Krups Savoy Control BW3140 Manual de Usario

Krups Pava Savoy Control BW3140

Lee a continuación 📖 el manual en español para Krups Savoy Control BW3140 (36 páginas) en la categoría Pava. Esta guía fue útil para 15 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/36
www.krups.com
KETTLE BW3140
ENFRDENLESITPT
NC00136517
EN ................. P. 1–5
FR ................. P. 6–10
DE ................. P. 11–15
NL ................. P. 16–20
ES ................. P. 21–25
IT ................... P. 26–30
PT ................. P. 31–35
1
2
fig. 2 fig. 3
fig. 4 fig. 5
fig. 1
1
English
On/off button - Display the temperature of the water in the
kettle.
On/off button - Display the temperature of the water in the
kettle.
Button to select the desired temperature (7 options: 100°
- 95° - 90° - 85° - 80° - 70° - 60°C). Saves the previously
selected temperature.
Button to keep warm (the cup flashes until the selected
temperature is reached). Keeps warm for 1 hour. By
default keeps warm to 60°C.
BEFORE USING FOR THE FIRST TIME
Remove all of the various packaging, stickers or accessories from both the inside
and outside of the kettle (do not forget to remove the transparent protective film from
the screen).
Adjust the length of the cord by winding it under the base. Wedge the cord into the
notch. (fig 1)
Throw away the water from the first two/three uses as it may contain dust. Rinse the
kettle and the filter separately.
USE
1. TO OPEN THE LID.
Press the opening button on the lid. It lifts automatically. (fig. 2 and 3)
To close, press down firmly on the lid.
2. PLACE THE BASE ON A FLAT, STABLE, HEAT-RESISTANT SURFACE AWAY
FROM WATER SPLASHES AND ANY SOURCES OF HEAT.
CAUTION: the safety precautions are part of the appliance. Read them
carefully before using your new appliance for the first time. Keep them in a
place where you can find and refer to them later on.
2
Kettle is only to be used with the base provided.
3. FILL THE KETTLE WITH THE DESIRED AMOUNT OF WATER. (fig 4)
Never fill the kettle when it is on its base.
Do not fill it above the maximum level, or below the minimum level. If the kettle is too
full, boiling water may spill out.
Do not use without water.
Check that the lid is closed properly before use.
4. POSITION THE KETTLE ON ITS BASE. PLUG IT INTO THE MAINS SOCKET.
5. TO START THE KETTLE
Press the on/off button on the base .)
The temperature of the water in the kettle is displayed on the screen.
TO BOIL THE WATER
2 options:
If you would like to boil the kettle, press the button.
If you would like to choose your own temperature (7 options: 10- 95° - 90° -
85° - 80° - 70° - 60°), press the button until you reach the desired temperature.
Once the temperature has been chosen (either with the or button) the
boiling cycle will begin automatically after 2 seconds, and will stop once the selected
temperature has been reached (accurate to +/- 3°C).
To stop the cycle once it is under way, press the selected button once again (either
the or button).
KEEP WARM FUNCTION
Your kettle has a ‘keep warm’ function . If you have selected a temperature
beforehand, the water will be heated to this temperature and then kept at this
temperature for 1 hour; if not then it will be kept warm at 60°C.
The maximum permitted temperature for the Keep Warm function is 95°C.
NOTE
The screen will turn off automatically after 30 minutes (standby mode) but all the
buttons will remain active. This means that pressing any button will switch the screen
back on.
If you use the button to select a temperature less than that of the water already in
the kettle, the function will not be activated and the cycle will not start.
Example: if the water is 90°C, you will not be able to start cycles for temperatures of
60°C/70°C/80°C/85°C.
Recommended temperatures :
70°C : white tea/green tea
90°C : black tea
100°C : boiling water/infusions
6. THE KETTLE WILL SWITCH OFF AUTOMATICALLY
As soon as the water reaches boiling point or the chosen temperature.
Do not leave water in the kettle after use as this quickens the formation of scale.

Especificaciones del producto

Marca: Krups
Categoría: Pava
Modelo: Savoy Control BW3140
Color del producto: Blauw
Peso.: 85 g
Ancho: 60 mm
Profundidad: 60 mm
Altura: 60 mm
Capacidad del acumulador/batería: 300 mAh
Bluetooth: Ja
Versión Bluetooth: 2.1+EDR
Perfiles Bluetooth: A2DP, AVRCP
Tipo de conector USB: Micro-USB
Tecnología de conectividad: Draadloos
Tipo de fuente de energía: Batterij/Accu
Cables suministrados: Micro-USB
Guía de inicio rápido: Ja
Energía promedio: 3 W
Número de hablantes: 1
Certificación: Bluetooth, FCC, CE
Certificados de sostenibilidad: RoHS
Conecta y reproduce: Ja
Uso recomendado: Universeel
Impedancia: - Ohm
Batería/Tiempo de carga de la batería: 1.5 uur
Tiempo de espera: 96 uur
Canales de salida de audio: - kanalen
Número de conductores: 1
Controlador de diámetro: 40 mm
Rango de frecuencia: 150 - 18000 Hz
tipo de imán: Neodymium
Alcance de Bluetooth: 10 m
subwoofer suministrado: Ja
Amplificador: Ingebouwd
Carga vía USB: Ja
Diseño de producto: Bolvormig
Tecnología de batería: Lithium-Polymeer (LiPo)
Tipo de Batería: Ingebouwd

¿Necesitas ayuda?

Si necesitas ayuda con Krups Savoy Control BW3140 haz una pregunta a continuación y otros usuarios te responderán




Pava Krups Manuales

Pava Manuales

Últimos Pava Manuales