Indesit DFG 26B1 S UK Manual de Usario

Indesit lavavajillas DFG 26B1 S UK

Lee a continuación 📖 el manual en español para Indesit DFG 26B1 S UK (8 páginas) en la categoría lavavajillas. Esta guía fue útil para 10 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/8

APPLIANCE

PRODUCT DESCRIPTION

1. Upper rack

2. Foldable aps

3. Upper rack height adjuster

4. Upper spray arm

5. Lower rack

6. Cutlery basket

7. Lower spray arm

8. Filter Assembly

9. Salt reservoir

10. Detergent and Rinse Aid dispensers

11. Rating plate

12. Control panel

DAILY REFERENCE

GUIDE

CONTROL PANEL

Before using the appliance carefully read Health and Safety guide.

THANK YOU FOR BUYING A INDESIT PRODUCT.

In order to receive a more complete assistance, please

You can download the Safety Instructions and the

Use and Care Guide, by visiting our website

docs.indesit.eu and following the Instructions on the

back of this booklet.

0000 000 00000

Service:

1. On-O/Reset button

2. Program selection knob

3. Short Time button and indicator light

4. Delayed Start button and indicator light

5. Indicator light Washing and Delayed Start 3h

6. Indicator light Drying and Delayed Start 6h

7. Indicator light Wash Cycle Complete and Delayed Start 9h

8. Start/Pause button and indicator lights

9. Rinse Aid rell indicator light

10. Salt rell indicator light

1 32 4 765 1098

FIRST TIME USE

SALT, RINSE AID AND DETERGENT

ADVICE REGARDING THE FIRST TIME USE

After installation, remove the stoppers from the racks and the reta-

ining elastic elements from the upper rack.

FILLING THE SALT RESERVOIR

The use of salt prevents the formation of LIMESCALE on the dishes and

on the machine’s functional components.

• It is important that the salt reservoir be never empty.

• It is important to set the water hardness.

TThe salt reservoir is located in the lower part of the dishwasher (see

PRODUCT DESCRIPTION) and should be lled when the SALT REFILL in-

dicator light in the control panel is lit.

1. Remove the lower rack and unscrew the

reservoir cap (anticlockwise).

2. -Only the rst time you do this: ll the salt re

servoir with water.

3. Position the funnel (see gure) and ll the salt

reservoir right up to its edge (approximately

1 kg); it is not unusual for a little water to leak out.

4. Remove the funnel and wipe any salt residue

away from the opening.

Make sure the cap is screwed on tightly, so that no detergent can get

into the container during the wash program (this could damage the

water softener beyond repair).

Whenever you need to add salt, it is mandatory to complete the

procedure before the beginning of the washing cycle.

SETTING THE WATER HARDNESS

To allow the water softener to work in a perfect way, it is essential that

the water hardness setting is based on the actual water hardness in

your house. This information can be obtained from your local water

supplier.

The factory setting is for average (3) water hardness.

• Switch on the appliance by pressing the button.ON/OFF

• Switch o the appliance by pressing the button.ON/OFF

• Hold down button START/PAUSE for 5 seconds, until you hear a beep.

• Switch on the appliance by pressing the button.ON/OFF

• The salt indicator light ashes (as many times as the current selection.)

• Set the to the desired hardness level PROGRAM SELECTION knob

number (see WATER HARDNESS TABLE).

• Switch o the appliance by pressing the button.ON/OFF

Setting is complete!

As soon as this procedure is complete, run a program without loading.

Only use salt that has been specically designed for dishwashers.

After the salt has been poured into the machine, the SALT REFILL indi-

cator light switches o.

If the salt container is not lled, the water softener and the

heating element may be damaged as a result.

Water Hardness Table

Level °dH

German degrees

°fH

French degrees

1 Soft 0 - 6 0 - 10

2 Medium 7 - 11 11 - 20

3 Average 12 - 17 21 - 30

4 Hard 17 - 34 31 - 60

5 Very hard 35 - 50 61 - 90

FILLING THE RINSE AID DISPENSER

Rinse aid makes dish DRYING easier. The rinse aid dispenser should A

be lled when the RINSE AID REFILL indicator light in the control

panel is lit.

