Metra LC-GMRC-LAN-09 Manual de Usario

Metra No categorizado LC-GMRC-LAN-09

Lee a continuación 📖 el manual en español para Metra LC-GMRC-LAN-09 (8 páginas) en la categoría No categorizado. Esta guía fue útil para 5 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/8
LC-GMRC-LAN-09
I N S TA L L AT I O N I N S T R U C T I O N S
AxxessInterfaces.com © COPYRIGHT 2019 METRA ELECTRONICS CORPORATION REV. 5/30/19 INSTLC-GMRC-LAN-09
Attention! Let the vehicle sit with the key
out of the ignition for a few minutes before
removing the factory radio. When testing the
aftermarket equipment, ensure that all factory
equipment is connected before cycling the
key to ignition.
INTERFACE COMPONENTS
TOOLS REQUIRED
• Crimping tool and connectors, or solder gun,
solder, and heat shrink • Tape • Wire cutter
• Zip ties
TABLE OF CONTENTS
Connections ............................................................2
Installation .............................................................3
Programming .........................................................3
APPLICATIONS
Chevrolet
Colorado 2015-2018(1)
Equinox 2018(1)
Malibu 2016-2018(2)
Silverado 2015-2018(3)
Silverado 1500 2014(3)
Suburban 2015-up
Tahoe 2015-up
GMC
Canyon 2015-2018(1)
Sierra 2015-2018(3)
Sierra 1500 2014(3)
Yukon / Yukon XL 2015-up
• LC-GMRC-LAN-09 interface • LC-GMRC-LAN-09 harness
• (1) • (2) With RPO code I05 or I06 With radio code IP1 With radio code IO3, IO5, or IO6• (3)
The RPO code is located in the Service Parts Identification sticker
INTERFACE FEATURES
GM Data Interface 2014-up
Provides accessory power (10-amp)
Retains R.A.P. (retained
accessory power)
Provides wires for multimedia
radios (park brake, reverse,
speed sense)
• Used in non-amplified models, or
when bypassing a factory amp
Designed for models without
OnStar
Retains all warning chimes
High level speaker input
Retains balance and fade
• Provides illumination output
Micro-B USB updatable
Visit AxxessInterfaces.com for more detailed information about the product and up-to-date
vehicle specific applications
2
CONNECTIONS
From the LC-GMRC-LAN-09 harness to the aftermarket radio:
Connect the wire to the ground wire.Black
Connect the Yellow wire to the battery wire.
Connect the wire to the accessory wire.Red
If retaining the factory AUX-IN jack, connect the & RCA jacks to the AUX input.Red White
If the aftermarket radio has an illumination wire, connect the wire to it.Orange
Connect the wire to the left front positive speaker output.White
Connect the wire to the left front negative speaker output.White/Black
Connect the wire to the right front positive speaker output.Gray
Connect the Gray/Black wire to the right front negative speaker output.
Connect the wire to the left rear positive speaker output.Green
Connect the wire to the left rear negative speaker output.Green/Black
Connect the wire to the right rear positive speaker output.Purple
Connect the wire to the right rear negative speaker output.Purple/Black
The following (3) wires are only for multimedia/navigation radios that require these wires.
Connect the wire to the VSS/speed sense wire.Blue/Pink
Connect the wire to the reverse wire.Green/Purple
Connect the wire to the parking brake wire.Light Green
3
REV. 5/30/2019 INSTLC-GMRC-LAN-09
INSTALLATION
PROGRAMMING
With the key in the off position:
1. Locate the factory radio harness in the vehicle and complete all necessary connections to the
aftermarket radio.
2. Connect the LC-GMRC-LAN-09 harness LC-GMRC-LAN-09 interface into the , and then to the
factory radio harness in the vehicle.
Note: For the Equinox and Malibu, use part number AX-GMLAN09EXT (sold separately) to extend
the wiring harness to the right of the glovebox where the radio brain is located at.
Attention: If the interface loses power for any reason, the following steps will need to be
performed again.
1.
Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on
.
If the radio does not come on within 60 seconds, turn the key to the off position, Note:
disconnect the interface, check all connections, reconnect the interface, and then try again.
2.
Cycle the key off. If the driver’s door is closed, open and close the door. Cycle the key back on.
3. Test all functions of the installation for proper operation, before reassembling the dash.

Especificaciones del producto

Marca: Metra
Categoría: No categorizado
Modelo: LC-GMRC-LAN-09

¿Necesitas ayuda?

Si necesitas ayuda con Metra LC-GMRC-LAN-09 haz una pregunta a continuación y otros usuarios te responderán




No categorizado Metra Manuales

No categorizado Manuales

Últimos No categorizado Manuales