Mount-It! MI-397 Manual de Usario
Mount-It!
soporte de panel plano
MI-397
Lee a continuación 📖 el manual en español para Mount-It! MI-397 (2 páginas) en la categoría soporte de panel plano. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios
Página 1/2
please contact us
(Mount-It!) for assistance.
(Mount-It!) for a replacement.
please contact us
SKU: MI-397
TV Wall Mount with Extra Long Extension
The angle of the screen can be adjusted down up to 10 degrees and up 5 degrees. To adjust the tilt angle
of the TV, loosen the tilt adjustment nuts shown here then adjust the tilt to the desired angle then tighten the
nuts back down.
Note: If the screen tilts down slowly over time adjust the screen back to the proper angle and ensure the tilt
adjustment nuts are firmly tightened.
The mount allows up to 3 degrees of levelling adjustment post installation. To adjust the level of the TV
loosen the 2 nuts located behind the rectangular VESA plate, level the TV then tighten the 2 nuts again to
secure the TV in position.
Tilt Adjustment
4Levelling Adjustment
5
We recommend using professional installation services if you are unable to follow the instructions provided in this manual.
(855)- 925-5668
Please scan this QR code
to visit the product page.
+5°
-10°
S-5
-3° +3°
S-5
ø 6mm
(ø 1/4")
90mm
(3.5")
Wood Stud Installation Option
Attach the TV to the VESA Arms (No Spacers)
Attach the TV to the VESA Arms (With Spacers)
MI-397 80
WARNING: This installation manual is intended to provide guidance on how to install the TV mount and the TV on a suitable wall.
Please contact a qualified professional if you are unsure of the steps described in the manual or have doubts about the safety of the
installation. Improper installation may cause damage or serious injury. We cannot be held liable for damage or injury caused by
improper mounting. Incorrect assembly, inappropriate use or for use cases not explicitly specified in this document. If unsure, please
contact us at www.mount-it.com. Email at support@mount-it.com, or call us at 1 (855)- 925-5668
Mount and Accessories
TV Mounting Hardware
Wall Mounting Hardware
CHOKING HAZARD. Package includes small parts. Not for children under 3 years. Adult supervision is required
Check carefully to make sure there are no missing or defective parts. Some hardware provided may not be used.
Use the correct monitor mounting hardware suitable for your installation.
1. Use a stud finder to locate the wall studs and mark their location with a pencil.
2. Hold, tape or secure the Wall Template (#L) to the wall at the desired installation location. Use a bubble
level to ensure the straightness of the Wall Template (#L) and on the center of the studs mark the locations
for the 4 Lag Screws as shown. Once marked, remove the Wall Template.
3. Use a 1/4” drill bit and drill on the marked locations to a depth of 3.5”.
4. Hold the Mount (#M) to the wall over the holes and secure to the wall using all 4 Lag Screws (#A) and
Lag Washers (#B).
Select the appropriate size Mounting Bolt (Select one size #D, #E) and Square Washer (#C) for your
display’s mounting holes and verify the length of the VESA bolt is not too long. If you are unsure of the
correct bolt size for your display refer to your TV user manual or contact the TV manufacturer for sizing
information. Attach the 2 VESA Arms (#N) to the back of your TV using the selected bolts and washer.
If necessary, use the included spacers (#I, J) between the mount and the screen as shown above to adjust
the length of the mounting bolt. Multiple spacers can be used in combination to achieve the desired bolt
depth.
Select the appropriate size Mounting Bolt (Select one size #F, #G,#H) and Square Washer (#C) for your
display’s mounting holes and verify the length of the VESA bolt is not too long. If you are unsure of the
correct bolt size for your display refer to your TV user manual or contact the TV manufacturer for sizing
information. Attach the 2 VESA Arms (#N) to the back of your TV using the selected bolts, washer and
spacers.
Hang the TV on the mount arms as shown in the diagram. Caution: Use the help of a second person for
safe lifting and easier installation.
Attach the Safety Clips (#S-1 and #S-2) to the bottom of the VESA arms as shown here, and secure them
in place using Safety Bolts (#S-3).
1.Hold, tape or secure the Wall Template (#L) to the wall at the desired installation location. Use a bubble
level to ensure the straightness of the Wall Template and mark the locations for the 5 Lag Screws as
shown, then remove the template.
2.Use a 2/5” drill bit and drill on the marked locations to a depth of 3.7”. Note: Do not drill mounting holes
into mortar (such as between bricks or stones) only drill and install into solid stone or concrete surfaces.
