Makita DC4001 Manual de Usario

Lee a continuación 📖 el manual en español para Makita DC4001 (16 páginas) en la categoría No categorizado. Esta guía fue útil para 3 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/16
INSTRUCTION MANUAL
MANUEL D'INSTRUCTION
MANUAL DE INSTRUCCIONES
Charger
Chargeur
Cargador
DC4001
IMPORTANT: Read Before Using.
IMPORTANT : Lire avant usage.
IMPORTANTE: Lea antes de usar.
2 ENGLISH
ENGLISH (Original instructions)
SPECIFICATIONS
Model: DC4001
Input A.C. 120 V, 50–60 Hz / 50/60 Hz
Output D.C. 25 V–40 V
Net weight 1.1 kg (2.4 lbs)
• Duetoourcontinuingprogramofresearchanddevelopment,thespecicationshereinaresubjecttochange
without notice.
• Specicationsmaydi󰀨erfromcountrytocountry.
The weight according to EPTA-Procedure 01/2014, are shown in the table.
SAFETY WARNINGS
IMPORTANT SAFETY INSTRUCTIONS
CAUTION:
1. SAVE THESE INSTRUCTIONS
– This manual contains important safety and operating instructions for battery
charger.
2. Before using battery charger, read all instructions and cautionary markings on
(1) battery charger, (2) battery, and (3) product using battery.
3. CAUTION – To reduce risk of injury, charge only Makita type rechargeable bat-
teries. Other types of batteries may burst causing personal injury and damage.
4. Non-rechargeable batteries cannot be charged with this battery charger.
5. Use a power source with the voltage specied on the nameplate of the charger.
6. Do not charge the battery cartridge in presence of ammable liquids or gases.
7. Do not expose charger to rain, snow, or wet condition.
8. Never carry charger by cord or yank it to disconnect from receptacle.
9. After charging or before attempting any maintenance or cleaning, unplug the
charger from the power source. Pull by plug rather than cord whenever discon-
necting charger.
10. Make sure cord is located so that it will not be stepped on, tripped over, or other-
wise subjected to damage or stress.
11. Do not operate charger with damaged cord or plug. If the cord or plug is dam-
aged, ask Makita authorized service center to replace it in order to avoid a
hazard.
12. Do not operate or disassemble charger if it has received a sharp blow, been
dropped, or otherwise damaged in any way; take it to a qualied serviceman.
Incorrect use or reassembly may result in a risk of electric shock or re.
13. The battery charger is not intended for use by young children or inrm persons
without supervision.
14. Young children should be supervised to ensure that they do not play with the
battery charger.
3 ENGLISH
15. Do not charge battery cartridge when room temperature is BELOW 10°C (50°F)
or ABOVE 40°C (104°F). At the cold temperature, charging may not start.
16. Do not attempt to use a step-up transformer, an engine generator or DC power
receptacle.
17. Do not allow anything to cover or clog the charger vents.
18. Do not plug or unplug the cord and insert or remove the battery with wet hands.
19. Never use gasoline, benzine, thinner, alcohol or the like to clean the charger.
Discoloration, deformation or cracks may result.
FCC statement
This device complies with part 15 of the FCC Rules.
Operationissubjecttothefollowingtwoconditions:(1)
Thisdevicemaynotcauseharmfulinterference,and
(2)thisdevicemustacceptanyinterferencereceived,
includinginterferencethatmaycauseundesired
operation.
FCC caution
Changesormodicationsnotexpresslyapprovedby
thepartyresponsibleforcompliancecouldvoidthe
user’sauthoritytooperatetheequipment.
Note:Thisequipmenthasbeentestedandfound
tocomplywiththelimitsforaClassBdigitaldevice,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipmentgenerates,usesandcanradiateradio
frequencyenergyand,ifnotinstalledandusedin
accordancewiththeinstructions,maycauseharmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a partic-
ularinstallation.Ifthisequipmentdoescauseharmful
interference to radio or television reception, which can
bedeterminedbyturningtheequipmento󰀨andon,the
userisencouragedtotrytocorrecttheinterferenceby
oneormoreofthefollowingmeasures:
Reorient or relocate the receiving antenna.
— Increasetheseparationbetweentheequipment
and receiver.
— Connecttheequipmentintoanoutletonacir-
cuitdi󰀨erentfromthattowhichthereceiveris
connected.
— Consultthedealeroranexperiencedradio/TV
technician for help.
Makita U.S.A. Inc.
14930 Northam Street, La Mirada, CA 90638-5753,
USA
+1-(714) 522-8088
Symbols
Thefollowingsshowthesymbolsusedforcharger.
volts
amperes
hertz
alternating current
W
watt
direct current
Charging
CAUTION: After charging is complete, be
sure to remove the power plug of the battery
charger from the AC voltage source, and remove
the socket of the battery charger and attach the
cap of the battery.
NOTICE: The battery charger is intended for
charging MAKITA portable power pack only. Never
use it for other purposes or for other manufactur-
er's batteries.
NOTICE: When the battery charger is connected
to the unit, the tool or machine does not start. In
this case, remove the battery charger from the
unit.
NOTICE: If the temperature of the battery
becomes low or high during charging, the
charging may stop. In this case, wait until the bat-
tery becomes ordinary temperature by warming
up or cooling down the battery, and then restart
the charging.

Especificaciones del producto

Marca: Makita
Categoría: No categorizado
Modelo: DC4001

¿Necesitas ayuda?

Si necesitas ayuda con Makita DC4001 haz una pregunta a continuación y otros usuarios te responderán




No categorizado Makita Manuales

No categorizado Manuales

Últimos No categorizado Manuales