SereneLife SLPRWAS23 Manual de Usario

SereneLife Limpiador de alta presión SLPRWAS23

Lee a continuación 📖 el manual en español para SereneLife SLPRWAS23 (2 páginas) en la categoría Limpiador de alta presión. Esta guía fue útil para 8 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Descargar PDF

Página 1/2

WARNING: Do not use the appliance before reading the instruction manual

This machine is designed for domestic use only

SLPRWAS23

HIGH PRESSURE WASHER

User Manual

Appliance is leaking

Slight leakage from the appliance pump is normal. lf the leakage increases

contract the authorized customer service.

Storage

In orderto prevent accidents or injuries, keep in mind the weight of the

appliance, pull out the telescopic rod (max length 410mm) when selecting

a storage location for it.

Storing the appliance

1. Park the machine on an even surface.

2. Press the disconnect on the trigger gun and remove the high pressure

hose from the trigger gun.

3. Push the casing of coupling forthe high pressure hose toward the rear

and disconnect the high pressure hose from the appliance.

4. lnsert the trigger gun into the holder.

5. Stow away the mains cable, the high pressure hose and accessories on

the appliance.

Prior to extended storage periods, as during the winter, also observe the

instructions in the care section.

Specication

Model No: SLPRWAS23

Power Supply: 110V

Power: 1200 Watt

Max pressure: Up to 1160+ psi

Water Flow: 300L / per Hour (5L/ per Min.)

Max water pressure: 80bar (8Mpa)

Working pressure: 6.5Mpa

Water temperature: 32-140° F

Environment temperature: 41-122° F

Weight: 14.35 lbs.

Length: 8.5 in

Width: 7.6 in

Height: 17.0 in

Symptom

Cause

Recommended action

Machine refused to

start

1.Machine

not

plugged

2.Defectiv

socket

3.Defective extension

cable

4.1ncorrect mains

voltage

5.Switch

o

6.Fuse has

blown

1. Plug in

machine

2.Try

another socket

3.Try

anothe

extension

cable

4.Check

voltage correctly

5.Turn on

switch

6.Replacefuse

Pump stop

working

Lack of water lead

high

temperature

check water ow

quantity

-put the hose in the

bottle (per

minute

)

Fluctuatin

pressure

1.Spray

lance

blocked

2. Pump is

sucking

air

Impurities

pump

1. Clean lance with

needle

2.Check

that hoses

and

connections

are

airtight

3.Contact

the

dealer

Machine do not

reach

operation

pressure

1.Spray lance blocked or

worn

2.Short supply

water

3.Hose

kinked

4.Filter blocked

5.Hose blocked

1. Clean or change

spray

lance

2.Check

inlet ow

rate

3.Straighte

out

hose

4.Ciean

lter

5.Ciean hose

Trigger gun can be

used

Trigger gun is

locked

Unlock

trigger gun

Machine often starts

and

stops by

itself

1. Safety valve worn

out

2.Pump,high pressure

hose,

trigger

gun

leaking

Contact

the

nearest

service center

2.Contact

the

nearest

service center

Troubleshooting

The content in this instruction manual (include accessories) is kept the nal

modifying and explanation rights

1 10 9 2

www.PyleUSA.comwww.PyleUSA.comwww.PyleUSA.comwww.PyleUSA.comwww.PyleUSA.com

In winter, please do not put the machine outside without draining

the water to avoid the damage to the machine. Just put it in a room

with frost prevention.

Safety instruction

Danger

1. Never touch the mains plug and the socket with wet hands.

2. The appliance must not be used ifthe power cord or important parts

of the appliance, e.g. high pressure hoses, trigger gun or safety devices

are damaged.

Please arrange for it to be replaced immediately by an authorised repair agent

or a skilled electrician.

3. The appliance may not be used in areas where a risk of explosion is

present.

4. The high pressure washer must not be directed at other persons or

directed by the user at him/her self to clean clothing or footwear.

5. lf the appliance is used in hazardous areas (e.g. lling stations) all ofthe

safety provisions and operating instructions detailed in this manual must

be observed.

6. Never use the appliance to clean objects containing hazardous

substances.

7. Vehicle tyres or tyre valves are susceptible to damage from the high

pressure washer and may burst. The rst indication of this is a

discoloration of the tyre.