3.Clear any dust and debris from the holes and insert the 5 Concrete Anchors (#K). Hold the Mount (#M) to
the wall over the holes and secure to the wall using all 5 Lag Screws (#A) and Lag Washers (#B).
Hang the TV on the Mount Arms
3
1a
2a
2b
55kg
(121lbs)
Wall Mount
M (x1)
VESA Arms
N (x2)
Wall Template
L (x1)
Hex Wrench
S-4 (x1)
S-1 (x1)
Security Clips
S-2 (x1)
Security Bolt
S -3 (x2)
Wrench
S-5 (x1)
Square Washer
C (x4)
15mm Spacer
I (x4)
5mm Spacer
J (x4)
Concrete Anchor
K (5)
M4 14x (x4)
D
M6 14x (x4)
E
M6 30x (x4)
F
M8x20 (x4 )
G
M8 45x (x4)
H
Lag Screw
A(x5)
Lag Washer
B (x5)
132
X X
√
L
16/24 inches
Level the wall plate
M
6mm(1/4”)
B A
90mm (3.5”)
Concrete/Stone Installation Option
1b 95mm
(3.7")
ø 10 mm
(ø 2 /5")
LM
BA
K
2
1
X X
√
TV
D/E
C
TV
G
C
J
F
C
I
F/H
C
IJ
S-1/S-2
S-3
Especificaciones del producto
| Marca: | Mount-It! |
| Categoría: | soporte de panel plano |
| Modelo: | MI-397 |
¿Necesitas ayuda?
Si necesitas ayuda con Mount-It! MI-397 haz una pregunta a continuación y otros usuarios te responderán
soporte de panel plano Mount-It! Manuales
17 Septiembre 2024
17 Septiembre 2024
17 Septiembre 2024
17 Septiembre 2024
17 Septiembre 2024
17 Septiembre 2024
17 Septiembre 2024
17 Septiembre 2024
17 Septiembre 2024
16 Septiembre 2024
soporte de panel plano Manuales
- soporte de panel plano Samsung
- soporte de panel plano HP
- soporte de panel plano Abus
- soporte de panel plano Acco
- soporte de panel plano Hitachi
- soporte de panel plano SilverStone
- soporte de panel plano 3M
- soporte de panel plano GPX
- soporte de panel plano Manhattan
- soporte de panel plano Vision
- soporte de panel plano Kensington
- soporte de panel plano Nec
- soporte de panel plano BlueBuilt
- soporte de panel plano Da-Lite
- soporte de panel plano Luxor
- soporte de panel plano Steren
- soporte de panel plano Digitus
- soporte de panel plano Insignia
- soporte de panel plano Sanus
- soporte de panel plano Peerless-AV
- soporte de panel plano Vogels
- soporte de panel plano Fellowes
- soporte de panel plano Sven
- soporte de panel plano Valueline
- soporte de panel plano One For All
- soporte de panel plano Ematic
- soporte de panel plano Newstar
- soporte de panel plano Ewent
- soporte de panel plano BakkerElkhuizen
- soporte de panel plano Ultimate
- soporte de panel plano Peerless
- soporte de panel plano Proaim
- soporte de panel plano Monoprice
- soporte de panel plano Chief
- soporte de panel plano Ergotron
- soporte de panel plano Gabor
- soporte de panel plano Atdec
- soporte de panel plano StarTech.com
- soporte de panel plano SIIG
- soporte de panel plano Bell'O
- soporte de panel plano B-tech
- soporte de panel plano Speaka
- soporte de panel plano Crimson
- soporte de panel plano Kogan
- soporte de panel plano Schwaiger
- soporte de panel plano Cabstone
- soporte de panel plano V7
- soporte de panel plano Bretford
- soporte de panel plano SmartMetals
- soporte de panel plano Unicol
- soporte de panel plano Zaor
- soporte de panel plano Dataflex
- soporte de panel plano Multibrackets
- soporte de panel plano Anthro
- soporte de panel plano AMX
- soporte de panel plano Rocstor
- soporte de panel plano CTA Digital
- soporte de panel plano Amer
- soporte de panel plano Avteq
- soporte de panel plano Walker Edison
- soporte de panel plano My Wall
- soporte de panel plano LTN Technologies
- soporte de panel plano Heckler
- soporte de panel plano Helder
Últimos soporte de panel plano Manuales
27 Octubre 2024
15 Octubre 2024
15 Octubre 2024
4 Octubre 2024
2 Octubre 2024
1 Octubre 2024
1 Octubre 2024
1 Octubre 2024
1 Octubre 2024
1 Octubre 2024