Martin to DMX Converter Manual de Usario

Martin No categorizado to DMX Converter

Lee a continuación 📖 el manual en español para Martin to DMX Converter (8 páginas) en la categoría No categorizado. Esta guía fue útil para 6 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/8
Martin to DMX
Converter
user manual
I
NTRODUCTION
1
Thank you for selecting the Martin to DMX Protocol Converter. This device
employs a unique NMBE algorithm to convert 16 channels of Martin data to 128
channels of DMX data, allowing you to control DMX-only fixtures with Martin’s
3032 and 2510 controllers.
C O N T R O L L E R R E Q U I R E M E N T S
Version 2.08 of the 3032 PC software is required for use with the Martin to DMX
Protocol Converter. This software may be downloaded from the Martin web site at
http://www.martin.dk. No upgrade of the 2510 Controller firmware is required.
S A F E T Y I N F O R M A T I O N
Warning! This product is for professional use only. It is not for
household use.
To prot e ct you r s elf an d o t h e r s fr o m elect r i c s h ock
Disconnect the fixture from AC power when not in use.
Always ground (earth) the fixture electrically.
Use only a source of AC power that complies with local building and electrical
codes and has both overload and ground-fault protection.
Do not expose the fixture to rain or moisture.
Do not open or modify the fixture. Refer all service to a Martin service technician.
U N P A C K I N G
The Martin to DMX Protocol Converter comes with:
3 m, 3-pin IEC mains cable
user manual
©2000, 2001 Martin Professional A/S, Denmark. All rights reserved. P/N 35000085, Rev. B
AC Power
3
AC P
OWER
2
Warning! For protection from fire and electric shock, the fixture must be
grounded (earthed). The power supply shall have overload and
ground-fault protection.
Important! Check the voltage setting before applying power!
To i n s t al l a pl u g on t he mai n s l e ad
The mains lead must be fitted with a grounding-type cord cap that fits your
power distribution system. Consult a qualified electrician if you have any
doubts about proper installation.
Following the cord cap manufacturers instructions, connect the yellow and
green wire to ground (earth), the brown wire to live, and the blue wire to neutral.
The table below shows some pin identification schemes.
To s et or ver ify volt ag e sett in g
The Martin to DMX Protocol Converter may be switched between 115 and 230 V.
Verify the voltage setting before applying power.
Slide the voltage switch located on the side to the voltage setting closest to the
local mains AC voltage.
To a p p l y p o w er
Verify the voltage setting. Plug the prepared power cord into the mains input
socket and the AC distribution system.
Wire Pin Marking Screw color
brown live “L” yellow or brass
blue neutral “N” silver
yellow/green ground green

Especificaciones del producto

Marca: Martin
Categoría: No categorizado
Modelo: to DMX Converter

¿Necesitas ayuda?

Si necesitas ayuda con Martin to DMX Converter haz una pregunta a continuación y otros usuarios te responderán




No categorizado Martin Manuales

No categorizado Manuales

Últimos No categorizado Manuales