Metra 70-8113 Manual de Usario

Lee a continuación 📖 el manual en español para Metra 70-8113 (2 páginas) en la categoría No categorizado. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/2
Receiver Wiring Adaptor
120 70-8113
Revision 03/13/17
STEP 1 -- MATCH & CONNECT WIRES
*120708113*
IMPORTANT
Before starting, compare items on your invoice with items
received. Thoroughly check packing materials. If an item
is missing, please call Crutchfield at 1-888-955-6000.
Copyright 2017 Crutchfield Corporation
Match wires below to the matching function of each wire on your receiver (refer to instructions supplied with receiver). The wire colors of your
new receiver may, or may not, match the wire colors of the adaptor. Match adaptor and receiver wires by function, disregarding color.
Your receiver illumination wire could be Orange or Orange/White. As with other wires, match this wire to the illumination wire in this harness
by function, not by color. If your receiver does not have an illumination wire, tape off the illumination wire.
Individually tape off any unused wires.
Make final wiring connections following instructions on the next page.
A.
B.
C.
D.
Blue/White - Amplifier Turn-On
Black/White - Amplifier Shield Ground
Yellow - 12 Volts Constant Power
Red - 12 Volts Switched Power
Green - Left Rear Channel
Violet - Right Rear Channel
White - Left Front Channel
Gray - Right Front Channel
Black - Chassis Ground
Blue - Power Antenna
Connect this wire with Ground
or Ground to Vehicle Chassis
Orange Illumination-
Receiver Wiring Adaptor Connections
120 70-8113
Page 2
STEP 2 -- CONTINUED
A. Strip wires back 1/2”.
B. Twist wires together and
insert in crimp cap.
C. Squeeze middle of cap
for tight connection.
Copyright 2017 Crutchfield Corporation
STEP 3 -- APPLICATION
When ready to install the receiver, plug
the Wiring Adaptor from the new receiver
or receiver assembly into the factory
radio harness(es) in the vehicle dash.
D. Complete crimp connections
for all necessary wires.
E. Be sure to wrap any wires from
the Wiring Adaptor that are
not necessary (wires with no
match from the new receiver)
with electrical tape.
STEP 2 -- CRIMP CONNECTIONS
Tools & Parts
Required
Wire Stripper/Crimp Tool Crimp Caps
Unused Wire (tape over bare wires)
Receiver Wiring Adaptor
Generic Illustration
Generic Illustration

Especificaciones del producto

Marca: Metra
Categoría: No categorizado
Modelo: 70-8113

¿Necesitas ayuda?

Si necesitas ayuda con Metra 70-8113 haz una pregunta a continuación y otros usuarios te responderán




No categorizado Metra Manuales

No categorizado Manuales

Últimos No categorizado Manuales