Microchip PIC32MX695F512H Manual de Usario

Microchip No categorizado PIC32MX695F512H

Lee a continuación 📖 el manual en español para Microchip PIC32MX695F512H (96 páginas) en la categoría No categorizado. Esta guía fue útil para 4 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/96
© 2009-2017 Microchip Technology Inc. DS60001155D-page 35-1
Section 35. Ethernet Controller
This section of the manual contains the following major topics:
35.1 Introduction .............................................................................................................. 35-2
35.2 Ethernet Controller Overview .................................................................................. 35-3
35.3 Status and Control Registers................................................................................... 35-4
35.4 Operation...............................................................................................................35-43
35.5 Ethernet Interrupts................................................................................................. 35-82
35.6 Operation in Power-Saving and Debug Modes ..................................................... 35-87
35.7 Effects of Various Resets....................................................................................... 35-90
35.8 I/O Pin Control ....................................................................................................... 35-91
35.9 Related Application Notes ..................................................................................... 35-92
35.10 Revision History..................................................................................................... 35-93
PIC32 Family Reference Manual
DS60001155D-page 35-2 © 2009-2017 Microchip Technology Inc.
35.1 INTRODUCTION
The Ethernet Controller is a bus master module that interfaces with an off-chip PHY to implement
a complete Ethernet node in an embedded system.
The following are key features of the Ethernet Controller module:
Supports 10/100 Mbps data transfer rates (see the Caution note in 35.4 “Operation”)
Supports the full-duplex and half-duplex operation
Supports the Reduced Media Independent Interface (RMII) and Media Independent
Interface (MII) PHY interface
Supports the MII Management (MIIM) PHY Management interface
Supports manual and automatic Flow Control
Supports Auto-MDIX and enabled PHYs
RAM descriptor based Direct Memory Access (DMA) operation for receive and transmit
path
Fully configurable interrupts
Configurable receive packet filtering
- Cyclic Redundancy Check (CRC)
- 64-byte pattern match
- Broadcast, multicast, and unicast packets
- Magic Packet™
- 64-bit Hash table
- Runt packet
Supports Packet Payload Checksum calculation
Supports various hardware statistics counters
Note: This family reference manual section is meant to serve as a complement to device
data sheets. Depending on the device variant, this manual section may not apply to
all PIC32 devices.
Please consult the note at the beginning of the “Ethernet Controller” chapter in
the current device data sheet to check whether this document supports the device
you are using.
Device data sheets and family reference manual sections are available for
download from the Microchip Worldwide Web site at: http://www.microchip.com
Note: To avoid cache coherency problems on devices with L1 cache, it is recommended
to access the Ethernet buffers from the KSEG1 segment.
© 2009-2017 Microchip Technology Inc. DS60001155D-page 35-3
Section 35. Ethernet Controller
35.2 ETHERNET CONTROLLER OVERVIEW
The Ethernet Controller provides the modules needed to implement a 10/100 Mbps Ethernet
node uses an external PHY chip. To offload the CPU from a moving packet data to and from the
module, the internal descriptor based DMA engines are included in the controller.
The Ethernet Controller consists of the following modules:
Media Access Control (MAC) block: This module implements the MAC functions of the
IEEE 802.3
Specification
Flow Control block: This module controls the transmission of PAUSE frames. Reception of
PAUSE frames is handled within the MAC
RX Filter (RXF) block: This module performs filtering on every receive packet to determ ine
whether each packet to be accepted or rejected
TX DMA/TX Buffer Management (BM) Engine: The TX DMA and TX BM engines perform
data transfers from the system memory (using descriptor tables) to the MAC transmit
interface
RX DMA/RX BM Engine: The RX DMA and RX BM engines transfer receive packets from
the MAC to the system memory (using descriptor tables)
Figure 35-1 illustrates the block d iagram of the Ethernet Controller.
Figure 35-1: Ethernet Controller Block Diagram
Note: Refer to the “Ethernet Theory of Operation” (DS01120) for more information on the
Ethernet operation and the IEEE 802.3 Specification (www.ieee.org).
TX Bus
Master
System BUS
RX Bus
Master
TX DMA
TX Flow Control
Host I/F
RX DMA
RX Filter
Checksum
MAC External
PHY
MII/RMII
I/F
MIIM
IF
MAC Control
and
Configuration
Registers
TX Function
RX Function
DMA
Control
Registers
Fast Peripheral Bus
Ethernet Controller
RX Flow
Control
Ethernet DMA
RX BM
TX BM
TX
FIFO
RX
FIFO

Especificaciones del producto

Marca: Microchip
Categoría: No categorizado
Modelo: PIC32MX695F512H

¿Necesitas ayuda?

Si necesitas ayuda con Microchip PIC32MX695F512H haz una pregunta a continuación y otros usuarios te responderán




No categorizado Microchip Manuales

No categorizado Manuales

Últimos No categorizado Manuales