JL Audio SlamPak SLPK-YA-FXC-SG-WH.r2 Manual de Usario

JL Audio No categorizado SlamPak SLPK-YA-FXC-SG-WH.r2

Lee a continuación 📖 el manual en español para JL Audio SlamPak SLPK-YA-FXC-SG-WH.r2 (15 páginas) en la categoría No categorizado. Esta guía fue útil para 13 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/15
I N S T A L L A T I O N G U I D E
for the
SLPK-YA-FXC-SG-TB.r2
SKU# 91168
&
SLPK-YA-FXC-SG-WH.r2
SKU# 91169
2013-2018 Yamaha FX
Thank you for choosing a JL Audio SlamPak™ for your marine sound system.
With proper installation, your new marine audio sound system
will deliver years of listening pleasure.
We strongly recommend that you have your new SlamPak™ installed by your
authorized JL Audio dealer. The installation professionals employed by your
dealer have the necessary tools and experience to disassemble and reassemble
your vessel properly. If you prefer to perform your own installation, please read
this installation guide completely before beginning the process.
If you choose to perform the installation yourself, it is absolutely
vital that the SlamPak™ be properly mounted to the vessel
according to these instructions. Failure to mount the enclosures
properly presents two problems:
1) A loose enclosure presents a serious safety hazard in the event of a
collision, rollover, or sudden deceleration.
2) The sub-bass performance will suffer due to the movement of the
enclosure caused by the force exerted by the woofer(s).
INSTALL ATION
DIFFICULTY:
ESTIMAT ED T IME:
3-4 HOURS
Continued on Next Page
55
OUT
OF
SLPK-YA-FXC-SG INSTR_SKU# 011475
SlamPak
IN CLU DE D HA R D W A R E
Continued on Next Page
Page 2 • JL Audio, Inc., 2020
SLPK-YA-FXC-SG INSTR_SKU# 011475
Qty Description
11 1/4 - 20 x 1” Serrated Flange Head Bolt
11 1/4” Oversized Flat Washer
17 1/4” Flat Washer
13 1/4 - 20 Nylon Insert Locknut
5 1/4 - 20 Hex Cap Screw
1 1/4 - 20 Hex Nut
3 1/4” Split Lock Washer
4 #8 - 32 x 1/2” Pan Head Phillips Screw
4 #8 Split Washer
4 #8 Flat Washer
1 Liquid Tight Water Seal
2 3/8” Grommet
1 Template
1 Amplier Bracket
1 Port Pod Bracket
1 Starboard Pod Bracket
2 Long L-Bracket
1 Short L-Bracket
10 11” Cable Tie
1 1-1/4” Foam Tape
1 Loctite® 263 Red read-Locking Compound
1 Loctite® 242 Blue read-Locking Compound
2 Gasket
1 Silicone Adhesive
2 2-Pin Female Receptacle
2 2-Pin Wedgelock
1 4-Pin Female Receptacle
1 4-Pin Wedgelock
4 Heat Shrink Tubing
Hardware Equipment
Qty Description
1 MX500/4 Amplier *
2VeX Speaker Enclosures
1 M8W5 Subwoofer Enclosure
1 MBT-CRXv2 Bluetooth Controller
1 Power Harness
1 Amplier Harness
1 1.5’ 2 Channel RCA Interconnect
1 50A Circuit Breaker
1 Sport Grille Badges (pair)
2 Aluminum Logo Cap
* NOTE: For optimum performance and reliability, all amplifier controls
have been preset for this SlamPak™ and sealed beneath the control
panel cover. No further adjustment is necessary.
Page 3 • JL Audio, Inc., 2020 Continued on Next Page
S T E P 8
Remove the cluster shroud.
S T E P 7
Remove the four Torx screws from the top of
the cluster shroud.
S T E P 6
The lower access panel has been removed.
S T E P 5
Remove the five push clips from the lower
access panel, and remove the panel.
S T E P 4
Unlatch and lift the lid.
S T E P 3
Remove the under seat locker.
S T E P 2
Remove the front seat section from the vessel.
S T E P 1
Unlatch and remove the rear seat section from
the vessel.
SLPK-YA-FXC-SG INSTR_SKU# 011475

Especificaciones del producto

Marca: JL Audio
Categoría: No categorizado
Modelo: SlamPak SLPK-YA-FXC-SG-WH.r2

¿Necesitas ayuda?

Si necesitas ayuda con JL Audio SlamPak SLPK-YA-FXC-SG-WH.r2 haz una pregunta a continuación y otros usuarios te responderán




No categorizado JL Audio Manuales

No categorizado Manuales

Últimos No categorizado Manuales