PAC LCGM24 Manual de Usario

Lee a continuación 📖 el manual en español para PAC LCGM24 (1 páginas) en la categoría No categorizado. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/1
LCGM24
Radio Replacement Interface for General Motors Vehicles
Pacic Accessory Corporation
® | Santa Ana, California 92705 | Ph. 866-931-8021 | support@pac-audio.com
©2013 Pacic Accessory Corporation
www.pac-audio.com
Rev. 050213
P ifi A C ti
P ifi A C ti
The LCGM24 allows the replacement of a factory radio in select General Motors vehicles with Class II radios. Using this interface
will retain factory features such as warning chimes and provides a data-bus generated 12-volt retained accessory power output
(RAP). RAP keeps the radio powered after key-off, just like the factory system. The LCGM24 also issues data commands that
maintain a “healthy” system status to other vehicle systems.
Introduction & Features
Installation Steps
PLEASE NOTE: This Interface is intended
for use in vehicles without OnStar® or
Bose® or when OnStar® or Bose® does
not need to be retained.
1. Wire your aftermarket radio to the LCGM24’s
harness according to the wiring connections chart.
The red accessory wire will support up to 10 amps
of current draw.
2. Remove the factory radio and plug in the LCGM24’s
24-pin harness into the factory vehicle harness.
Using the supplied length of wire, mount the
interface within the dash of the vehicle with double
sided tape or wire ties. There are no adjustments
to make, just mount your aftermarket radio and re-
install your factory dash panels and youre done!
1. Turn the ignition on. The LED on the interface will turn on & the +12v accessory wire will turn on.
2. Turn on the radio & check balance & fade.
3. Turn off vehicle & remove key. RAP will be active & keep the radio on for 10 minutes or until the drivers door is opened.
4. The LED & radio will turn off when RAP turns off or the drivers door is opened.
Testing & Verication
Illustration / Schematic
Yellow Battery +12v
Black Ground
Red Accessory +12v
(10A)
Blue Antenna On Input
White Front L + input
White / Black Front L - input
Grey Front R + input
Grey / Black Front R - input
Green Rear L + input
Green / Black Rear L - input
Purple Rear R + input
Purple / Black Rear R - input
Wiring Connections
Aftermarket Radio
Connections
To Vehicle
Connector

Especificaciones del producto

Marca: PAC
Categoría: No categorizado
Modelo: LCGM24

¿Necesitas ayuda?

Si necesitas ayuda con PAC LCGM24 haz una pregunta a continuación y otros usuarios te responderán




No categorizado PAC Manuales

PAC

PAC RP4-GM31 Manual de Usario

19 Septiembre 2024
PAC

PAC NU-GM51 Manual de Usario

19 Septiembre 2024
PAC

PAC NAV-1129 Manual de Usario

19 Septiembre 2024
PAC

PAC LP7-2R Manual de Usario

19 Septiembre 2024
PAC

PAC LP7-4 Manual de Usario

19 Septiembre 2024
PAC

PAC GMK367B Manual de Usario

19 Septiembre 2024
PAC

PAC CP1-FRD1 Manual de Usario

19 Septiembre 2024
PAC

PAC C2A-CHY5 Manual de Usario

19 Septiembre 2024
PAC

PAC NU-GM3 Manual de Usario

19 Septiembre 2024
PAC

PAC CP1-TSL1 Manual de Usario

19 Septiembre 2024

No categorizado Manuales

Últimos No categorizado Manuales