Pioneer DVR-117D Manual de Usario

Pioneer No categorizado DVR-117D

Lee a continuación 📖 el manual en español para Pioneer DVR-117D (2 páginas) en la categoría No categorizado. Esta guía fue útil para 9 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/2

Step 1 – Prepare the Computer

1) Turn OFF the computer and disconnect the power cord.

2) Remove the bezel and the open drive bay cover from the computer’s front panel.

Note: Your computer may be a tower

model as shown on the left or a

desktop model as shown below. This

drive works in either PC model style.

Step 2 – Prepare the Drive

3) Attach slide rails to the drive if required for your drive model.

Slide rails are sold separately through computer retailers.

4) Position the drive close to the open computer bay.

Horizontal Installation Vertical Installation

Step 3 – Connect the Cables

5) Connect the power cable from the computer to the drive.

Pay close attention to the polarity of the cable.

6) Connect the IDE cable to the drive.

C onfirm that Pin 1 on the drive corresponds to Pin 1 on the cable.

7) Connect the drive’s audio output to the sound card if one is present.

Step 4 – Finish the Installation

8) Place the mounting screws in the appropriate holes and tighten by hand.

When mounting screws are loose, vibrations from the spinning disc may cause a ripping sound.

9) Replace the bezel and power ON the computer.

Setting the Jumper For Use in a Master/Slave PC

If you have a Master/Slave type of computer, you probably have two IDE channels, Primary and Secondary. The hard

drive is using the Primary IDE channel and any drives are using the Secondary channel. Install this drive as the Master

device on the Secondary channel and any other devices as Slaves to this new drive. Follow the directions below to

change your older drives or other equipment on the Secondary channel to a Slave device.

1) Disconnect the following drive cables in the order listed below.

 Power cable

 IDE cable

 Audio cable

2) Remove the drive from the drive bay.

3) Use your fingers or a tool to move the jumper to the new setting.

4) Return the drive to the drive bay.

5) Reconnect the cables in the reverse order, Audio, IDE then Power.

Jumper: (jumpered = ON; no jumper = OFF)

Set the jumper to select the drive type for your computer.

Pin Name Function

1 MA on Drive set to Master mode

2 SL on Drive set to Slave mode

3 CS on Drive set to Cable Select mode

4 Reserved

5 Reserved

Master Slave Cable Select

Setting the Jumper For Use in a Cable-Select PC

Some computers support a data exchange method called Cable Select. If your PC uses Cable Select then all devices

need to be set to Cable Select as well. Also, the IDE cable must be designed for Cable Select communication.

Simply position the jumper for Cable Select and install the drive according to the instructions beginning on the opposite

side of this paper. No other changes are required when using Cable Select computers.

Do Not jumper the drive to Cable Select unless your PC uses this method.

Especificaciones del producto

Marca:	Pioneer
Categoría:	No categorizado
Modelo:	DVR-117D
Color del producto:	Zwart
Peso.:	1270 g
Longitud del cable:	6.1 m
Nivel de ruido:	- dB
Consumo-anual-de-energía:	- kWu
Rango:	- m
tipo de limpieza:	Droog
Capacidad de polvo:	0.4 l
Potencia máxima de entrada:	- W
Tipo de contenedor de aspiradora:	Zakloos
Uso correcto:	Thuis
Limpia superficies:	Carpet, Hard floor
Plumero:	Ja
Inalámbrico:	Ja
Ancho de la boquilla para limpieza de pisos:	165.1 mm