Shure RK100PK Manual de Usario

Lee a continuación 📖 el manual en español para Shure RK100PK (1 páginas) en la categoría No categorizado. Esta guía fue útil para 10 personas y fue valorada con 4.5 estrellas en promedio por 2 usuarios

Página 1/1
Model RK100PK and RK100PKW Microex®
Preampler Kit User Guide
INSTALLATION - RK100PK (BLACK), RK100PKW (WHITE)
The RK100PK and RK100PKW preamp comes assembled for
use with microphones using a miniature 4-pin connector. To wire a
microphone cable directly to the preamp, follow these instructions:
Turn screw (A) counter-clockwise until it recedes below
the case.
Remove the cap (C) by removing the set screw (B) with
the provided hex wrench (.05 in.).
FIGURE 1
Push the circuit board out from the case interior to expose
the black and red wires (D).
Unsolder the wires from the circuit board (E).
FIGURE 2
1.
2.
3.
4.
Insert the rubber ex relief (G) into the cap (C) and feed
through the microphone cabling.
Note: You will need to reuse the rubber ex relief from your old
preamp. If the rubber ex relief is unavailable, please contact the
Shure Service Department.
FIGURE 3
Solder the wires directly back onto the circuit board.
Match wires as marked on the circuit board using the fol-
lowing key:
R = RED
B = BLACK
S = (GROUND) SHIELD
R
B
S
R
FIGURE 4
Push the circuit board back into the case, making sure
that the set screw (A) is lined up with the screw hole in
the side of the case (if the circuit board does not go in
all the way, twist it slightly until the screw and hole are
aligned). Raise the set screw (A) by turning clockwise
so that the preamplier is held securely in place. Screw
on the cap (C). Do not use the set screw with the cap.
5.
6.
7.
C
B
A
F
D
E
G
C

Especificaciones del producto

Marca: Shure
Categoría: No categorizado
Modelo: RK100PK

¿Necesitas ayuda?

Si necesitas ayuda con Shure RK100PK haz una pregunta a continuación y otros usuarios te responderán




No categorizado Shure Manuales

No categorizado Manuales

Últimos No categorizado Manuales