Metra 99-3101 Manual de Usario

Lee a continuación 📖 el manual en español para Metra 99-3101 (3 páginas) en la categoría No categorizado. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/3
IMPORTANT
Installation Kit
120 99-3101
Before starting, compare items on your invoice with items
received. Carefully check through packaging material. If an
item is missing, please call:
Crutchfield
Parts Supplied:
Chevrolet
Revision 09/13/01
Page 1 of 3
Kit assembly instructions are on the following pages. *120993101*
Mounting Bracket
(1) Truss Head Screw
Face Plate
Rear Support Strap (1) Speed Clip
®
Copyright 2001 Crutchfield Corporation
at 1-888-955-6000
2. Secure rear support strap under top edge of
receiver mounting bracket with speed clip and
screw as shown (Figure 2).
3. Remove DIN sleeve and trim ring from receiver if
in place.
4. Slide DIN sleeve into receiver mounting bracket and
secure by bending securing tabs (Figure 3).
5. Slide receiver fully into sleeve and install trim ring.
6. Install assembly following instructions in the
Mastersheet for your particular vehicle.
Installation Kit
120 99-3101
Chevrolet
DIN Assembly
1. Using a utility knife, cut out to createshaft supports
the DIN opening as shown (Figure 1).
Page 2
Receiver Mounting Bracket
DIN Sleeve
FIGURE 1
FIGURE 3
Securing Tabs
Bend tabs after sleeve
is inside mounting bracket.
Trim Ring
Shaft receiver assembly instructions
are on the next page.
FIGURE 2
Rear Support Strap
Speed Clip
Shaft Supports
Tools Required
Flat Blade
Screwdriver
Utility Knife
Phillips
Screwdriver
®
Copyright 2001 Crutchfield Corporation
Installation Kit
Tools Required
120 99-3101
Deep Socket
(size depends
upon receiver)
Chevrolet
Shaftnuts (supplied with receiver)
1. Secure rear support strap under top edge of receiver
mounting bracket speed clipwith and screw as shown
(Figure 1.)
2. Choose the proper spacers (supplied with your order) to
allow receiver nosepiece to extend 1/8” to 1/4” beyond
face of receiver mounting bracket (Figure 2).
3. Secure receiver and faceplate to mounting bracket with
spacers and shaftnuts as shown.
4. Attach receiver control knobs.
5. Install assembly following instructions in the Mastersheet
for your particular vehicle.
Faceplate
Receiver Mounting Bracket
Shaft Assembly Page 3
1/8” - 1/4”
Spacer
Spacers (supplied with your order)
Control Knobs FIGURE 2
Rear Support Strap
Speed Clip
Phillips
Screwdriver
FIGURE 1
®
Copyright 2001 Crutchfield Corporation

Especificaciones del producto

Marca: Metra
Categoría: No categorizado
Modelo: 99-3101

¿Necesitas ayuda?

Si necesitas ayuda con Metra 99-3101 haz una pregunta a continuación y otros usuarios te responderán




No categorizado Metra Manuales

No categorizado Manuales

Últimos No categorizado Manuales