Metra 95-7331 Manual de Usario

Lee a continuación 📖 el manual en español para Metra 95-7331 (4 páginas) en la categoría No categorizado. Esta guía fue útil para 7 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/4
METRA. The World’s best kits.metraonline.com © COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
REV. 11/6/2015 INST95-7331
Installation instructions for part 95-7331
CAUTION!
Metra recommends disconnecting the negative bat
-
tery terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your local
Dealership for more information. All accessories, switches, climate
controls panels, and especially air bag indicator lights must be con-
nected before reconnecting the battery or cycling the ignition. Also,
do not remove the factory radio with the key in the on position, or the
vehicle running. It would be best to remove the key from the ignition
and then wait a few seconds before removing the factory radio.
ISO DDIN radio provision
A) Radio housing B) Radio brackets
KIT FEATURES
KIT COMPONENTS
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: 70-1004 • 70-7303 (2009 model only)
Antenna Adapter: • 40-KI10
Panel removal tool Phillips screwdriver • 10mm socket wrench
TOOLS REQUIRED
Kia Amanti 2007-2009
95-7331
A B
Dash Disassembly ..............................................2-3
Kit Assembly
ISO DDIN radio provision ...................................... 4
Table of Contents
95-7331
2
1. Unclip the top half of the shift knob
and remove the “C” clip securing
the shifter. Pull up on the shifter to
remove. (Figure A)
2. Unclip and remove the panel
surrounding the shifter. (Figure B)
3. Unclip and remove the top half of
center console, including the cup
holders. (Figure C)
4. Open the center console and
remove the screw cover located in
the bottom.
5. Remove (2) 10mm bolts securing
the compartment, and then unclip
and remove the compartment.
(Figure D)
Continued on the next page
Dash Disassembly
(Figure B) (Figure D)
123
(Figure A) (Figure C)
95-7331
Dash Disassembly
(Figure F) (Figure H)
6. Unclip the rear trim panel from the center console, including
the a/c vents. Unplug and remove the rear trim panel. (Figure E)
7. Remove (1) Phillips screw from each side at the rear of the
center console. (Figure E)
8. Unclip the side panels from the front of the center console.
(Figure F)
Note: It is not necessary to remove these panels.
9. Remove (4) Phillips screws securing the center console, and
then lift and slide the center console back out of the way.
(Figure G)
Note: You do not have to take the center console all the way out.
10. Remove (1) Phillips screw from each side panel, and then
unclip and remove the panels. (Figure H)
11. Remove (4) Phillips screws securing the radio, and then
unplug and remove the radio.
12. Unclip and remove the switches and/or switch covers along
the top of the factory radio.
Note: Retain the switches and/or covers to be reinstalled in
the radio housing.
Continue to kit assembly
(Figure E) (Figure G)
3

Especificaciones del producto

Marca: Metra
Categoría: No categorizado
Modelo: 95-7331

¿Necesitas ayuda?

Si necesitas ayuda con Metra 95-7331 haz una pregunta a continuación y otros usuarios te responderán




No categorizado Metra Manuales

No categorizado Manuales

Últimos No categorizado Manuales