Sansui HDLCD1909 Manual de Usario
Sansui
Televisor de plasma LCD
HDLCD1909
Lee a continuación 📖 el manual en español para Sansui HDLCD1909 (23 páginas) en la categoría Televisor de plasma LCD. Esta guía fue útil para 10 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios
Página 1/23
19” WIDE TFT LCD TELEVISION WITH DIGITAL TUNER
OWNER’S MANUAL
ATTENTION
If you purchase a universal remote control from your local retailer, please contact the remote manufacturer for
the required programming code.
AIR/CABLE MODE SELECTION
When shipped from the factory, the Signal Type option is set to the “Cable” (Cable Television) mode.
If not using Cable TV, set this menu option to the “Air” position.
Before operating the unit, please read this manual thoroughly.
HDLCD1909
HDLCD1909A
HDLCD1909B
IF CONTACT WITH CUSTOMER SERVICE IS REQUIRED
PLEASE HAVE THE MODEL NUMBER READY PRIOR TO THE CALL
CUSTOMER SERVICE – 1-800-289-0980
ORION WEBSITE
FOR INFORMATION ON OUR OTHER PRODUCTS, PLEASE VISIT OUR WEBSITE AT
www.orionsalesinc.com
39A0601A_En.indd 139A0601A_En.indd 1 6/26/09 4:32:56 PM6/26/09 4:32:56 PM
2
Location of the required Marking
The rating sheet and the safety caution are
on the rear of the unit.
The lightning flash with arrowhead
symbol, within an equilateral triangle
is intended to alert the user to the
presence of uninsulated dangerous
voltage within the product's enclosure
that may be of sufficient magnitude to
constitute a risk of electric shock.
The exclamation point within an
equilateral triangle is intended to
alert the user to the presence of
important operating and maintenance
(servicing) instructions in the literature
accompanying the appliance.
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance with the
FCC Rules could void the user's authority to operate this equipment.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN
OR MOISTURE.
TO PREVENT THE SPREAD OF FIRE, KEEP CANDLES OR OPEN FLAMES AWAY
FROM THIS PRODUCT AT TIMES.
CAUTION: TO PREVENT ELECTRIC SHOCK DO NOT USE THIS POLARIZED PLUG WITH AN
EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE
FULLY INSERTED TO PREVENT BLADE EXPOSURE.
The lamp(s) within this product contain mercury.
Disposal should be in compliance with local, state or
federal laws.
Record the model number and serial number.
Model number _______________ Serial number _______________
39A0601A_En.indd 239A0601A_En.indd 2 6/26/09 4:32:59 PM6/26/09 4:32:59 PM
3
15) Apparatus should not be exposed to dripping or splashing, and objects filled with liquids, such as
vases, should not be placed on the apparatus.
16) An outside antenna system should not be located in the vicinity of overhead power lines or other
electric light or power circuits, or where it can fall into such power lines or circuits. When installing an
outside antenna system, extreme care should be taken to keep from touching such power lines or
circuits, as contact with them might be fatal.
17) Do not overload wall outlets and extension cords, as this can result in a risk of fire or electric shock.
18) Do not push objects through any openings in this unit, as they may touch dangerous voltage points
or short out parts that could result in fire or electric shock. Never spill or spray any type of liquid into
the unit.
19) If an outside antenna or cable system
is connected to the unit, be sure the
antenna or cable system is grounded
to provide some protection against
voltage surges and built-up static
charges, Section 810 of the National
Electrical Code, ANSI/NFPA 70, provides
information with respect to proper
grounding of the mast and supporting
structure, grounding of the lead-in
wire to an antenna discharge unit, size
of grounding conductors, location of
antenna discharge unit, connection to
grounding electrodes, and requirements for the grounding electrode.
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)
ANTENNA LEAD IN WIRE
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAMPS
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)
GROUND
CLAMP
ELECTRIC SERVICE
EQUIPMENT
NEC-NATIONAL ELECTRICAL CODE
S2898A
EXAMPLE OF ANTENNA GROUNDING AS PER THE NATIONAL ELECTRICAL CODE
39A0601A_En.indd 339A0601A_En.indd 3 6/26/09 4:33:02 PM6/26/09 4:33:02 PM
Especificaciones del producto
Marca: | Sansui |
Categoría: | Televisor de plasma LCD |
Modelo: | HDLCD1909 |
¿Necesitas ayuda?
Si necesitas ayuda con Sansui HDLCD1909 haz una pregunta a continuación y otros usuarios te responderán
Televisor de plasma LCD Sansui Manuales
5 Octubre 2024
3 Septiembre 2024
14 Agosto 2024
12 Agosto 2024
11 Agosto 2024
25 Julio 2024
25 Julio 2024
25 Julio 2024
Televisor de plasma LCD Manuales
- Televisor de plasma LCD Sony
- Televisor de plasma LCD Samsung
- Televisor de plasma LCD LG
- Televisor de plasma LCD Philips
- Televisor de plasma LCD Daewoo
- Televisor de plasma LCD Grundig
- Televisor de plasma LCD JVC
- Televisor de plasma LCD Medion
- Televisor de plasma LCD Pioneer
- Televisor de plasma LCD Toshiba
- Televisor de plasma LCD Akai
- Televisor de plasma LCD BenQ
- Televisor de plasma LCD Loewe
- Televisor de plasma LCD Hitachi
- Televisor de plasma LCD Salora
- Televisor de plasma LCD Marantz
- Televisor de plasma LCD Tatung
- Televisor de plasma LCD Ricatech
- Televisor de plasma LCD Viewsonic
- Televisor de plasma LCD Hannspree
- Televisor de plasma LCD Qmedia
- Televisor de plasma LCD Opera
- Televisor de plasma LCD Technostar
- Televisor de plasma LCD Magnavox
- Televisor de plasma LCD Gericom
- Televisor de plasma LCD Bang Olufsen
Últimos Televisor de plasma LCD Manuales
23 Octubre 2024
23 Octubre 2024
23 Octubre 2024
22 Octubre 2024
22 Octubre 2024
22 Octubre 2024
22 Octubre 2024
21 Octubre 2024
20 Octubre 2024
19 Octubre 2024