Metra 70-7863 Manual de Usario

Lee a continuación 📖 el manual en español para Metra 70-7863 (2 páginas) en la categoría No categorizado. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/2
In order to retain the factory AUX input, the new
receiver must have an AUX input connection. An
adaptor may be needed with receivers that have a
3.5mm AUX input.
Receiver Wiring Adaptor
120 70-7863
Revision 11/10/16
STEP 1 -- MATCH & CONNECT WIRES
*120707863*
IMPORTANT
Before starting, compare items on your invoice with items
received. Thoroughly check packing materials. If an item
is missing, please call Crutchfield at 1-888-955-6000.
Copyright 2016 Crutchfield Corporation
Match wires below to the matching function of each wire on your receiver (refer to instructions supplied with receiver). The wire colors of your
new receiver may, or may not, match the wire colors of the adaptor. Match adaptor and receiver wires by function, disregarding color.
Connect the illumination wire from the new receiver to the Orange illumination wire in the wiring adaptor. If the new receiver does not have an
illumination wire, tape off the illumination wire in the wiring adaptor.
Tape off any unused wires.
Make final wiring connections following instructions on the next page.
A.
B.
C.
D.
Red - 12 Volts Switched Power
Yellow - 12 Volts Constant Power
Orange - Illumination
Black - Chassis Ground
Blue/White - Power Antenna and Amplifier Remote
(connect to Amp Remote of new receiver)
MAIN HARNESS
AUX INPUT
HARNESS
White - Left Channel
Red - Right Channel
Subwoofer Input
SUBWOOFER
HARNESS
Violet - Right Rear Signal Input
Green - Left Rear Signal Input
White - Left Front Signal Input
Gray - Right Front Signal Input
For best results, this RCA plug should
be connected to the subwoofer preamp
output on the new receiver.
Connect to
RCA outputs
on new receiver.
This plug might be white in some packages.
If so, please disregard. It serves the same
function as indicated.
Receiver Wiring Adaptor Connections
120 70-7863
Page 2
STEP 2 -- CONTINUED
A. Strip wires back 1/2”.
B. Twist wires together and
insert in crimp cap.
C. Squeeze middle of cap
for tight connection.
Copyright 2016 Crutchfield Corporation
STEP 3 -- APPLICATION
When ready to install the receiver, plug
the Wiring Adaptor from the new receiver
or receiver assembly into the factory
radio harness(es) in the vehicle dash.
D. Complete crimp connections
for all necessary wires.
E. Be sure to wrap any wires from
the Wiring Adaptor that are
not necessary (wires with no
match from the new receiver)
with electrical tape.
STEP 2 -- CRIMP CONNECTIONS
Tools & Parts
Required
Wire Stripper/Crimp Tool Crimp Caps
Unused Wire (tape over bare wires)
Receiver Wiring Adaptor
Generic Illustration
Generic Illustration

Especificaciones del producto

Marca: Metra
Categoría: No categorizado
Modelo: 70-7863

¿Necesitas ayuda?

Si necesitas ayuda con Metra 70-7863 haz una pregunta a continuación y otros usuarios te responderán




No categorizado Metra Manuales

No categorizado Manuales

Últimos No categorizado Manuales