1. Open the dispenser B by pressing and pulling up the tab on the lid.

2. Pour in the rinse aid (max.110 ml), making sure it does not overow

from the dispenser. If this happens, clean the spill immediately with

a dry cloth.

3. Press the lid down until you hear a click to close it.

NEVER pour the rinse aid directly into the appliance tub.

ADJUSTING THE DOSAGE OF RINSE AID

If you are not completely satised with the drying results, you can ad-

just the quantity of rinse aid used.

• Switch the dishwasher on using the button.ON/OFF

• Switch it o using the button.ON/OFF

• Press button

START/PAUSE

three times - a beep will be heard.

• Switch it on using the button.ON/OFF

• The rinse-aid indicator light will ash as many times as the level that

was set.

• Set the level of rinse aid quantity to be supplied using the

PROGRAM SELECTION knob (see PROGRAMS TABLE).

• Switch it o using the button.ON/OFF

Setting is complete!

If the rinse aid level is set to (ECO), no rinse aid will be supplied1 . The

LOW RINSE AID indicator light will not be lit if you run out of rinse aid.

A maximum of 4 levels can be set according to the dishwasher model.

The factory setting is specic to the model, please follow instruction

above to check this for your machine.

• If you see bluish streaks on the dishes, set a low number (2-3).

• If there are drops of water or limescale marks on the dishes, set a

mid-range number (4-5).

FILLING THE DETERGENT DISPENSER

To open the detergent dispenser use the opening device A.

Introduce the detergent into the dry dispenser B only. Place the

amount of detergent for pre-washing directly inside the tub.

1. When measuring out the detergent

refer to the mentioned earlier infor-

mation to add the proper quantity.

Inside the dispenser there are B

indications to help the detergent

dosing.

2. Remove detergent residues from

the edges of the dispenser and clo-

se the cover until it clicks.

3. Close the lid of the detergent

dispenser by pulling it up until the

closing device is secured in place.

The detergent dispenser automatically opens up at the right time

according to the program.

ECO program data is measured under laboratory conditions according to European Standard EN 50242.

Note for Test Laboratories: for information on comparative EN testing conditions, please send an email to the following address:

assistenza_en_lvs@indesitcompany.com

Pre-treatment of the dishes is not needed before any of the programs.

*) Not all options can be used simultaneously.

**) The duration of the program shown on the display or in the booklet is an estimate calculated on standard conditions. The actual time may vary

depending on many factors such as temperature and pressure of the incoming water, room temperature, amount of detergent, quantity and type of load,

load balancing, additional selected options and sensor calibration. The sensor calibration can increase program duration up to 20 min.

Standby consumption: Left-on mode consumption: 5 W - O mode consumption: 0.5 W

Program

Drying

phase

Available

options *)

Detergent

container Duration

of wash

program

(h:min)**)

Water

consumption

(litres/cycle)

Energy

consumption

(kWh/cycle)

Tub B

1Eco 50° 3:20 12.0 1.04

2Intensive 65° - 2:30 15.0 1.50

3Normal 55° - 2:00 15.0 1.35

4Fast 50° - - 0:55 11.5 1.10

5Express 40’ 50° - - 0:40 9.0 0.90

6Half Load 50° - 1:20 12.0 1.10

PROGRAMS TABLE

PROGRAMS DESCRIPTION

Instructions on wash cycle selection.

1 ECO

Normally soiled crockery. Standard program, the most ecient in

terms of its combined energy and water consumption.

2 INTENSIVE

Program recommended for heavily soiled crockery, especially suitable

for pans and saucepans (not to be used for delicate items).

3 NORMAL

For normally soiled dishes with dried food residues..

4 FAST

Normally soiled crockery. Everyday cycle, that ensures optimal cleaning

performance in shorter time.

5 EXPRESS 40’

Program to be used for lightly-soiled dishes with no dried food resi-

dues.

6 HALF LOAD

Ideal for washing a half load of lightly or normally soiled crockery.

