Middle Atlantic Products SRS4-14 Manual de Usario

Lee a continuación 📖 el manual en español para Middle Atlantic Products SRS4-14 (4 páginas) en la categoría No categorizado. Esta guía fue útil para 3 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/4
I-0900 Rev J
THANK YOU
Thank you for purchasing the SRS Series. Please read these instructions
thoroughly before installing/assembling this product.
Page 2
12 MOUNTING
HOLES
BOTTOM
PAN
LOCKING
PANEL
SQUARING
PANEL
1) Position and center SRS in millwork with setback
desired.
2) Using 2 preliminary mounting hole locations attach
the SRS to the millwork.
PRELIMINARY
MOUNTING
HOLES
3) Remove "Locking Panel" and slide rack out
4) Secure SRS using 12 mounting points indicated
in drawing.
(4x)
(4x)
(4x)
5) Attach rackrail to the sliding section using hardware
provided, finger tighten only.
6) Install squaring panel approximately 1/3 of the way
down from the top of the rackrail using hardware
provided. NOTE: The squaring panel remains in place
until some of the equipment is loaded.
7) Final tighten the rackrail to the sliding section.
8) Test the sliding carriage operation. Adjust mounting
positions as necessary should interference with the
millwork occur.
9) Attach the Locking panel.
10) Rail Stops serve to maintain a plumb position when rack
is closed. Mount 2 stops per side in the highest position
possible while maintaining contact with the backside of
the rackrail in the closed position. Wood screws are
for this provided attachment. (see illustration above)
RAIL STOPS
(stack 2 per side)
NOTE: If optional cable carrier
is used it must be
installed prior to rackrail.
(See PAGE 2)
Page 3
OPTIONAL
SRS Cable Carrier Instructions
1) Attach the Hinge Mounting Plate
to the rear surface of the SRS bottom
pan with four 10-32 socket head screws.
2) Attach the Cable Carrier Hinge to the
rear of the Hinge Mounting Panel with
four 10-32 socket head screws.
3) Attach front of Cable Carrier to the
SRS Chassis with four 10-32 socket
head screws
NOTE: Carefully examine drawing
for details of which side hinge
mounting panel goes to
BOTTOM PAN HINGE MOUNTING
PLATE
SRS REAR RAILS
SRS Series rough-in pan
mounting point locations
3x 18.125
3x 12.125
4x 17.34
18.69
15.95
11.0
8.0
.000
(from trim)
9.55
19.09
FRONT
4x 13.97
2.95
4x 1.59
3.95
(only mounting holes shown)

Especificaciones del producto

Marca: Middle Atlantic Products
Categoría: No categorizado
Modelo: SRS4-14

¿Necesitas ayuda?

Si necesitas ayuda con Middle Atlantic Products SRS4-14 haz una pregunta a continuación y otros usuarios te responderán




No categorizado Middle Atlantic Products Manuales

No categorizado Manuales

Últimos No categorizado Manuales