PAC LCGM51 Manual de Usario

Lee a continuación 📖 el manual en español para PAC LCGM51 (1 páginas) en la categoría No categorizado. Esta guía fue útil para 2 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/1
LCGM51
Radio Replacement Interface for General Motors Vehicles
Pacic Accessory Corporation
® | Clearwater, Florida 33760 | Ph. 866-931-8021 | support@pac-audio.com
©2015 Pacic Accessory Corporation
www.pac-audio.com
Rev. 012915
P ifi A C ti
P ifi A C ti
The LCGM51 allows the replacement of a factory radio in select General Motors vehicles with 29-bit v2 GMLAN radios. Using this
interface will retain factory features such as warning chimes and provides a data-bus generated 12-volt retained accessory power
output (RAP). RAP keeps the radio powered after key-off, just like the factory system. The LCGM51 also issues data commands
that maintain a “healthy” system status to other vehicle systems.
Introduction & Features
Installation Steps
PLEASE NOTE: This Interface is intended
for use in vehicles without OnStar® or
Bose® or when OnStar® or Bos does
not need to be retained.
1. Wire your aftermarket radio to the LCGM51 harness
according to the wiring connections chart. The
red accessory wire will support up to 10 amps of
current draw.
2. Remove the factory radio and plug in the LCGM51’s
14/16-pin harness into the factory vehicle harness.
Using the supplied length of wire, mount the
interface within the dash of the vehicle with double
sided tape or wire ties. There are no adjustments
to make, just mount your aftermarket radio and re-
install your factory dash panels and you’re done!
1. Turn the ignition on. The LED on the interface will turn on & the +12v accessory wire will turn on.
2. Turn on the radio & check balance & fade.
3. Turn off vehicle & remove key. RAP will be active & keep the radio on for 10 minutes or until the drivers door is opened.
4. The LED & radio will turn off when RAP turns off or the drivers door is opened.
Testing & Verication
Illustration / Schematic
Yellow Battery +12v
Black Ground
Red Accessory +12v
(10A)
White Front L + input
White / Black Front L - input
Grey Front R + input
Grey / Black Front R - input
Green Rear L + input
Green / Black Rear L - input
Purple Rear R + input
Purple / Black Rear R - input
Wiring Connections
Aftermarket Radio
Connections
To Vehicle
Connector
Connect to
LCGM51 module
Acc On
LED
LCGM51

Especificaciones del producto

Marca: PAC
Categoría: No categorizado
Modelo: LCGM51

¿Necesitas ayuda?

Si necesitas ayuda con PAC LCGM51 haz una pregunta a continuación y otros usuarios te responderán




No categorizado PAC Manuales

PAC

PAC RP4-GM31 Manual de Usario

19 Septiembre 2024
PAC

PAC NU-GM51 Manual de Usario

19 Septiembre 2024
PAC

PAC NAV-1129 Manual de Usario

19 Septiembre 2024
PAC

PAC LP7-2R Manual de Usario

19 Septiembre 2024
PAC

PAC LP7-4 Manual de Usario

19 Septiembre 2024
PAC

PAC GMK367B Manual de Usario

19 Septiembre 2024
PAC

PAC CP1-FRD1 Manual de Usario

19 Septiembre 2024
PAC

PAC C2A-CHY5 Manual de Usario

19 Septiembre 2024
PAC

PAC NU-GM3 Manual de Usario

19 Septiembre 2024
PAC

PAC CP1-TSL1 Manual de Usario

19 Septiembre 2024

No categorizado Manuales

Últimos No categorizado Manuales