Notes:

Please note that cycles like Express or Fast are most eective for lightly

soiled dishes.

To reduce consumption even further, only run the dishwasher

when it is full.

Especificaciones del producto

Marca:	Indesit
Categoría:	lavavajillas
Modelo:	DFG 26B1 S UK
Color del producto:	Wit
Amable:	IP-beveiligingscamera
Código de seguridad internacional (IP):	IP67
Formatos de vídeo soportados:	MPEG
factor vorm:	Rond
Soporte de colocación:	Buiten
Tecnología de conectividad:	Bedraad
red LAN:	Ja
Método de montaje:	Plafond/muur
Modos de vídeo compatibles:	1080p
Resolución Máxima:	1920 x 1080 Pixels
Número total de megapíxeles:	2 MP
Formatos de compresión de vídeo:	H.264
Diámetro:	67.8 mm
Tipo de fuente de energía:	Power over Ethernet (PoE)
Iluminación mínima:	0.1 Lux
Número de cámaras:	1
Lector de tarjetas de memoria integrado:	Ja
Tarjetas de memoria compatibles:	MicroSDHC, MicroSDXC
Disco duro incorporado:	Nee
Vision nocturna:	Ja
tipo LED:	IR
Longitud de onda infrarroja:	1100 nm
Cifrado HTTPS:	Ja
Número de puertos Ethernet LAN (RJ-45):	1
Certificación:	CE, FCC
Full HD:	Ja
Tamaño del sensor óptico:	1/2.8 "
Estabilizador de imagen:	Ja
Tipo de sensor de imagen:	CMOS
Velocidad de obturación de la cámara:	1/10000 s
Tipo cámarasluiter:	Elektronisch
Protección-de-contraseña:	Gebruiker
Resoluciones de gráficos compatibles:	320 x 240,640 x 480 (VGA),1280 x 720 (HD 720),1920 x 1080 (HD 1080)
navegador web:	Ja
Reducción de ruido:	Ja
Estándar de red:	IEEE 802.1x
Longitud:	146.43 mm
Funciones de seguridad:	Vandaalbestendig
Máximo 30 cuadros por segundo:	60 fps
Protocolos de red compatibles:	Pv4/v6, TCP, UDP, DHCP, PPPoE, HTTP, HTTPS, DNS, DDNS, NTP, RTP, RTSP, RTCP, SMTP, FTP, IGMP, ICMP, ARP, Bonjour, UPnP, QoS, SNMP
Gestión basada en web:	Ja
filtro de dirección IP:	Ja
Exploración progresiva:	Ja
Relación señal-ruido:	56 dB
Alimentación a través de Ethernet (PoE):	Ja
yo codifico:	IK10
Número de líneas de televisión:	1100
Modo día/noche:	Ja
Método de transmisión:	Multicast
Vídeo transmitido en vivo:	Ja
Sensor de movimiento:	Ja
A prueba de la intemperie:	Ja
Alcance de visión nocturna:	30 m
Ver remotamente:	Ja
control de velocidad de bits:	Constant Bit Rate (CBR), Variable Bit Rate (VBR)
Amplio rango dinámico (WDR):	Ja
tasa-de-bits:	128Kbps - 12Mbps
Wifi.:	Nee
Consumo de energía (típico):	4.34 W
Temperatura de funcionamiento (TT):	-40 - 50 °C
Humedad relativa de funcionamiento (VV):	10 - 85 procent
Sensor-de-luz:	Ja
Ajuste de la velocidad de obturación:	Automatisch/handmatig
Máscara zona privada:	Ja
Funciones del sistema de videovigilancia inteligente (IVS):	Face detection, Missing object
Ángulo de visión de la lente, horizontal:	99 °
Tipo de notificación de alerta:	E-mail, Snapshot alert message, Text alert message
Amplio rango dinámico digital (DWDR):	Ja
Interfaz de montura de lente:	Boardaansluiting
Ángulo de visión de la lente, vertical:	52.8 °
Vasto foco:	Ja
Reducción de ruido 3D:	Ja
Control de ganancia automática:	Ja
Iris:	Ja