Metra 99-7877 Manual de Usario

Lee a continuación 📖 el manual en español para Metra 99-7877 (7 páginas) en la categoría No categorizado. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/7
METRA. The World’s best kits.metraonline.com © COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
REV. 3/9/2016 INST99-7877
Installation instructions for part 99-7877
CAUTION!
All accessories, switches, climate controls panels, and
especially air bag indicator lights must be connected before cycling
the ignition. Also, do not remove the factory radio with the key in the
on position, or while the vehicle is running.
DIN radio provision with pocket
ISO DIN radio provision with pocket
ISO DDIN radio provision
Painted to match factory dash
99-7877S = Silver, 99-7877B = Matte Black
A) Radio housing • B) ISO brackets • C) ISO trim plate • D) ISO DDIN brackets • E) ISO DDIN trim plate • F) Pocket
20;-,(;<9,:
20;*64765,5;:
>0905.(5;,55(*655,*;065: (sold separately)
Wiring Harness:70-1729
Antenna Adapter: • 40-HD10 • 40-HD11 (with NAV)
Panel removal tool Phillips screwdriver • 8mm Socket wrench
;663:9,8<09,+
Honda Fit 2009-2013
99-7877 Dash Disassembly ..................................................2
Kit Preparation ........................................................3
Kit Assembly
DIN radio provision with pocket ............................ 4
ISO DIN radio provision with pocket ...................... 5
ISO DDIN radio provision ...................................... 6
Table of Contents
A B FEDC
99-7877
2
Dash Disassembly
1. Unclip and remove the lower
center panel below radio. (Figure A)
2. Remove (1) 8mm bolt facing up
behind center panel.
Slide the recirculation 5V[L!
control lever to FRESH for better
access to bolt. (Figure A)
3. Open the upper glove box then use
a pry tool to unclip and remove the
radio/climate control assembly.
(Figure B & C)
(Figure A)
(Figure B)
(Figure C)
4. Remove (2) Phillips screws
securing the hazard switch
to the back of the factory
radio panel. (Figure D)
5. Remove (2) Phillips screws
securing the air bag light to
the back of the factory radio
panel. (Figure E)
6. Remove (5) Phillips screws
securing the A/C vents to
the radio panel.
7. Remove (7) retaining clips
from radio housing to be
used later in kit preparation.
Continue to kit preparation
(Figure D)
(Figure E)
Rear factory radio panel
Rear factory radio panel
99-7877
Kit Preparation
3
(Figure A) (Figure B)
1. Secure the hazard switch into the
radio housing panel using the
factory hardware. (Figure A)
2. Secure the air bag light into the
radio housing panel using the
factory hardware. (Figure A)
3. Secure the A/C vents to the
radio housing using the factory
hardware. (Figure B)
4. Attach the (7) retaining clips to the
radio housing panel in the same
location as removed from the
factory radio panel.

Especificaciones del producto

Marca: Metra
Categoría: No categorizado
Modelo: 99-7877

¿Necesitas ayuda?

Si necesitas ayuda con Metra 99-7877 haz una pregunta a continuación y otros usuarios te responderán




No categorizado Metra Manuales

No categorizado Manuales

Últimos No categorizado Manuales