Indesit ID60C2(K)S Manual de Usario

Indesit horno ID60C2(K)S

Lee a continuación 📖 el manual en español para Indesit ID60C2(K)S (28 páginas) en la categoría horno. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/28
ID60C2 S
Contents
Introduction, 2
Installation, 3
Safety Information, 4
Features, 6
Control Panel, 7
Clock/Minute Minder Operation, 8-9
Temperature Conversion Chart, 10
Ceramic Hob, 11-12
Grill, 13
Guide to Grilling, 14
Top Oven Cookery Notes , 15
Main Oven Cookery Notes, 16
Oven Temperature charts, 17-18
Care and Cleaning, 19-20
Cooking Results Not Satisfactory?, 21
Something Wrong With Your Cooker?, 22
If it Still Won't Work..., 23
Disposal of the appliance, 23
Guarantee Information, 24
Service Information, 25
You must read these instructions prior to using
your appliance and retain them for future use.
Operating Instructions
Free Standing Electric Cooker
GB
English, 1
GB
ID60C2 AA
2
GB
Your new appliance is guaranteed* and will give
lasting service.This guarantee is only applicable if
the appliance has been installed in accordance with
the installation instructions detailed in this booklet.
To help make best use of your cooking equipment,
please read this booklet carefully.
The cooker is designed specifically for domestic use
and responsibility will not be accepted for use in any
other installation.
When the cooker is first used an odour may be
emitted, this will cease after a period of use.
When first using the cooker ensure that the room is
well ventilated (e.g. open a window or use an
extractor fan) and that persons who may be
sensitive to the odour avoid any fumes.
It is suggested that any pets be removed from the
room until the smell has ceased. This odour is due
to temporary finish on oven liners and elements and
also any moisture absorbed by the insulation.
* The guarantee is subject to the provisions that
the appliance:
(a) Has been used solely in accordance with the
Users Instruction Book.
(b) Has been properly connected to a suitable
supply voltage as stated on the rating plate
attached to this equipment.
(c) Has not been subjected to misuse or accident
or been modified or repaired by any person other
than the authorised employee or agent.
(d) Has been correctly installed.
This appliance conforms with the followingThis appliance conforms with the following
This appliance conforms with the followingThis appliance conforms with the followingThis appliance conforms with the following
European Economic Community directives:European Economic Community directives:
European Economic Community directives:European Economic Community directives:
European Economic Community directives:
- 2006/95/EC EC
EC EC
EC of 12/12/06 (Low Voltage) and
subsequent modifications;
- 2004/108/ECECECECEC of 15/12/04 (Electromagnetic
Compatibility) and subsequent modifications;
- 2002/96/ECECECECEC
- 1275/2008 (Stand-by/ Off mode)
Introduction
Technical Characteristics
Top Oven
Usable Volume: 42 Litres
Declared energy consumption for
Natural convection Class
heating mode: Conventional
Main Oven
Usable Volume: 74 Litres
Declared energy consumption for
Forced convection Class
heating mode: Fan Oven
Voltage and Frequency
230-240V~ 50Hz
Radio Interference
This appliance conforms to EN 55014 regarding
suppression of radio and television interference.
Hob
Regulation (EU) No 65/2014 supplemen-
ting Directive 2010/30/EU.
Regulation (EU) No 66/2014 implementing
Directive 2009/125/EC.
Standard EN 60350-1
Standard EN 50564.
ENERGY LABEL and ECODESIGN
Regulation (EU) No 65/2014 supplemen-
ting Directive 2010/30/EU.
Regulation (EU) No 66/2014 implementing
Directive 2009/125/EC.
Standard EN 60350-1
Standard EN 50564.
ENERGY LABEL and ECODESIGN
HobHob
ECODESIGN
Regulation (EU) No 66/2014 implementing
Directive 2009/125/EC.
Standard EN 60350-2.
Standard EN 50564.
3
GB
WARNING - THIS APPLIANCE MUST BE EARTHED.
Mains Connection
Your cooker should have been checked to ensure
that the voltage corresponds with your supply
voltage, this is stated on the rating plate, which is
situated on the outer rear panel.The model number
and the serial number are located on the front of the
cooker, as shown on the Features page.
The cooker must be connected by a competent
person such as one who is a, NICEIC registered
contractor to a suitable double-pole control unit with
a minimum rating of 32A and a minimum contact
clearance of 3mm (applicable to newer properties,
older properties where a 30A double pole control unit
and a minimum contact clearance of 3mm is
acceptable).
The double pole control unit should be fitted
adjacent to the cooker, in accordance with IEE
regulations.The control unit must be within 2 metres
of but not directly above the appliance and should
be easily accessible in the event of an emergency.
The power supply cable should conform to B.S.6004
with a conductor size of 6mm2, minimum.
Access to the mains terminals is gained by
removing the rear access cover. The mains cable
must pass through the cable clamp adjacent to the
terminal block. Sufficient cable should be used to
allow the cooker to be pulled out for servicing.
Ensure that the mains cable is routed away from
any brackets affixed to the rear panel and is not
trapped to the rear wall when pushing the cooker
into position between cabinets.
For the installation of the feeding cable carry out the
following operations:
1 Open the terminal
board by inserting a
screwdriver into the
bottom tabs of the
cover. Use the
screwdriver as a lever
by pushing it down to
open the cover (see
diagram).
2 Loosen the cable
clamp screw and
remove it, using a
screwdriver as a lever
(see figure).
3. Fasten the wires
under the screw heads,
respecting
the colour code:
Installation
Black/Blue (N), Red/Brown (L) and Bare Wire/Yellow-
Green ( ).
Once the connections have been made, tighten all
the terminal screws fully.
Fasten the supply cable in place with the clamp
and close the cover of the terminal board.
Levelling
Four feet are fitted which can be adjusted up or
down to set the height (900mm - 930mm) and level
the cooker.
The feet can be simply screwed in or out to lower or
raise the cooker.
After the correct height is achieved, lock the feet
into position by tightening the locking nut using an
open ended spanner.
CAUTION: Some soft floor coverings may get
damaged if the cooker is not moved carefully.
NOTE: Ensure oven shelves are level by using a
spirit level on the rod shelves.
Siting the Cooker
The cooker is designed to fit between kitchen
cabinets spaced 600mm apart.
The space either side need only be sufficient to
allow withdrawal of the cooker for servicing and
cleaning. It can be used with cabinets one side or
both as well as in an angled corner setting.
It can also be used freestanding.
Adjacent side walls which project above hob level,
must not be nearer to the cooker than 150mm and
should be protected by heat resistant material. Any
overhanging surface or cooker hood should not be
nearer than 650mm.
Note: This appliance must NOT be fitted on a
platform.
Moving the Cooker
Before moving your
cooker, switch off at
the cooker control
unit, ensure that it is
cool.
Open the grill door
sufficiently to allow a
comfortable grip on
the underside front
edge of the oven
roof, avoiding any
grill elements.
Note: Take care in moving the cooker as it is
heavy.Take care to ensure that any floor
covering is not damaged.

Especificaciones del producto

Marca: Indesit
Categoría: horno
Modelo: ID60C2(K)S

¿Necesitas ayuda?

Si necesitas ayuda con Indesit ID60C2(K)S haz una pregunta a continuación y otros usuarios te responderán




horno Indesit Manuales

horno Manuales

Últimos horno Manuales