and plug must only be replaced

by authorised technicians.

Warning! The company shall not be held responsible in the

event that these regulations are not respected.

Especificaciones del producto

Marca:	Hotpoint
Categoría:	Wasmachines
Modelo:	Aqualtis AQ8F 492 U
Colocación del dispositivo:	Vrijstaand
Tipo de operación:	Touch
Pantalla incorporada:	Ja
Peso.:	49572 g
Ancho:	600 mm
Profundidad:	600 mm
Altura:	845 mm
Impuesto neto:	2400 W
Número de cubiertos:	13 couverts
Sistema de secado:	Warmtewisselaar
Color de la puerta:	Wit
Longitud del cable:	1.75 m
Temporizador de inicio retrasado:	Ja
Retraso del inicio:	24 uur
Indicación de tiempo restante:	Ja
Bloqueo infantil:	Nee
Tapa removible:	Ja
control wifi:	Ja
Duración del ciclo:	295 min
Nivel de ruido:	44 dB
Clase-de-eficiencia-energética:	D
Peso del embalaje:	51000 g
Adecuado para ajuste de panel:	Nee
Consumo de agua por ciclo:	9.5 l
Actual:	10 A
Clase de emisión de ruido:	B
Número de programas de lavado:	6
Consumo de energía por 100 ciclos.:	84 kWu
Pies ajustables:	Ja
Profundidad cuando la puerta está abierta.:	1155 mm
Reunión del producto:	Volledige grootte (60 cm)
Panel de control de colores:	Zwart
Tipo de compartimento Bestek:	Mand
Material de carenado:	Roestvrijstaal
Ajuste de pies:	20 mm
asistente de dosificación:	Ja
Número de ajustes de temperatura:	4
Función AquaStop:	Ja
Función AquaSensor:	Ja
Glasbescherming:	Ja
medio cargado:	Ja
Sensor de carga:	Ja
Programas de lavado:	60min 65°C, Auto 45-65°C, Eco 50°C, Intensive 70°C, Pre-wash, Quick 45°C
Consumo de energía por ciclo:	0.92 kWu
Longitud de la manguera de drenaje:	1.9 m
Longitud de la manguera de suministro de agua:	1.65 m
Cesta superior regulable en altura:	Ja
Temperatura (máx.):	70 °C
Altura bajo encimera:	30 mm
Colocación ajustable de cestas.:	Lower, Upper
Consumo de energía (mantenerlo encendido):	0.5 W
Consumo de energía (cuando está apagado):	0.5 W
Descalcificador de agua incorporado:	Ja
voltaje-de-entrada-de-CA:	220 - 240 V
Frecuencia-de-entrada-de-CA:	50/60 Hz
Escala de eficiencia energética:	A tot G