HQ Power Astar III Manual de Usario
HQ Power
Maquina de efectos
Astar III
Lee a continuación 📖 el manual en español para HQ Power Astar III (31 páginas) en la categoría Maquina de efectos. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios
Página 1/31

VDPL300HD
ASTAR III - LED TRIPLE DERBY - DMX-CONTROLLED
ASTAR III - TRIPLE DERBY - DMX-GESTUURD
ASTAR III - TRIPLE DERBY - PILOTAGE DM X
ASTAR III - DOBLE DERBY – CONTROL DMX
ASTAR III - TRIPLE DERBY - DMX-GESTEUERT
USER MANUAL 2
GEBRUIKERSHANDLEIDING 7
NOTICE D’EMPLOI 12
MANUAL DEL USUARIO 17
BEDIENUNGSANLEITUNG 25

VDPL300HD
V. 02 – 03/01/2013 2 ©Velleman nv
USER MANUAL
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device should be returned to your
distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing HQPower™! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
Keep this device away from rain and moisture.
Unplug the mains lead before opening the housing.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
• A qualified technician should install and service this device.
• Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the
device against damage by leaving it switched off until it has reached room temperature.
• This device falls under protection class I. It is therefore essential that the device be earthed. Have a
qualified person carry out the electric connection.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if
necessary.
• Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug
only.
• Do not look directly at the light source as sensitive people may go into epileptic seizure if they do.
• Note that damage caused by user modifications to the device is not covered by the warranty.
• Mechanical wear and the LEDs are not covered by warranty.
• Keep the device away from children and unauthorised users
3. General Guidelines
• Indoor use only. Keep this device away from rain, moisture, splashing and dripping liquids.
• This device is designed for use on stage, in discos, theatres, etc.
• Lighting effects are not designed for permanent operation: regular operation breaks will prolong their lives.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device is protected against extreme heat, dust and moisture. Respect a
minimum distance of 0.5m between the device’s light output and any illuminated surface.
• Use an appropriate safety cable to fix the device (e.g. VDLSC7 or VDLSC8).
• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by
unqualified people. Any damage that may occur will most probably be due to unprofessional use of the
device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.

VDPL300HD
V. 02 – 03/01/2013 3 ©Velleman nv
4. Features
• multi-coloured effect to cover complete room
• DMX controlled by 8 channels
• auto mode, sound activated or master/slave mode
• built-in microphone for sound activation
5. Overview
1 LED display
2 DMX input
3 DMX output
4 Built-in
microphone
5 Fuse holder
6 IEC cord input
6. Installation
a. Mounting the device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without
deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used… Have the material and the device itself checked regularly. Do not attempt to install
the device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
b. Fuse replacement
Only fit or replace a fuse when the device is unplugged from the mains.
Replace a blown fuse with a fuse of the same type and rating (see “Technical Specifications”):
1. Remove the fuse holder using a flat-head screwdriver.
2. Remove the old fuse and install a new one.
3. Put back the fuse holder.
7. Operation
The device can be used in the following modes:
• Standalone mode (with the built-in microphone)
• Master-slave
• With a DMX512 controller
Especificaciones del producto
Marca: | HQ Power |
Categoría: | Maquina de efectos |
Modelo: | Astar III |
¿Necesitas ayuda?
Si necesitas ayuda con HQ Power Astar III haz una pregunta a continuación y otros usuarios te responderán
Maquina de efectos HQ Power Manuales

3 Septiembre 2024

3 Septiembre 2024

2 Septiembre 2024

2 Septiembre 2024

2 Septiembre 2024

2 Septiembre 2024

2 Septiembre 2024

2 Septiembre 2024

2 Septiembre 2024

2 Septiembre 2024
Maquina de efectos Manuales
- Maquina de efectos Manta
- Maquina de efectos BeamZ
- Maquina de efectos Velleman
- Maquina de efectos American DJ
- Maquina de efectos Steren
- Maquina de efectos Adj
- Maquina de efectos Behringer
- Maquina de efectos NGS
- Maquina de efectos Valcom
- Maquina de efectos Midas
- Maquina de efectos Elation
- Maquina de efectos QTX
- Maquina de efectos Konig
- Maquina de efectos Valueline
- Maquina de efectos Fredenstein
- Maquina de efectos Chauvet
- Maquina de efectos Showtec
- Maquina de efectos Eurolite
- Maquina de efectos Monoprice
- Maquina de efectos Elysia
- Maquina de efectos Antari
- Maquina de efectos Stairville
- Maquina de efectos Black Lion Audio
- Maquina de efectos Laserworld
- Maquina de efectos Monacor
- Maquina de efectos Martin
- Maquina de efectos Drawmer
- Maquina de efectos ColorKey
- Maquina de efectos JB Systems
- Maquina de efectos Evo-Lite
- Maquina de efectos Blizzard
- Maquina de efectos Hazebase
- Maquina de efectos Cameo
- Maquina de efectos Sagitter
- Maquina de efectos DJPower
- Maquina de efectos Doepfer
- Maquina de efectos Fun Generation
- Maquina de efectos Karma
- Maquina de efectos Lotronic
- Maquina de efectos IMG Stage Line
- Maquina de efectos Lexicon
- Maquina de efectos Futurelight
- Maquina de efectos The Confetti Maker
- Maquina de efectos Eliminator Lighting
- Maquina de efectos BoomTone DJ
- Maquina de efectos Klark Teknik
- Maquina de efectos Lab Gruppen
- Maquina de efectos TCM FX
- Maquina de efectos Magmatic
- Maquina de efectos Technical Pro
- Maquina de efectos Rosco
- Maquina de efectos Showven
Últimos Maquina de efectos Manuales

18 Octubre 2024

10 Octubre 2024

8 Octubre 2024

6 Octubre 2024

3 Octubre 2024

2 Octubre 2024

2 Octubre 2024

1 Octubre 2024

30 Septiembre 2024

29 Septiembre 2024