Metra 70-5520 Manual de Usario

Lee a continuación 📖 el manual en español para Metra 70-5520 (2 páginas) en la categoría No categorizado. Esta guía fue útil para 6 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/2
Receiver Wiring Adaptor
120 70-5520
Revision 01/07/14
White - Left Front Speaker Positive
Violet/Black - Right Rear Speaker Negative
Red - 12 Volts Switched Power
Violet - Right Rear Speaker Positive
Green - Left Rear Speaker Positive
Yellow - 12 Volts Constant Power
Gray - Right Front Speaker Positive
Gray/Black - Right Front Speaker Negative
Green/Black - Left Rear Speaker Negative
White/Black - Left Front Speaker Negative
Orange - Illumination
Black - Chassis Ground
Connect wires below to the matching function of each wire on your receiver (refer to instructions supplied with receiver).
The wire colors of your new receiver may, or may not, match the wire colors of the adaptor. Match adaptor and receiver
wires by function, disregarding color.
If your receiver does not have an Illumination wire, tape off the Orange wire.
Connect Black wire to Ground wire of new receiver.
Individually tape off any unused wires.
Make final connections following instructions on the next page.
STEP 1 -- CONNECT WIRES
*120705520*
IMPORTANT
Before starting, compare items on your invoice with items
received. Carefully check packing materials. If an item is
missing, please call Crutchfield at 1-888-955-6000.
Blue - Power Antenna
(Amp Remote in Sonata)
Blue/White - Amplifier Turn-On (Not used in Sonata)
These notes pertain to 2006-'08 Hyundai Sonatas only:
This Blue Wire is used as the Amp Remote lead in 2006-'08 Hyundai
Sonatas with a factory subwoofer, but will not be used if the vehicle
does not have a subwoofer.
For all 2006-'08 Hyundai Sonatas: Connect the Power Antenna Wire on
the new receiver to the factory Green/Black Wire matching this location
(bottom of illustration) on the factory harness disconnected from the
factory radio.
Copyright 2014 Crutchfield Corporation
A.
B.
C.
D.
E.
Receiver Wiring Adaptor Connections
120 70-5520
Page 2
STEP 2 -- CONTINUED
A. Strip wires back 1/2”.
B. Twist wires together and
insert in crimp cap.
C. Squeeze middle of cap
for tight connection.
Copyright 2014 Crutchfield Corporation
STEP 3 -- APPLICATION
When ready to install the receiver, plug
the Wiring Adaptor from the new receiver
or receiver assembly into the factory
radio harness(es) in the vehicle dash.
D. Complete crimp connections
for all necessary wires.
E. Be sure to wrap any wires from
the Wiring Adaptor that are
not necessary (wires with no
match from the new receiver)
with electrical tape.
STEP 2 -- CRIMP CONNECTIONS
Tools & Parts
Required
Wire Stripper/Crimp Tool Crimp Caps
Unused Wire (tape over bare wires)
Receiver Wiring Adaptor
Generic Illustration
Generic Illustration

Especificaciones del producto

Marca: Metra
Categoría: No categorizado
Modelo: 70-5520

¿Necesitas ayuda?

Si necesitas ayuda con Metra 70-5520 haz una pregunta a continuación y otros usuarios te responderán




No categorizado Metra Manuales

No categorizado Manuales

Últimos No categorizado Manuales