Metra 95-7631B Manual de Usario

Lee a continuación 📖 el manual en español para Metra 95-7631B (7 páginas) en la categoría No categorizado. Esta guía fue útil para 5 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/7
REV. 9/28/2016 INST95-7631B
INSTALLATION INSTRUCTIONS FOR PART 95-7631B
METRA – The World’s best kits.®metraonline.com © COPYRIGHT 2016 METRA ELECTRONICS CORPORATION
CAUTION!
All accessories, switches, climate controls panels,
and especially air bag indicator lights must be connected before
cycling the ignition. Also, do not remove the factory radio with
the key in the on position, or while the vehicle is running.
ISO DDIN radio provision
Painted matte black
A) Radio trim panel • B) Radio brackets C) (4) #8 x 3/8” Phillips screws
20;-,(;<9,:
20;*64765,5;:
>0905.(5;,55(*655,*;065: (sold separately)
Wiring Harness: • 70-7552 Antenna Adapter: 40-NI12
Panel removal tool • Phillips screwdriver
12mm socket wrench T-20 Torx driver
;663:9,8<09,+
Nissan Titan 2017-up, Titan XD 2016-up
95-7631B
Table of Contents
ABC
Dash Disassembly ..............................................2-5
Kit Assembly
ISO DDIN radio provision ...................................... 6
95-7631B
2
Dash Disassembly
1. Remove the (2) Phillips screws
securing the knee bolster panel
below the steering column, and
then unclip the panel. It is not
necessary to completely remove
the panel. (Figure A)
2. Unclip and remove the passenger
door sill and kick panel. (Figure B)
3. Remove the (5) T-20 Torx screws
securing the glove box and then
remove. There are (2) screws
below the glove box, and (3)
screws exposed when you open
the glove box. (Figures C and D)
Continued on next page
(Figure B)
(Figure D)
(Figure A) (Figure C)
Upper screws
Lower screws
95-7631B
3
Dash Disassembly
4. Unclip and remove the (2) side
trim panels at the front of the
center console, and then remove
the (1) Phillips screw exposed
behind each panel. Tip: Pull out on
the front sides of the console to
release for later steps. (Figure E)
5. Slide both of the front seats
forward and then remove the (2)
12mm bolts from the rear sides of
the center console. Slide the seat
back once done. (Figure F)
6. Unclip and remove either the front
console pocket or heated seat
controls, depending on options
available. (Figure G)
Continued on next page
(Figure F)(Figure E) (Figure G)

Especificaciones del producto

Marca: Metra
Categoría: No categorizado
Modelo: 95-7631B

¿Necesitas ayuda?

Si necesitas ayuda con Metra 95-7631B haz una pregunta a continuación y otros usuarios te responderán




No categorizado Metra Manuales

No categorizado Manuales

Últimos No categorizado Manuales