Damaged vehicle tyres/tyre valves are highly dangerous. Ensure that a

distanc of at least 30 cm is observed when cleaning with the washer.

8. Risk of explosion. Do not spray ammable liquids. Never draw in uids

containing solvents or undiluted acids. This includes petrol, paint thinner

and heating oil. The spray mist thus generated is highly inammable,

explosive and poisonous. Do not use acetone, undiluted acids or solvents

as they are damaging to the materials from which is the appliance is

made.

Warning

1. The mains plug and the coupling of an extension cable must be

watertight and must never lay in the water.

2. Unsuitable extension cables can be hazardous. Only use extension cables

outdoors which have been approved for this purpose and labeled with a

sucient cable cross-section: 1-10m: 1.5mm² 10-30m: 2.5mm²

3. Always fully unroll electrical cables.

4. High pressure hoses, xtures and couplings are important forthe safety

of the appliance. Only use high pressure hoses, xtures and couplings

recommended by the manufacturer.

5. This appliance is not intended for use by persons with reduced physical,

sensory or mental capabilities. The appliance must not be operated by

children or persons who have not been instructed accordingly. Children

should be supervised to prevent them from playing with the appliance.

6. The operator must use the appliance correctly. When working with the

appliance, p2-he must considerthe local conditions and pay due care and

attention to other persons, in particular children who are nearby.

Caution

1. Do not use the machine ifthe persons nearby do not wear safety

protection device.

2. Wearing protective clothing and safety goggles to protect against

splash back containing water or dirt.

3. Create stability for the appliance prior to all work on or with the

appliance to prevent accidents or damage. The stability ofthe appliance is

warranted when it is placed on to an even surface.

4. For safety reasons, we recommend that you operate the appliance only

via an earth-leakage circuit breaker (max. 30mA).

5. Make sure that the power cord or extension cables are not damaged by

running over, pinching, dragging or similar. Protect the power cable from

heat, oil, and sharp edges.

6. Never leave the appliance unattended when it is in operation.

Operation

Package

Please check all accessories before opening the box. lf there is something

missing, please contact the dealers or sellers.

7 4 5 6

4. Install spray lance (pic E).

Push the spray lance into the trigger gun and fasten it by turning it

through 90 degree.

Water Supply

Impurities in the water can damage the high pressure pump and

accessories. All high pressure washer (except hot water system) use the

cold water. The suitable water temperature is 41°F to 140°F

Water supply from mains

Observe water supply regulations

For connection values, use bre-reinforced water hose (not included) with a

standard coupling, normally the length is 5m, connect the water hose to

the appliance and water supply.

1. Open the watertap

2. Unlock the lever on the trigger gun

3. Pull on the lever of the trigger gun

4. Turn on the appliance (pic F ON: open OFF: close)

Start up

Dry runs lasting longer than two minutes lead to damages to the high

pressure pump. lf the appliance does not build up pressure within two

minutes, switch it o and proceed as instructed in the Chapter

“Troubleshooting”. The trigger gun is subjected to recoil force when the

water washer is discharged. Make sure that you have a rm footing and are

also holding the trigger gun and spray lance rmly.

The spray lance has two main settings stream and fan for easy cleaning (pic H).

Illustration

Special accessories expand the possibilities of using your appliance.Please

contact thedealer for further information.

Illustrate accessories before start-up.

1. Install coupling for water connection (pic A).

Screw the coupling to the water connection on the appliance.

2. Install high pressure hose (pic B. pic J).

Insert the high pressure hose tightly in to coupling on the appliance, it

will lock in audibly.

Make sure the connection nipple is aligned correctly.Note:

Check the secure connection by pulling on the high pressure hose.

3. Install the storage of trigger gun (pic C).

Insert the storage of trigger gun and push down all the way.

Caution

Prior to cleaning, make sure that the high pressure washer is placed safely

on level ground. Wear protective goggles and protective clothing during

the cleaning process.

Notes: Release the lever ofthe trigger gun, the device will switch o again.

High pressure washer remains in the system.

Working with detergent

Use detergent when cleaning. Remove the lid from the detergent bottle

and press the detergent bottle into detergent (pic D).

