Metra 95-6532B Manual de Usario

Lee a continuación 📖 el manual en español para Metra 95-6532B (4 páginas) en la categoría No categorizado. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/4
METRA. The World’s best kits.metraonline.com © COPYRIGHT 2015 METRA ELECTRONICS CORPORATION
REV. 9/23/2015 INST95-6532B
CAUTION: Metra recommends disconnecting the negative battery
terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your
local Dealership for more information. All accessories, switches,
climate controls panels, and especially air bag indicator lights
must be connected before reconnecting the battery or cycling
the ignition. Also, do not remove the factory radio with the key
in the on position, or the vehicle running. It would be best to
remove the key from the ignition and then wait a few seconds
before removing the factory radio.
Installation instructions for part 95-6532B
A) Radio trim panel • B) Radio brackets • C) (4) White panel clips
20;*64765,5;:
>0905.(5;,55(*655,*;065: (sold separately)
Wiring Harness: • XSVI-6523-NAV
Antenna Adapter: 40-EU55 Amplified antenna adapter
Panel removal tool • Phillips screwdriver
Torx driver
;663:9,8<09,+
Jeep Renegade 2015-up
95-6532B
A B
Dash Disassembly ................................................. 2
Kit Assembly
ISO DDIN radio provision ...................................... 3
Table of Contents
ISO DDIN radio provision
Painted to match factory finish
20;-,(;<9,:
C
95-6532B
2
Dash Disassembly
 Unclip and remove the trim panel
surrounding the factory radio.
(Figure A)
 Remove (4) T-20 Torx Screws
securing the radio. (Figure B)
 Unplug and remove the radio.
 Cut shaded area at the top of the
radio cavity. (Figure C)
Continue to kit assembly
(Figure A)
(Figure B)
(Figure C)
Remove
shaded
area
95-6532B
3
Kit Assembly
ISO DDIN radio provision
1. Attach the (4) supplied white panel
clips radio housing to the .
(Figure A)
2. Attach the radio brackets to the
radio using the screws supplied
with the radio. (Figure B)
3. Locate the factory wiring harness
and antenna connector in the
dash, and complete all necessary
connections to the radio. Metra
recommends using the proper
mating adapter from Metra and/or
AXXESS. Re-connect the negative
battery terminal and test the radio
for proper operation.
4. Reassemble the dash in the
reverse order of disassembly using
the 6532 instead radio trim panel
of the factory radio panel.
(Figure A) (Figure B)

Especificaciones del producto

Marca: Metra
Categoría: No categorizado
Modelo: 95-6532B

¿Necesitas ayuda?

Si necesitas ayuda con Metra 95-6532B haz una pregunta a continuación y otros usuarios te responderán




No categorizado Metra Manuales

No categorizado Manuales

Últimos No categorizado Manuales