Metra XSVI-5524-NAV Manual de Usario

Metra No categorizado XSVI-5524-NAV

Lee a continuación 📖 el manual en español para Metra XSVI-5524-NAV (4 páginas) en la categoría No categorizado. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/4
XSVI-5524-NAV
I N S T A L L A T I O N I N S T R U C T I O N S
AxxessInterfaces.com © COPYRIGHT 2019 METRA ELECTRONICS CORPORATION REV. 11/12/19 INSTXSVI-5524-NAV
Product Info
INTERFACE FEATURES
INTERFACE COMPONENTS
TOOLS & INSTALLATION ACCESSORIES REQUIRED
• Crimping tool and connectors, or solder gun,
solder, and heat shrink • Tape • Wire cutter
• Zip ties • Multimeter
Ford Data Interface 2011-Up
APPLICATIONS
Provides accessory power (12 volt 10 amp)
Retains R.A.P. (retained accessory power)
Provides illumination, parking brake, reverse, and speed sense outputs
Prewired ASWC-1 harness (ASWC-1 sold separately)
Retains balance and fade
Micro-B USB updatable
Note: The XSVI-5524-NAV does not retain SYNC.
Ford
Escape (S trim) 2019
Escape (w/ 4.2-inch screen) 2013-2018
F-250/350/450/550
(w/o 4.2-inch color screen) 2017-Up
Fiesta (w/ SYNC) 2011-2013
Fiesta (w/o 6-inch MyFord
Touch radio) 2014-2015
Fiesta (w/o 6-inch SYNC 3 radio) 2016-2019
Focus (w/o 6-inch MyFord
Touch radio) 2012-2014
Transit (w/ CD player, w/o NAV) 2015-Up
Transit Connect
(w/ CD player, w/o NAV) 2015-2018
• XSVI-5524-NAV Interface
• XSVI-5524-NAV Harness
TABLE OF CONTENTS
Connections ............................................................2
Installation .............................................................3
Programming .........................................................3
2
CONNECTIONS
From the 16-pin harness with stripped leads to the aftermarket radio, connect the:
wire to the ground wire.Black
Yellow wire to the battery wire.
wire to the accessory wire.Red
Orange wire to the illumination wire (if applicable).
wire to the power antenna wire.Blue
wire to the front right positive speaker output.Gray
Gray/Black wire to the front right negative speaker output.
White wire to the front left positive speaker output.
White/Black wire to the front left negative speaker output.
Green wire to the rear left positive speaker output.
Green/Black wire to the rear left negative speaker output.
wire to the rear right positive speaker output.Purple
wire to the rear right negative output.Purple/Black
The following (3) wires are only for multimedia/navigation radios that require these wires.
Light Green wire to the parking brake wire.
wire to the VSS or speed sense wire.Blue/Pink
Green/Purple wire to the reverse wire.
12-pin ASWC-1 harness & 3.5mm jack:
The 12-pin harness & 3.5mm jack is to be used with the (sold separately) to ASWC-1 ASWC-1
retain steering wheel audio controls. If the is not being used, disregard this harness. ASWC-1
If it is to be used, refer to the instructions for radio connections and programming. ASWC-1
Disregard the harness that comes with the .ASWC-1
3
REV. 11/12/2019 INSTXSVI-5524-NAV
INSTALLATION PROGRAMMING
With the key in the off position:
Connect the 1. XSVI-5524-NAV harness into the XSVI-5524-NAV interface, and then to the
wiring harness in the vehicle.
Note: If installing an ASWC-1, connect it after you program and test the XSVI-5524-NAV, with
the key in the off position.
Attention! If the interface loses power for any reason, the following steps will need to be
performed again.
Cycle the engine on.1.
Note: If the radio doesn’t come on within 60 seconds, turn the key to the off position,
disconnect the interface, check all connections, reconnect the interface, and then try again.
Cycle the ignition off, then back on.2.
Test all functions of the installation for proper operation.3.

Especificaciones del producto

Marca: Metra
Categoría: No categorizado
Modelo: XSVI-5524-NAV

¿Necesitas ayuda?

Si necesitas ayuda con Metra XSVI-5524-NAV haz una pregunta a continuación y otros usuarios te responderán




No categorizado Metra Manuales

No categorizado Manuales

Últimos No categorizado Manuales