JennAir MEC9536BS Manual de Usario

JennAir horno MEC9536BS

Lee a continuación 📖 el manual en español para JennAir MEC9536BS (8 páginas) en la categoría horno. Esta guía fue útil para 6 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/8
CUTOUT DIMENSIONS FOR OVENS INSTALLED UNDER COOKTOP
IMPORTANT: Observe all governing codes and ordinances. Cooktop must be approved for use over an oven. See cooktop Installation
Instructions for cutout dimensions. Center the cooktop cutout over oven cutout.
To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor,
delaminate or sustain other damage. This oven has been designed in accordance with UL and CSA International and complies with the
maximum allowable wood cabinet temperatures of 194°F (90°C).
Approved Built-In Oven and Electric Radiant/Coil Cooktop Combinations
For the approved model number combinations, refer to the undercounter label located on top of the oven chassis and on the
bottom of the cooktop burner box.
NOTE: For undercounter installation, it is recommended that the junction boxes for oven and cooktop be located in the adjacent right or
left cabinet. A 1" (2.5 cm) minimum diameter hole should have been drilled in the upper rear right or left corner of the side wall surface
to pass the appliance cable through to the junction box.
A. 24" (61 cm) cabinet depth
B. 25" (63.5 cm) countertop depth
C. Recommended oven and cooktop junction box locations
D. Allow ⁵⁄₈" (1.6 cm) for oven trim to overlap on each side.
E. 27¾" (70.5 cm) minimum cutout height
F. 36" (91.4 cm) from cabinet base to countertop
G. 4⁵⁄₈" (11.7 cm) maximum from cabinet base
H. See Cutout Dimensions chart.
I. 31
³⁄₈
" (79.7 cm) from top of countertop to bottom of cutout
CUTOUT DIMENSIONS
Oven Size Oven Cutout Dimension
24" (61 cm) 22¹⁄₂" (57.2 cm)
27" (68.6 cm) 25¹⁄₂" (64.8 cm)
30" (76.2 cm) 28½" (72.4 cm)
36" (91.4 cm) 34¹⁄₂" (87.6 cm)
A
E F
G
H
B
C
C
D
I
W10351318A
2
Approved Built-In Oven and Induction Cooktop Combinations
For the approved model number combinations, refer to the undercounter label located on top of the oven chassis and on the
bottom of the cooktop burner box.
NOTE: For undercounter installation, it is recommended that the junction boxes for oven and cooktop be located in the adjacent right or
left cabinet. A 1" (2.5 cm) minimum diameter hole should have been drilled in the upper rear right or left corner of the side wall surface
to pass the appliance cable through to the junction box.
A. 24" (61 cm) cabinet depth
B. 25" (63.5 cm) countertop depth
C. Recommended oven and cooktop junction box locations
D. Allow ⁵⁄₈" (1.6 cm) for oven trim to overlap on each side.
E. 27¾" (70.5 cm) minimum cutout height
F. 36" (91.4 cm) from cabinet base to countertop
G. 3⁵⁄₈" (9.2 cm) from cabinet base. If dimension “F” is greater than
36" (91.4 cm), dimension “G” can be increased the same difference
for induction combinations.
H. See Cutout Dimensions chart.
I. 32
³⁄₈
" (82.2 cm) from top of countertop to bottom of cutout
CUTOUT DIMENSIONS
Oven Size Oven Cutout Dimension
24" (61 cm) 22¹⁄₂" (57.2 cm)
27" (68.6 cm) 25¹⁄₂" (64.8 cm)
30" (76.2 cm) 28½" (72.4 cm)
A
EF
G
H
B
C
C
D
I
3
Approved Built-In Oven and Gas Cooktop Combinations
For the approved model number combinations, refer to the undercounter label located on top of the oven chassis.
NOTE: For undercounter installation, it is recommended that the junction box for oven be located in the adjacent right or left cabinet. A
1" (2.5 cm) minimum diameter hole should have been drilled in the upper rear right or left corner of the side wall surface to pass the
appliance cable through to the junction box.
The upper shaded areas are recommended locations for recessed junction box for 120-volt grounded outlet for cooktop.
Lower shaded areas are recommended locations for flexible or rigid gas pipe installation. The gas connection on the cooktop is on the
right (same location as “J” in the above diagram). The gas pipe can be installed on either side of the cutout, and either through the floor
or through the wall. Refer to local codes regarding the use of gas lines.
A. 24" (61 cm) cabinet depth
B. 1" (2.5 cm) clearance to bottom of countertop
C. 25" (63.5 cm) countertop depth
D. Recommended oven junction box locations
E. 1" (2.5 cm) clearance to cabinet
F. 27¾" (70.5 cm) minimum cutout height
G. Allow ⁵⁄₈" (1.6 cm) for oven trim to overlap on each side.
H. 36" (91.4 cm) from cabinet base to countertop
I. 31
³⁄₈
" (79.7 cm) from top of countertop to bottom of cutout
J. Gas line through wall 10¹⁄₂" (26.7 cm) to center of cutout
K. 3¼" (8.3 cm)
L. Gas line through floor 10½" (26.7 cm) to center of cutout
M. 3½" (8.9 cm)
N. 4⁵⁄₈" (11.7 cm) maximum from cabinet base
O. See Cutout Dimensions chart.
CUTOUT DIMENSIONS
Oven Size Oven Cutout Dimension
24" (61 cm) 22¹⁄₂" (57.2 cm)
27" (68.6 cm) 25¹⁄₂" (64.8 cm)
30" (76.2 cm) 28½" (72.4 cm)
36" (91.4 cm) 34¹⁄₂" (87.6 cm)
AC
D
E
F
GH
NM
E
D
K
B
J
L
O
I

Especificaciones del producto

Marca: JennAir
Categoría: horno
Modelo: MEC9536BS

¿Necesitas ayuda?

Si necesitas ayuda con JennAir MEC9536BS haz una pregunta a continuación y otros usuarios te responderán




horno JennAir Manuales

horno Manuales

Últimos horno Manuales