Notes: The device is under low pressure when using detergent and pulling

out spray lance.

Release the lever on the trigger gun, lock the lever on the trigger gun,

insert the spray lance into trigger gun when interrupting operation.

Finish Operation

1. Turn o tap.

2. Press the lever on the trigger gun to release any remaining pressure and

water in the system.

3. Pull out the main plug.

4. Store the water hose and high pressure hose.

Maintenance and Care

Turn o the appliance and remove the mains plug prior to any care and

maintenance work. Prior to longer periods of storage, pull out the lter in

the detergent bottle and clean under running water. Pull out the lter in

the water connection and clean under running water (pic I).

Use the needle to clean the residue (pic L).

CONTENTS

Gerneral Information -----------------------------------------------------------------------3

Safety Instruction -------------------------------------------------------------------------- 4

Operation --------------------------------------------------------------------------------------5

Illustration -------------------------------------------------------------------------------------6

Maintenance and Care -------------------------------------------------------------------- 8

Troubleshooting -----------------------------------------------------------------------------9

Storage -------------------------------------------------------------------------------------- 10

Specication -------------------------------------------------------------------------------- 10

Circuit Diagram -----------------------------------------------------------------------------11

Dear customer,

Pis read and comply with these original instructions prior to the initial

operation of your appliance and store them for later use or subsequent

owners.

General Information

This high pressure washer is designed for domestic use only:

1. To clean cars, motorbikes, caravans, bicycles.

2. To clean patios, fences, garden walls, pathways, driveways and house

facades, particularly useful for cleaning blocked driveway.

3. To remove algae and moss from roofs, brickwork and guttering.

4. To clean garden tools and machinery, furniture and barbecues.

5. To clean hygienic of animal pens and their surrounding area.

With accessories, replacement parts and detergents approved by factory.

Observethe instructions provided with these detergents.

The packing material can be recycled. Please do not place the packaging

into the ordinary refuse for disposal, but arrange for the proper recycling.

Old appliances contain valuable materials that can be recycled. Please

arrange for the proper recycling of old appliances. Please dispose your

old appliances using appropriate collection systems.

Read symbols in the operating instructions

Danger: Immediate danger that can cause severe injury or even death.

Warning: possible hazardous situation that could lead to severe injury or

even death.

Caution: possible hazardous situation that could lead to mild injury to

persons or damage to property.

The high pressure washer may not be directed at persons,

animals, live electrical equipment or at the appliance itself.

Protect the appliance against frost.

1. Coupling for water

connection

11. Lock of high pressure

hose

2. Water

inlet

12. Back

body

3. Front

body

13. Storage of trigger

gun

4. On/O switch

14. Storage of spray

lance

5. Power

cord

6. Water

outlet

7. High pressure

hose

8. Trigger

gun

9. Spray

lance

10. Lock

trigger

gun

www.PyleUSA.comwww.PyleUSA.comwww.PyleUSA.comwww.PyleUSA.comwww.PyleUSA.com www.PyleUSA.com

Especificaciones del producto

Marca:	SereneLife
Categoría:	Limpiador de alta presión
Modelo:	SLPRWAS23
Color del producto:	Roestvrijstaal
Ancho:	770 mm
Profundidad:	400 mm
Altura:	195 mm
Peso del embalaje:	10500 g
Ancho del embalaje:	950 mm
Empaquetadura en profundidad:	520 mm
Altura del embalaje:	250 mm
Manual de usuario:	Ja
Ancho del compartimento de instalación:	820 mm
Profundidad del compartimento de instalación:	450 mm
tipo de fregadero:	Onderbouwspoelbak
Fregadero de forma:	Rechthoekig
Material del fregadero:	Roestvrijstaal
Número de lavabos:	2 kommen
Formar el primer fregadero:	Rechthoekig
Dimensiones del primer recipiente (WxL):	400 x 400 mm
Primero viene la profundidad:	195 mm
Forma el segundo fregadero:	Rechthoekig
Dimensiones del segundo recipiente (WxL):	340 x 400 mm
En segundo lugar viene la profundidad:	195 mm
Kraangat:	Nee
Encimera:	Nee
Grifo incluido:	Nee
Tamaño del fregadero:	3.5 "